FORD ESB-M4P4-A-2008 ANODIZE ALUMINUM APPLIQUE TO BE USED WITH FORD WSS-M99P1111-A 《经阳极化处理的铝表面上的贴花 与标准FORD WSS-M99P1111-A一起使用 》.pdf

《FORD ESB-M4P4-A-2008 ANODIZE ALUMINUM APPLIQUE TO BE USED WITH FORD WSS-M99P1111-A 《经阳极化处理的铝表面上的贴花 与标准FORD WSS-M99P1111-A一起使用 》.pdf》由会员分享，可在线阅读，更多相关《FORD ESB-M4P4-A-2008 ANODIZE ALUMINUM APPLIQUE TO BE USED WITH FORD WSS-M99P1111-A 《经阳极化处理的铝表面上的贴花 与标准FORD WSS-M99P1111-A一起使用 》.pdf（1页珍藏版）》请在麦多课文档分享上搜索。

1、 ENGINEERING MATERIAL SPECIFICATIONDate Action Revisions 2008 11 06 N-STATUS No Replacement A. Wedepohl, FNA 2003 08 27 Revised Para 3.0 inserted; Para 3.4 deleted 1963 08 07 Released ASI-1020 Printed copies are uncontrolled Copyright 2008, Ford Global Technologies, Inc. Page 1 of 1 ANODIZE, ALUMINU

2、M APPLIQUE ESB-M4P4-A NOT TO BE USED FOR NEW DESIGN 1. SCOPE This specification defines the quality required for an Anodized Aluminum Appliqu. This appliqu has a cement applied to one side for a permanent bond to metallic components. 2. APPLICATION This specification was released originally for inte

3、rior automotive decorative trim panels, such as instrument cluster housings. 3. REQUIREMENTS 3.0 STANDARD REQUIREMENTS FOR PRODUCTION MATERIALS Material suppliers and part producers must conform to the Companys Standard Requirements For Production Materials (WSS-M99P1111-A). 3.1 BOND STRENGTH, min 1

4、0 lb (44.5 N) (ASTM D 903, 180 peel) 3.2 BOND RESISTANCE There shall be no evidence of loosening of the appliqu that has been bonded to its specified component after the following tests: 24 h at -29 C 24 h at 66 C 24 h in salt spray (ASTM B 117) 48 h of 98 +/- 2% relative humidity at 38 +/- 1 C At the end of each test period, check the bond effectiveness. 3.3 ANODIZED SURFACE Shall pass ESB-M4P1.