FORD FLTM BJ 013-01-2001 TIMKEN CUP GREASE STRING TEST《TIMKEN杯润滑绳试验》.pdf

《FORD FLTM BJ 013-01-2001 TIMKEN CUP GREASE STRING TEST《TIMKEN杯润滑绳试验》.pdf》由会员分享，可在线阅读，更多相关《FORD FLTM BJ 013-01-2001 TIMKEN CUP GREASE STRING TEST《TIMKEN杯润滑绳试验》.pdf（3页珍藏版）》请在麦多课文档分享上搜索。

1、 FORD LABORATORY TEST METHOD BJ 013-01 Date Action Revisions 2001 07 24 Revised Editorial no technical change A. Cockman 1992 05 12 Printed copies are uncontrolled Page 1 of 3 Copyright 2001, Ford Global Technologies, Inc. TIMKEN CUP GREASE STRING TEST Application This procedure is used to determine

2、 the amount of grease string which can be tolerated in assembly practices of areas such as wheel bearings where excessive stringiness will contaminate the brake lining, causing expensive service adjustment. Scope This method consists of removing a Timken bearing cup at a given rate from a grease cup

3、 and measuring the length of string. Apparatus Required The test apparatus shall consist of the following, as shown on attached sketch: 1. Drill Press - “Craftsman“ - Model No. 115-6962, or equivalent. 2. Timken Test Cup No. T-48651 (normally used with Timken lubricant tester) modified as shown in s

4、ketch. 3. Grease cup from Standard Laboratory Grease Working Machine, E.H. Sargent & Co. No. S-67078, or equivalent. 4. Spatula for packing and levelling grease in cup. 5. 6 inch metal scale for measuring length of string from Timken test cup. Conditioning and Test Conditions All test values indicat

5、ed herein are based on material conditioned in a controlled atmosphere of 23 +/- 2 C and 50 +/- 5 % relative humidity for not less than 24 h prior to testing and tested under the same conditions unless otherwise specified. FORD LABORATORY TEST METHOD BJ 013-01 Page 2 of 3 Copyright 2001, Ford Global

6、 Technologies, Inc. Procedure 1. Place modified Timken test cup in drill press chuck and tighten (height is not important). 2. Adjust travel of drill press to 4 inches up and down. 3. Adjust return spring tension to 2 1/2 lb pull with 8/100 s to travel the 4 inches. 4. Fill grease worker cup with gr

7、ease to be tested and place cup on drill press adjustable table and tighten table to obtain .250 setting. (See sketch.) Grease to be tested at 75 +/- 5 F. 5. With the drill press travel in the down position, level the grease with a spatula to completely cover the Timken test cup. Release drill press

8、 hand wheel and measure length of string suspended from the bottom face of the Timken test cup. 6. Repeat test three times and report the average length of string. For wheel bearing grease, strings greater than 1/2 inch are not permissible. Chemicals, materials, parts, and equipment referenced in this document must be used and handled properly. Each party is responsible for determining proper use and handling in its facilities. FORD LABORATORY TEST METHOD BJ 013-01 Page 3 of 3 Copyright 2001, Ford Global Technologies, Inc. TIMKEN CUP GREASE STRING TEST