NAVY MIL-T-81088 (2)-1966 THREAD POLYAMIDE HIGH TEMPERATURE RESISTANT《耐高温聚酰胺螺纹》.pdf

《NAVY MIL-T-81088 (2)-1966 THREAD POLYAMIDE HIGH TEMPERATURE RESISTANT《耐高温聚酰胺螺纹》.pdf》由会员分享，可在线阅读，更多相关《NAVY MIL-T-81088 (2)-1966 THREAD POLYAMIDE HIGH TEMPERATURE RESISTANT《耐高温聚酰胺螺纹》.pdf（2页珍藏版）》请在麦多课文档分享上搜索。

1、- M I L-T-8 %088-S Amendmen t-2 11 October 1964 Superseding Amendment-1 18 November 1965 MILITARY SPM: IFICATION THREAD, POLYAMIDE, HIGH TEMPERATURE RESISTANT This amendment forms a part of Military Specification MIL-T-81088Wep) of 23 June 1964 and has been approved by the Naval Air Systems Command,

2、 Department of the Navy. By this amendment basic Specification MIL-T-81088(Wep) is changed to read MIL-T-81088(AS). Page 1, paragraph 1.2.1 - Delete entire paragraph and insert the following: 1.2.1 The thread shall be of the following t-ypes and classes i as specified (see 6.2): .: 3 Type I - Unbond

3、ed Type II = Bonded Class 1 - Low elongation Class 2 - Normal elongation Page 3, Table I - Delete entire table and insert the following: Page 6, paragraph 6.2 - Add the following subparagraphs: (e) Thread size (f) Class Provided by IHSNot for ResaleNo reproduction or networking permitted without lic

4、ense from IHS-,-,-MIL-T-BLOBB (2) 3 MIL-T-81088 (AS) Amendment -2 CHARACTERISTICS Thread size Denier (nominal) Yarn ply Length per pound (yards) (min) Type 1 Type II TABLE I Physical Properties Breaking strength (pounds) (min) Elongation (percent) (ma) Class 1 Class 2. Turns per inch/direction (min)

5、 Ply Single CCC-T-191 METHOD NO. visual REQUIREMENTS Ba Eb 200 200 2 3 4010 8200 5600 7375 5000 4100 4100 .4.0 6.0 33 33 40 40 4054, 4050 7.0,Z 6.0,Z Not less Not less than than ply,S ply, 8 UA- GOVERNMENT PRIHTINO OFFICE: lW7-251-516/3436 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-