ITU-R REPORT F 2059-2005 Antenna characteristics of point-to-point fixed wireless systems to facilitate coordination in high spectrum use areas《利于在高频谱使用区协调的点对点固定无线系统的天线特性》.pdf

《ITU-R REPORT F 2059-2005 Antenna characteristics of point-to-point fixed wireless systems to facilitate coordination in high spectrum use areas《利于在高频谱使用区协调的点对点固定无线系统的天线特性》.pdf》由会员分享，可在线阅读，更多相关《ITU-R REPORT F 2059-2005 Antenna characteristics of point-to-point fixed wireless systems to facilitate coordination in high spectrum use areas《利于在高频谱使用区协调的点对点固定无线系统的天线特性》.pdf（18页珍藏版）》请在麦多课文档分享上搜索。

1、 Rep. ITU-R F.2059 1 REPORT ITU-R F.2059 Antenna characteristics of point-to-point fixed wireless systems to facilitate coordination in high spectrum use areas (2005) Summary This ITU-R Report provides information and results of comparative statistical studies on commercially manufactured point-to-p

2、oint FWS antennas, from the perspectives of interference management and spectrum reuse potential within FS. The use of a Monte Carlo methodology permits the derivation of quantitative estimates of spectrum utilization efficiency for point-to-point FWS antennas with widely varying characteristics. Th

3、rough the statistical correlation of simulation results against individual antenna parameters and based on some simplifying assumptions, useful information is obtained about the role of such parameters in facilitating efficient spectrum use. For example, the antenna front-to-back ratio is shown to b

4、e a potentially useful estimator of spectrum reuse potential for the co-polar case. The results of simulation in the 7.5, 11 and 13 GHz point-to-point FWS bands are reported and analysed, with some preliminary conclusions drawn. 1 Introduction Digital radio-relay systems and other point-to-point fix

5、ed wireless system (FWS) operate in the frequency bands between about 1 to 60 GHz, typically as constant bit-rate (2-155 Mbit/s) transport network elements complementing optic fibre and satellite transport media. The lower frequency (e.g. 4 and 6 GHz) bands have for many years supported long and med

6、ium haul radio-relay systems. More recently, given technology and global market developments, the higher microwave bands have experienced explosive growth, driven by the demand for cellular mobile backhaul and other new carrier networks. WRC decisions in favour of mobile/Global mobile personal commu

7、nication by satellite (GMPCS) allocations has witnessed the displacement of many point-to-point fixed services from the 1-3 GHz bands placing further pressure on the remaining fixed allocations. Nevertheless, point-to-point FWS are a major user of the microwave radio spectrum and demand is expected

8、to continue into the foreseeable future. Spectrum congestion is an ever increasing problem, especially in urban areas, with the potential reuse of microwave RF channels limited by interference related quality of service (QoS) considerations. Point-to-point FWS mainly utilize highly directional, line

9、arly polarized parabolic antennas. Within the fixed service interference environment, antenna radiation performance is a dominant factor in determining the extent of possible frequency reuse or “spectrum efficiency”. Accordingly, many administrations specify antenna performance standards for certifi

10、cation purposes, including “notional” radiation patterns and other criteria such as a minimum antenna size (parabolic reflector diameter). In practice, given the range of manufactured antenna products and the inherent variability of their radiation characteristics, the application of such minimum pe

11、rformance antenna standards is often problematic. For example, in some frequency bands, operators would prefer to deploy smaller and less visually intrusive antennas and tower structures, particularly in support of access networks around urban and environmentally conscious areas, but are constrained

12、 by requirements based directly or indirectly on a minimum antenna reflector size. 2 Rep. ITU-R F.2059 Annex 1 outlines the application of a Monte Carlo approach 1 to deriving estimates of the relative spectrum efficiency of different models of parabolic reflector antennas, with a view to comparing

13、available models and developing an understanding of the preferred antenna radiation characteristics of point-to-point FWS antennas for use in high spectrum use areas. The use of manufacturers digitized FWS antenna data facilitates the computer simulation of a homogeneous FWS interference environment

14、, integrating a multidimensional problem space (antenna gain, co-polar and cross-polar envelope patterns) to a simple point estimate of the number of co-channel services that can theoretically be accommodated within a given area. The simulation is repeated for a sample population of serial productio

15、n 7.5 GHz antennas, with parabolic reflector diameters within the range 0.6 up to 4.6 m. The simulation derived sampling distributions are then analysed using standard statistical methods. The methodology is similarly applied to other frequency bands, in this case the 11 GHz and 13 GHz fixed service

16、 bands and conclusions drawn. Before considering the results of studies, the following sections review issues of interference management, commercial microwave antenna types and their radiation parameters. 1.1 Spectrum utilization efficiency In elementary terms the antenna is a coupling device. Its p

17、rincipal purpose is to facilitate an efficient transfer of energy between a transmission line and the medium of “free” space. Ideally, as much as possible of the power generated at the transmitter should be directed at and arrive at its associated receiver(s). In practice, only a very small fraction

18、 is available at the receiver, with the bulk of the transmitted energy distributed into the environment as noise. This radiated noise power manifests itself as interference, potentially “denying” access to the spectrum by other services, out to a distance where the noise power is sufficiently dimini

19、shed to permit the receiver of another service to operate without unacceptable degradation of its grade of service (GoS). In accordance with Recommendation ITU-R SM.1046 Definition of spectrum use and efficiency of a radio system, such spectrum denial is sometimes expressed as the product of geometr

20、ic space (area/ volume), bandwidth and time. In this case, the time term can be ignored, since we assume constant bit rate FWS, so T = 1: U = B.S MHz . m2 (1) where: U: represents an area bandwidth product, i.e. the spectrum space occupied by a fixed service system and denied to other services B: ra

21、dio-frequency bandwidth of the system S: area of the potentially denied spectrum. Transmitters and receivers already in operation both deny spectrum to other new services existing transmitters potentially interfere with and deny spectrum to the receivers of proposed new systems and existing receiver

22、s are susceptible to interference from and therefore deny spectrum to the transmitters of new systems. For conceptual purposes and for terrestrial fixed services of arbitrary bandwidth1, the area S may be represented as being bounded by a geographic power density contour (Fig. 1), determined by, 1Fo

23、r the purposes of this document we are principally interested in the term “S”, so all wanted and unwanted signals are assumed to be co-channel and the radio-frequency bandwidth term “B” need not be considered. Rep. ITU-R F.2059 3 inter alia2, by the susceptibility of the victim receiving system to i

24、nterfering emissions (i.e. receiver sensitivity and the required grade of service). In principle this is somewhat analogous to the establishment of a coordination area. FIGURE 1 Spectrum denial area “S” The degree of unwanted interference signal coupling is proportional to: the absolute and relative

25、 (Gt(), Gr() azimuth relationships; the antenna discrimination, including co-polar and cross-polar components; the radial distance (d) between the interference source and victim; and additional losses (lm() due to terrain obstruction on the interference path. In practice, for homogeneous fixed servi

26、ces operating within the same frequency band, the standard deviations of parameters such as transmit power, feeder losses and receiver interference threshold are small and for many purposes these parameters are often approximated with constants (See Recommendation ITU-R F.758 Considerations in the d

27、evelopment of criteria for sharing between the terrestrial fixed service and other services.). Potential interference path distance d and relative antenna azimuths are predetermined by the locations dictated by the respective communication and siting requirements of the interfering and potentially i

28、nterfered with services. However, the radiation pattern envelope (G() is unique to each antenna and the standard deviation of the gain patterns between different models of FWS antennas typically extends to orders of magnitude. In conclusion, it is generally accepted that the use of directional anten

29、nas with high off-axis discrimination reduces the overall levels of interference, reduces the area “S”, and increases the potential reuse capacity of the available RF spectrum space. 1.2 Point-to-point FWS antennas For point-to-point FWS using parabolic antennas, it is well known that the directive

30、gain is proportional to aperture, i.e. reflector diameter 2. Figure 2 demonstrates this relationship, using sample data of 141 different 7.5 GHz parabolic antennas. 2In addition to the system gain parameters. 4 Rep. ITU-R F.2059 FIGURE 2 Diameter (m) vs. gain (dBi) FIGURE 3 Gain (dBi) vs. beamwidth

31、(degrees) Similarly, the behaviour of on-axis gain vs. half power beamwidth is relatively well conditioned (Fig. 3), with the statistical variation including some deliberate antenna design tradeoffs. Accordingly, the behaviour of these parameters is easily approximated using established mathematical

32、 models. However, whilst recognizing that the side-lobe patterns of antennas of different sizes are strongly influenced by the ratio of the antenna diameter to the operating wavelength (D/), per Recommendation ITU-R F.699 Reference radiation patterns for fixed wireless system antennas for use in coo

33、rdination studies and interference assessment in the frequency range from 100 MHz to about 70 GHz, for actual production antennas the off-axis co-polar and cross-polar radiation levels of different antenna models are not so predictable. Once outside of the 3 dB beamwidth3, differences often extend t

34、o orders of magnitude, even for models of the same physical aperture (Fig. 4). FIGURE 4 Comparison of co-polar RPEs for a number of STD/HP/UHP 1.8 m dish antennas 3It should be emphasized that the cross-polarization is strongest in the main beam and can also be relatively strong in the side lobes, d

35、epending upon the particular type of antenna used. Rep. ITU-R F.2059 5 For the antenna designer, the challenge is to derive an optimum combination of parabolic reflector and feed. The reflector cannot intercept all of the energy radiated by the feed, as maybe desired for maximum gain. The lost power

36、 can be considered as a spillover loss, given by integrating the power patterns of the feed over the angular region outside of that subtended by the reflector. Other losses account for non-uniform illumination, non constant phase of the aperture field and cross-polarization loss, collectively referr

37、ed to as the aperture efficiency. Commercial model designs are based around obtaining either maximum gain or a reduction in side lobes in exchange for a slight decrease in gain. Increased illumination at the periphery of the reflector surface increases the diffraction field and side-lobe levels. Spe

38、cial techniques, such as RF absorbent “shrouds”, are often employed to suppress the diffraction field and thus reduce the average magnitude of side lobes. The best of these designs represent years of development and exhibit dramatically reduced back and side-lobe levels in comparison to standard mod

39、els. Optimized cross-polar feed systems provide further benefits in terms of additional interference immunity, to the extent that co-channel cross-polar operation on the same RF path is now a routine technique, particularly on long-haul circuits. 1.3 Commercial FWS antenna specifications Manufacture

40、rs catalogues usually list families of electrically similar parabolic FWS antenna models within the range of industry standard apertures. For the purposes of this study, three categories are defined 3, based on the manufacturers nominal model designations (see Table 1), STD standard, HP high perform

41、ance and UHP ultra-high performance, shown in Fig. 3 as green, red and magenta respectively. Frequency band Usually aligned with relevant ITU-R Recommendations detailing radio-frequency (RF) channel arrangements. Model type Manufacturers generic model type typically including (but not limited to) th

42、e following generic descriptors. TABLE 1 Commercial antenna model types Model name Description (see Note) Grid parabolic Grid reflector parabolics, useable range limited to the range 0.4-2.7 GHz. Small to medium capacity systems, inherently good cross-polar performance and low wind loading Standard

43、Unshielded, low cost, solid parabolic antennas. Average side-lobe performance. F/B ratio of the order of 40-55 dB High performance Deep or shrouded dish offering improved side-lobe suppression and F/B ratio of the order of 70 dB Ultra high performance Shrouded antennas with optimal feed arrangements

44、, very high side-lobe suppression and F/B ratios in excess of 80 dB NOTE Dual beam and multiband antennas are not considered in this study. Diameter The diameter of the parabolic reflector (in metres). Commonly manufactured sizes include antennas of 0.3, 0.6, 1.2, 1.8, 2.4 3.0, 3.7 and (in some band

45、s) 4.6 m. Gain The mid-band gain of the antenna (dBi). Additional figures may be given for the top and bottom limits of the operating frequency range. 6 Rep. ITU-R F.2059 Beamwidth Nominal half power beamwidth of the main antenna beam at the dB points at the midland frequency. Cross-polar discrimina

46、tion The ratio of the co-polar main beam signal response to the maximum cross-polar signal response, within the region bounded by twice the 3 dB beamwidth; Front-to-back (F/B) ratio The ratio of the response of the highest peak in the region 180 40 to the main beam response. Production antennas do n

47、ot normally exceed the rated values by more than 2 dB; and Radiation pattern envelope The relative distribution of radiated power as a function of direction (azimuth) in space is the radiation pattern envelope (RPE) of an antenna. The RPE is most commonly referenced as a ratio relative to the main b

48、eam (dB) over the full range of azimuths from 0 to 360, or 0 to 180 for antennas with symmetric patterns. The RPEs of commercially available fixed service antennas represent the envelope peaks of a measured sample of manufactured units. Parallel and cross-polar patterns are measured for both horizon

49、tal and vertical polarizations and typical production units are guaranteed not to have any peaks exceeding the manufacturers published envelopes by more 3 dB. In addition to catalogued specifications, major antenna manufacturers typically provide the above characteristics, including RPEs, in digitized format including a widely used standard electronic format for use in spectrum sharing and coordination studies 4, facilitating detailed coordination and the statistical simulations outlined in this document