FORD F-2-2011 ELECTRICAL AND ELECTRONICS SYSTEM ENGINEERING (Version 28).pdf

《FORD F-2-2011 ELECTRICAL AND ELECTRONICS SYSTEM ENGINEERING (Version 28).pdf》由会员分享，可在线阅读，更多相关《FORD F-2-2011 ELECTRICAL AND ELECTRONICS SYSTEM ENGINEERING (Version 28).pdf（24页珍藏版）》请在麦多课文档分享上搜索。

1、 FECDS F-2 Engineering CAD however, the order of the content shall be maintained. Figure F2.1 3.4.1.1 Title block: Title block shall be as per Standard A-1. For composite wire harness drawing, the part number shown in the title block will be part number used for “shown on“ drawing. 3.4.1.2 Revision

2、block: Revision block shall be as per Standard A-2. 3.4.1.3 Electrical standard notes and tables 3.4.1.3.1 CIRCUIT COUNT AND HARNESS WEIGHT NOTES: Total number of circuits shall be shown in the general electrical notes using the Circuit Count note below: WIRE HARNESS CIRCUIT COUNT:_ Harness weight s

3、hall be shown in the General electrical notes HARNESS WEIGHT _ kg 3.4.1.3.1.1 For tabulated wire harness drawings, add a tabulation column for CIRCUIT COUNT. See Figure F-2.3. Original Issue: 19960419 Copyright, Ford Motor Company. Latest Re-issue: 20111231F24 Printed copies are uncontrolled.ENGINEE

4、RING CAD FOR SINGLE GOLD TERMINAL = XX.XX N . Figure F-2.12 NOTE: Mating force shall use the average value with standard deviation with a sample size per USCAR methods. NOTE: If a standard does not apply, retain the note number then follow it with N/A. Original Issue: 19960419 Copyright, Ford Motor

5、Company. Latest Re-issue: 20111231F216 Printed copies are uncontrolled.ENGINEERING CAD temperature, duration, etc. (Through Hole, SMT and Compliant Pin) Land sizes (SMT) Land locations (SMT) Land material (SMT) Land material thicknesses (SMT) 3.5.4 SPECIFIC COMPONENT DRAWING REQUIREMENTS 3.5.4.1 Thi

6、s is the information that shall be contained on a Component/Device Drawing. This information will be used by the Ford Engineer during the harness compatibility review process: Reference to the USCAR interface or Ford connector drawing part number Mating half connector (Harness half) Header pin numbe

7、ring (Mating face) Connector location on component/device Description of connector orientation (Position of latch) The interface/header pin numbering shall match the mating harness half pin numbering. Any deviations to the recommended interface dimensions shall be clearly defined and submitted to th

8、e relevant Ford Core Electrical Distribution Systems (EDS) Component Engineer for approval. 4 SPECIFICATIONS NOTE: The following specifications can be accessed via FordDoc. 4.2 ES6L2T-1274-AA SPECIFICATION. PSF Wire Circuit Description & Color Specification ENGINEERING CAD & DRAFTING STANDARDS Return to TOC Original Issue: 19960419 Copyright, Ford Motor Company. Latest Re-issue: 20111231F224 Printed copies are uncontrolled.4.3 WIRE SPECIFICATIONS https:/ 4.4 STANDARD NOTES, GENERAL NOTES, AND NON-STANDARD NOTES: See ESF65B-14A121-AA Specification. 5 ADDENDUM (RESERVED)