DOD A-A-53193-1987 HAMMER HAND (OPTICAL)《锤子(眼镜的)》.pdf

《DOD A-A-53193-1987 HAMMER HAND (OPTICAL)《锤子(眼镜的)》.pdf》由会员分享，可在线阅读，更多相关《DOD A-A-53193-1987 HAMMER HAND (OPTICAL)《锤子(眼镜的)》.pdf（3页珍藏版）》请在麦多课文档分享上搜索。

1、A-A-53173 51 m 9777774 004ZG7 3 m A-A-5 319 3 15 September 1987 COMMERCIAL ITEM DESCRIPTION HAMMERr HAND (OPTICAL) The General Services Administration has authorized the use of this commercial item description in pref- erence to Military Specification MIL-H-3663B. This commercial item description co

2、vers a riveting hammer suitable for use in optical shops. Salient characteristics: Shall be a small hammer commonly known as “Swiss Style“ hammer. The head shall be made of cast malleable iron, suitably heat treated. The handle shall be made of smoothed hardwood. Over- all length of handle with head

3、 shall be 8-3/4 inches plus or minus 1/4 inch. One end of the hammer head shall be 1/2 inch diameter with chamfered flat face. The other end shall be chisel shaped. All corners and edges shall be smoothed. Hardness of the head shall be ranged from C50 Rockwell or better. The head shall weigh two oun

4、ces nominal. e The hammer head shall be permanently marked with manufacturers name or logo. Workmanship. The hammer shall be free from defects which detract from its appearance or impair its serviceability. Unit. Each (EA). One hammer, as specified, constitutes one unit . AMSC N/A FSC 5120 DISTRIBUT

5、ION STATEMENT A. Approved for public release; distribution is unlimited. 1 of 3 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-53193 51 m 7997974 0042988 5 m A-A-53 193 Quality Assurance Provisions. the contract or purchase order, the contractor

6、 is responsible for the performance of all inspection requirements as specified herein. purchase order, the contractor may use his own or any facilities suitable for the performance of the inspection requirements specified herein, unless disapproved by the Government. The Government reserves the rig

7、ht to perform any of the inspections set forth in the specification where such inspections are deemed necessary to assure. supplies and services conform to prescribed requ.irements . Regulatory requirements. Responsibility for inspection. Unless otherwise specified in Except as otherwise specified i

8、n the contract or Federal Food, Drug and Cosmetic Act. If the product covered by this document has been determined by the U.S. Food and Drug Administration to be under its jurisdiction, the offeror/ contractor shall comply, and be responsible for compliance by its subcontractors/suppliers, with the

9、requirements of the Federal Food, Drug and Cosmetic Act, as amended, and regulations promulgated thereunder. In addition, the offerorlcontractor shall comply, and be responsible for compliance by its subcontractors/suppliers, with the requirements of all other applicable Federal, State, and local st

10、atutes, ordinances, and regulations. use recovered material in accordance with Public Law 94-580 as amended, and as implemented by Federal Acquisition Regulation Subpart 23.4 to the maximum extent practical. Recovered materials. The offeror/contractor is encouraged to Preservation, packaging, packin

11、g, labeling, and marking. Unless otherwise specified, preservation, packaging, and packing shall be to a degree of protection to preclude damage to containers and/or contents thereof under normal shipping conditions, handling, etc., involving shipment from the supply source to the receiving activity

12、, plus reshipment from receiving activity, and shall conform to applicable carriers rules and regulations. Intermediate and exterior package quantities and labeling and marking shall be as specified in the contract and/or order. Ordering data. (Intermediate/exterior package quantities and labeling a

13、nd marking must be specified in the contract and/or order . 1 2 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,- A-A-53173 51 M 7779774 0042989 7 M A-A-53 193 NOTE: document : The following National Stock Number is covered by this 5120-00-299-8418 MILITARY INTERESTS: Custodianst Army - MD Navy - MS Air Force - 03 Preparing Activity: DOD-MB . Agent : DLA-DM Project No. 5120-CO26 Location: Disk # 9 .- -. I 3 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-