HOLDEN HN 2425-2009 ADHESIVE ACRYLIC TWO-PART《胶黏剂 双组分压克力》.pdf

《HOLDEN HN 2425-2009 ADHESIVE ACRYLIC TWO-PART《胶黏剂 双组分压克力》.pdf》由会员分享，可在线阅读，更多相关《HOLDEN HN 2425-2009 ADHESIVE ACRYLIC TWO-PART《胶黏剂 双组分压克力》.pdf（2页珍藏版）》请在麦多课文档分享上搜索。

1、ABN 84 006 893 232 GM Holden Limited Engineering Department MATERIAL SPECIFICATION NUMBER SHEET RELEASE REVISION : : HN 2425 1 of 2 November, 2003 May, 2009 NAME: ADHESIVE, ACRYLIC, TWO-PART THIS DOCUMENT MUST NOT BE REPRODUCED. IF USED IN RELATION TO THE COMPANYS PRODUCTS THE RECIPIENT IS RESPONSIB

2、LE TO CONFIRM THE DOCUMENT ISSUE DATE IS STILL VALID. FORM : S:EngBusProcessEngMaterialsMatlsAndAppearanceNBRspecific0AdminMgmtStandardFormsMatspec.doc 1. SCOPE The material described by this specification is a two-part acrylic adhesive used for bonding unprepared metals or plastics. This adhesive i

3、s quick curing, has good impact and peel strength. REFERENCES HN1000 ASTM D1475 ASTM-D1002 GMW3059 2. REQUIREMENTS Property Test Method Requirement Colour Visual Off-white paste Specific Gravity ASTM-D1475 1.5 max Mix ratio (by volume) Pre-packaged cartridges 10 : 1 Time to Handling Strength 23C - 2

4、 hours Complete Cure 23C - 24 hours Lap Shear Strength to Aluminium23C ASTM D1002 12 MPa min 4. APPROVAL, INSPECTION AND REJECTION Refer HN 1000, Clauses A and C. 5. HAZARDOUS MATERIALS Refer HN 1000, Clause H. ABN 84 006 893 232 GM Holden Limited Engineering Department MATERIAL SPECIFICATION NUMBER

5、 SHEET RELEASE REVISION : : HN 2425 2 of 2 November, 2003 May, 2009 NAME: ADHESIVE, ACRYLIC, TWO-PART THIS DOCUMENT MUST NOT BE REPRODUCED. IF USED IN RELATION TO THE COMPANYS PRODUCTS THE RECIPIENT IS RESPONSIBLE TO CONFIRM THE DOCUMENT ISSUE DATE IS STILL VALID. FORM : S:EngBusProcessEngMaterialsM

6、atlsAndAppearanceNBRspecific0AdminMgmtStandardFormsMatspec.doc 6. RESTRICTED AND REPORTABLE SUBSTANCES (i) All substances and parts must meet the requirements of GMW3059. (ii) All chemical components present in materials supplied to this specification must comply with Australian NICNAS (National Ind

7、ustrial Chemicals Notification and Assessment Scheme) obligations. 7. APPROVED SUPPLIERS AND MATERIALS Material known to meet the full requirements of this specification: APPROVED SUPPLIER APPROVED MATERIAL Lord Australia 403/19 3M Scotch-Weld DP-8005 8. REVISIONS May, 2009 -Revised section “6.RESTRICTED AND REPORTABLE SUBSTANCES” to directly refer to GMW3059 and NICNAS requirements -Section “7. APPROVED SUPPLIERS AND MATERIALS” -Approved material added Prepared by: Y.Zia