REG NASA-LLIS-0309--1994 Lessons Learned High Intensity Discharge Lamps.pdf

《REG NASA-LLIS-0309--1994 Lessons Learned High Intensity Discharge Lamps.pdf》由会员分享，可在线阅读，更多相关《REG NASA-LLIS-0309--1994 Lessons Learned High Intensity Discharge Lamps.pdf（2页珍藏版）》请在麦多课文档分享上搜索。

1、Lessons Learned Entry: 0309Lesson Info:a71 Lesson Number: 0309a71 Lesson Date: 1994-02-04a71 Submitting Organization: KSCa71 Submitted by: David PenningtonSubject: High Intensity Discharge Lamps Description of Driving Event: A metal halide high intensity light bulb in the O&C high bay ceiling inadve

2、rtently exploded. Glass fragments were spewed to the O&C high bay floor, which was clear of personnel and flight hardware at the time of the incident. The subject light fixture was inspected and cleaned of all debris. Metal halide bulbs are very bright and increase the amount of available illuminati

3、on by 50%.The explosion of the metal halide bulb caused concern so the bulbs fragments were collected and sent to NASAs malfunction lab for evaluation. The malfunction lab observed discoloration of some bulb fragments. According to the lab the discoloration suggests that the lamp was reaching the en

4、d of its useful life. It is not known what the manufacturers recommended life for these particular lamps is, but once they reach that particular number of hours, under continued use, they have an increased propensity to explode. In addition, the lab studied the interface area between the lamp bulb a

5、nd the metal housing, no anomalies were noted.Lesson(s) Learned: Metal halide bulbs provide good illumination but require specific mounting hardware for operation.Recommendation(s): To protect personnel and flight hardware, all metal halide bulbs should be covered with a lens assembly capable of wit

6、hstanding the impact produced when one of these bulbs explodes.Evidence of Recurrence Control Effectiveness: Several O&C facility support personnel were interviewed regarding the exploding bulbs. One person Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS

7、-,-,-said protective covers/lenses had been installed to contain the bulb fragments if one were to inadvertently explode. This person said he knew of at least one bulb that had exploded since the installation of the protective covers and said the bulbs fragments were contained with no problem. After

8、 contacting several more O&C facility support personnel, no other evidence of additional bulb explosions was found. The last time burnt out bulbs were replaced approximately 125 bulbs had burned out and not one of them had exploded. Comments: NASA document number SPP 0-01 titled “Shuttle Payload Gro

9、und Operations Contractor Standard Practices and Procedures“, Section D Requirements and Responsibilities: Tool, equipment, and material control (paragraph #43) states: “Glass is forbidden in/on or over flight hardware unless the glass is equipped with a shatterproof protective cover that will conta

10、in all fragments in case of glass breakage. Unprotected light sources are not allowed in/on or over flight hardware.“Documents Related to Lesson: N/AMission Directorate(s): N/AAdditional Key Phrase(s): a71 Energetic Materials - Explosive/Propellant/Pyrotechnica71 FacilitiesAdditional Info: Approval Info: a71 Approval Date: 1994-04-19a71 Approval Name: James G. Klinea71 Approval Organization: KSC/HEIa71 Approval Phone Number: 407-867-7614Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-