DLA MS28925 REV D-2005 LIGHT SIGNAL HAND HELD 4-1 2 INCH《4-1 2英寸手持信号灯》.pdf

《DLA MS28925 REV D-2005 LIGHT SIGNAL HAND HELD 4-1 2 INCH《4-1 2英寸手持信号灯》.pdf》由会员分享，可在线阅读，更多相关《DLA MS28925 REV D-2005 LIGHT SIGNAL HAND HELD 4-1 2 INCH《4-1 2英寸手持信号灯》.pdf（6页珍藏版）》请在麦多课文档分享上搜索。

1、AMSC N/A 1 of 6 FSC 6220 MS28925D 25 May 2005 Superseding MS28925C 25 April 1977 DETAIL SPECIFICATION SHEET LIGHT, SIGNAL, HAND HELD, 4-1/2 INCH This specification sheet is approved for use by all Departments and Agencies of the Department of Defense. The requirements for acquiring the product descr

2、ibed herein shall consist of this specification sheet and MIL-L-6723. .625.8752.750LAMPRETAINER GASKET, 3 REQD.HOUSINGR 2.1253.250 MAX2.2505.1254.594FILTER6.750.2502.656SWITCH TRIGGER2.234BREAK SHARPEDGE (TYP)HANDLECOARSE KNURL1.562 1.875R .250 .016CLAMP, SAE-AS85049/1, /2, /41 AND /42 10 FEET 1 INC

3、H CORD,UNDERWRITERS STDTYPE STV CORD18 AWG, 2 CONDUCTORNUT, AN3054PLUG, MS3106.750.125.125TOP.812 FINISH: LIGHT, LUSTERLESS BLACK, FED-STD-595, COLOR 37038 Inactive for new design after 4 January 2000. INCH-POUNDProvided by IHSNot for ResaleNo reproduction or networking permitted without license fro

4、m IHS-,-,-MS28925D 2BB4.453A (a) .032SEE DETAIL A4.830VIEW B - B4.875.250.125.032DETAIL AENLARGED(a) DIMENSION A TO BE APPROXIMATELY .375 WHEN IN PLACE IN LIGHT ASSEMBLY AND APPROX .875 WHEN OUT OF ASSEMBLY. ROLL APPROXIMATELY 4.750 O.D. TRIM AND BEND TO CONFORM TO CLOSED DIMENSIONS GIVEN TO ALLOW S

5、UFFICIENT SPRING TENSION TO SATISFACTORILY RETAIN LAMP IN HOUSING. MATERIAL: ALUMINUM OR ALUMINUM ALLOY; STEEL. FINISH: ALUMINUM OR ALUMINUM ALLOY, ANODIZE, MIL-A-8625 OR CHEMICAL FILM CONFORMING TO MIL-C-5541. STEEL. CADMIUM PLATE, AMS-QQ-P-416 OR ZINC PLATE, ASTM B633. RETAINER 1.000 .062.312 .062

6、.312 .062MATERIAL: FELT, RUBBER SUBSTITUTE OR OTHER SUITABLE MATERIAL. COMMERCIAL GRADE. GASKETProvided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MS28925D 330 30BREAK EDGE.016 MAX.407 MAXMETHOD OF FABRICATION OPTIONAL.798 MAX.266 MAX.1004.562.406 MAXMAT

7、ERIAL: LENS: PLASTIC, CLIPS: METAL THE DIMMING FILTER SHALL BE COLOR NON-SELECTIVE AND SHALL HAVE A TRANSMISSION OF .02 +.01. OTHER FILTERS SHALL CONFORM TO MIL-C-7989. THE CLIPS SHALL HOLD THE FILTER IN THE LIGHT AGAINST AN ACCELERATION OF 2 G IN ANY DIRECTION, YET SHALL PERMIT CONVENIENT INSERTION

8、 AND REMOVAL OF FILTER. FILTER 5.562.120.875.1205.500 .120 1.875 .120FIBERHANDLEHINGE(LOCATIONOPTIONAL)MATERIAL AND SHAPE OPTIONALEACH CASE SHALL ACCOMODATE 4 FILTERS MADE TO THIS STANDARD.CASE FINISH: FILTER CLIPS AND METAL FITTINGS OF CASE; ALUMINUM OR ALUMINUM ALLOY, ANODIZE, MIL-A-8625 OR CHEMIC

9、AL FILM CONFORMING TO MIL-C-5541. STEEL; CADMIUM PLATE, AMS-QQ-P-416 OR ZINC PLATE, ASTM B633. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MS28925D 42.774 MAX (TYP)4.750 MAX3.0003030.152(3 HOLES)+.005-.0011.000 MAXCLIPS FOR BEZEL3.5003.125.5001.5

10、00.437.7502.750.100CLIP FOR HANDLEAAHEAD DIAMETEROF RIVET .223/.213.177 HOLEMETHOD OFFABRICATIONOPTIONALBRACKET SECTION A - ATHIS BRACKET SHALL BE SUITABLE FOR HOLDING THE LIGHT IN ANY ORIENTATION AGAINST AN ACCELERATION OF 4 G IN ANY DIRECTION, YET PERMIT CONVENIENT INSERTION AND REMOVAL OF THE LIG

11、HT. THE BRACKET SHALL BE DESIGNED SO THAT NEITHER THE BRACKET, NOR SUITABLE STANDARD ROUND- HEAD SCREWS USED FOR MOUNTING THE BRACKET, SHALL SCRATCH A FILTER INSTALLED IN THE LIGHT. FINISH: ALUMINUM OR ALUMINUM ALLOY; ANODIZE, MIL-A-8625 OR CHEMICAL FILM CONFORMING TO MIL-C-5541. STEEL; CADMIUM PLAT

12、E, AMS-QQ-P-416 OR ZINC PLATE, ASTM B633. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MS28925D 5DASH NO. ITEMS PLUG LAMP WEIGHT LB MAX SUPERSEDES -1 28 VOLT MS25239-4501 AN3089-6 -2 13 VOLT MS3106-16-11P MS25239-4501 AN3089-5 -3 28 VOLT MS25239-4

13、501 AN3089-12 -4 LIGHT 13 VOLT HUBBEL 7542 OR EQUIVALENT MS25239-4501 2.0 AN3089-11 -5 ONE -1 LIGHT, ONE -20 CASE WITH FILTERS AN3089-4 -6 ONE -2 LIGHT, ONE -20 CASE WITH FILTERS AN3089-3 -7 ONE -1 LIGHT, ONE -20 CASE WITH FILTERS, ONE -21 BRACKET AN3089-2 -8 ONE -2 LIGHT, ONE -20 CASE WITH FILTERS,

14、 ONE -21 BRACKET AN3089-1 -9 ONE -3 LIGHT, ONE -20 CASE WITH FILTERS AN3089-10 -10 ONE -4 LIGHT, ONE -20 CASE WITH FILTERS AN3089-9 -11 ONE -3 LIGHT, ONE -20 CASE WITH FILTERS, ONE -21 BRACKET AN3089-8 -12 ONE -4 LIGHT, ONE -20 CASE WITH FILTERS, ONE -21 BRACKET AN3089-7 -13 GASKET .01 -14 RING .1 -

15、15 FILTER, GREEN -16 FILTER, RED -17 FILTER, YELLOW -18 FILTER, DIMMING .2 -19 CASE 1.0 -20 ONE -19 CASE, ONE -15 GREEN FILTER, ONE -16 RED FILTER, ONE -17 YELLOW FILTER, ONE -18 DIMMING FILTER -21 BRACKET .2 REQUIREMENTS 1. Dimensions in inches. 2. Unless otherwise specified, tolerances: Decimals .

16、016; angular 1. Standard commercial tolerances shall apply to all material used in construction of light. 3. In the event of a conflict between the text of this standard and the references cited herein, the text of this standard shall take precedence. 4. Unless otherwise specified, issues of referen

17、ced documents are those in effect at the time of solicitation. 5. Changes from previous issue. Marginal notations are not used in this revision to identify changes with respect to the previous issue due to the extent of the changes. Provided by IHSNot for ResaleNo reproduction or networking permitte

18、d without license from IHS-,-,-MS28925D 6Preparing activity: DLA -IS Custodians: Army CR4 (Project 6220-1161) Navy - AS NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at http:/assist.daps.dla.mil Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-