DLA MIL-DTL-27434 10 B-2009 ADAPTER CONNECTOR COAXIAL RADIOFREQUENCY BETWEEN SERIES SERIES LC SOCKET CONTACT TO SERIES N SOCKET CONTACT FLANGE MOUNT TYPE UG 71A U.pdf

《DLA MIL-DTL-27434 10 B-2009 ADAPTER CONNECTOR COAXIAL RADIOFREQUENCY BETWEEN SERIES SERIES LC SOCKET CONTACT TO SERIES N SOCKET CONTACT FLANGE MOUNT TYPE UG 71A U.pdf》由会员分享，可在线阅读，更多相关《DLA MIL-DTL-27434 10 B-2009 ADAPTER CONNECTOR COAXIAL RADIOFREQUENCY BETWEEN SERIES SERIES LC SOCKET CONTACT TO SERIES N SOCKET CONTACT FLANGE MOUNT TYPE UG 71A U.pdf（2页珍藏版）》请在麦多课文档分享上搜索。

1、MIL-DTL-27434/10B 26 May 2009 SUPERSEDING MIL-DTL-27434/10A 30 October 2008 DETAIL SPECIFICATION SHEET ADAPTER, CONNECTOR, COAXIAL, RADIOFREQUENCY, BETWEEN SERIES, SERIES LC, SOCKET CONTACT, TO SERIES N, SOCKET CONTACT, FLANGE MOUNT, TYPE UG271A/U This specification is approved for use by all Depart

2、ments and Agencies of the Department of Defense The requirements for acquiring the product described herein shall consist of this specification sheet and MIL-DTL-27434. Inches mm Inches mm .005 .196 0.13 4.99 1.187 1.562 30.15 39.67 NOTES: 1. Dimensions are in inches. 2. Metric equivalents are given

3、 for information only. 3. Unless otherwise specified dimensional tolerances are .005 inches. FIGURE 1. Type UG 271 A/U connector adapter. AMSC N/A FSC 5935 INACTIVE FOR NEW DESIGN AFTER 19 FEBRUARY 1982 INCH-POUND Provided by IHSNot for ResaleNo reproduction or networking permitted without license f

4、rom IHS-,-,-MIL-DTL-27434/10B 2 ENGINEERING DATA: Impedance: 50 ohms, nominal. Voltage rating: 1,000 V rms, maximum at sea level. 125 V rms, maximum at 70,000 feet. Temperature rating: -65 C to +165 C. REQUIREMENTS: Dimensions and configuration: As specified on figure 1. Mating characteristics: Seri

5、es LC and series N interface shall be in accordance with MIL-STD-348. Dielectric withstanding voltage: Method 301 of MIL-STD-202, 2,500 V rms minimum at sea level. Corrosion: Applicable. Vibration: Applicable. Shock: Applicable. Part or Identifying Number (PIN): UG-271A/U. Supersession: This documen

6、t supersedes Navy drawing REB49279. Changes from previous issue. The margins of this specification are marked with vertical lines to indicate where changes from the previous issue were made. This was done as a convenience only and the Government assumes no liability whatsoever for any inaccuracies i

7、n these notations. Bidders and contractors are cautioned to evaluate the requirements of this document based on the entire content irrespective of the marginal notations and relationship to the last previous issue. Referenced documents. If addition to MIL-DTL-27434, this document references the foll

8、owing: MIL-STD-202 MIL-STD-348 CONCLUDING MATERIAL Custodians: Preparing activity: Army - CR DLA - CC Navy - EC Air Force - 85 (Project 5935-2009-154) DLA - CC Review activities: Navy - SH Air Force - 99 NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at http:/assist.daps.dla.mil. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-