NAVY MIL-H-85800 (1)-1995 HOSE ASSEMBLIES POLYTETRAFLUOROETHYLENE ARAMID FIBER REINFORCED 5000 AND 8000 PSI GENERAL SPECIFICATION FOR《5000和8000PSI芳纶纤维增强聚四氟乙烯软管装配的一般规格》.pdf

《NAVY MIL-H-85800 (1)-1995 HOSE ASSEMBLIES POLYTETRAFLUOROETHYLENE ARAMID FIBER REINFORCED 5000 AND 8000 PSI GENERAL SPECIFICATION FOR《5000和8000PSI芳纶纤维增强聚四氟乙烯软管装配的一般规格》.pdf》由会员分享，可在线阅读，更多相关《NAVY MIL-H-85800 (1)-1995 HOSE ASSEMBLIES POLYTETRAFLUOROETHYLENE ARAMID FIBER REINFORCED 5000 AND 8000 PSI GENERAL SPECIFICATION FOR《5000和8000PSI芳纶纤维增强聚四氟乙烯软管装配的一般规格》.pdf（1页珍藏版）》请在麦多课文档分享上搜索。

1、MIL-H-85800 (AS) AMENDMENT 1 6 November 1995 MILITARY SPEC1 FICATION HOSE ASSEMBLIES, POLYTETRAFLUOROETHYLENE, ARAMID FIBER REINFORCED, 5000 AND 8000 PSI, GENERAL SPECIFICATION FOR This amendment forms a part of MIL-H-85800(AS), dated i6 January 1987, and is approved for use by the Naval Air Systems

2、 Command, Department of the Navy, I and is available for use by all Departments and Agencies of the Department of Defense. PAGE 1 2.1.1: Under “SPECIFICATIONS, FEDERAL,“ add the following: “P - D - 680 Dry C1 eani ng and Degreasi ng Sol vent. I PAGE 19 4.6.3.10e: Delete and substitute: “e. After the

3、 final two-hour pressurization period, the hose assemblies shall be drained and flushed with solvent conforming to type 1A of P-D-680. I 4.6.3.10f: Delete and substitute: “ f. The hose assemblies shali be air dried and then subjected to a pneumatic effusion test in accordance with 4.6.3.12. To condu

4、ct this test, the hose shall be installed in an apparatus similar to that shown on Figure 4. li Preparing activity: Navy - AS (Project 4720-NO53) AMSC N/A 1 of 1 FSC 4720 DISTRIBUTION STATEMENT A. Approved for pub1 i c re1 ease; distribution is un1 imi ted. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-