FORD ESF-M6B12-A-2009 INK MARKING - FLUID TYPE TO BE USED WITH FORD WSS-M99P1111-A 《流体型标记墨水 与标准FORD WSS-M99P1111-A一起使用 》.pdf

《FORD ESF-M6B12-A-2009 INK MARKING - FLUID TYPE TO BE USED WITH FORD WSS-M99P1111-A 《流体型标记墨水 与标准FORD WSS-M99P1111-A一起使用 》.pdf》由会员分享，可在线阅读，更多相关《FORD ESF-M6B12-A-2009 INK MARKING - FLUID TYPE TO BE USED WITH FORD WSS-M99P1111-A 《流体型标记墨水 与标准FORD WSS-M99P1111-A一起使用 》.pdf（2页珍藏版）》请在麦多课文档分享上搜索。

1、 ENGINEERING MATERIAL SPECIFICATION Material Name Specification Number Date Action Revisions 2009 06 10 N-STATUS No longer used; No Replacement Named A. Wedepohl, NA 2002 08 26 Revised Updated and renumbered 1987 02 09 888002-512 Released CF4R Printed copies are uncontrolled Page 1 of 2 Copyright 20

2、09, Ford Global Technologies, Inc. INK, MARKING - FLUID TYPE ESF-M6B12-A NOT TO BE USED FOR NEW DESIGN 1. SCOPE The material defined by this specification is a fluid type, quick drying marking ink with good adhesive properties for use in automatic printers. 2. APPLICATION This specification was rele

3、ased originally for material used for marking identification on alternators, heater motors, windshield wiper motors, etc. 3. REQUIREMENTS 3.1 STANDARD REQUIREMENTS FOR PRODUCTION MATERIALS Material suppliers and part producers must conform to the Companys Standard Requirements For Production Materia

4、ls (WSS-M99P1111-A). 3.2 SOLIDS, min 12% (FLTM BI 102-01) 3.3 VEHICLE Percent vehicle by weight not less than 4%. 3.4 COLOR To be specified on Engineering drawing. 3.5 STABILITY There shall be no setting, livering or curdling of the material after being stored for 30 days in a 3/4 filled, sealed con

5、tainer at 23 +/- 2 C. (Some materials will tend to settle in storage, but must be readily re-dispersed.) 3.6 QUALITY The material shall be free from dirt, lumps and skins, shall adhere readily to painted and unpainted surfaces and be miscible with the recommended thinner. ENGINEERING MATERIAL SPECIF

6、ICATION ESF-M6B12-A Page 2 of 2 Copyright 2009, Ford Global Technologies, Inc. 3.7 RESISTANCE PROPERTIES . Must be resistant to grease, water, oil, gasoline and alcohol when thoroughly dry. . Tangerine, Silver, White, Yellow, Black and Red must withstand 175 C for 5 h minimum with only slight darkening. . Blue, Brown, Green, Maroon, Violet and Orange fade at 175 C after 2 h, but must retain legibility of color.