DLA DSCC-DWG-08009-2008 CABLE RADIO FREQUENCY FLEXIBLE COAXIAL 75 OHMS LOW LOSS LOW SMOKE DIAMETER 405 (DIAMETER 475 ARMORED).pdf

《DLA DSCC-DWG-08009-2008 CABLE RADIO FREQUENCY FLEXIBLE COAXIAL 75 OHMS LOW LOSS LOW SMOKE DIAMETER 405 (DIAMETER 475 ARMORED).pdf》由会员分享，可在线阅读，更多相关《DLA DSCC-DWG-08009-2008 CABLE RADIO FREQUENCY FLEXIBLE COAXIAL 75 OHMS LOW LOSS LOW SMOKE DIAMETER 405 (DIAMETER 475 ARMORED).pdf（6页珍藏版）》请在麦多课文档分享上搜索。

1、REVISIONS LTR DESCRIPTION DATE APPROVED Prepared in accordance with ASME Y14.100 Source Control Drawing REV PAGE REV REV STATUS OF PAGES PAGE 1 2 3 4 5 6 PREPARED BY PMIC N/A Ron Gary DEFENSE SUPPLY CENTER, COLUMBUS COLUMBUS, OHIO 43218-3990 CHECKED BY Ami Chase APPROVED BY Abdonasser Abdouni TITLE

2、CABLE, RADIO FREQUENCY, FLEXIBLE, COAXIAL, 75 OHMS, LOW LOSS, LOW SMOKE, DIAMETER .405, (DIAMETER .475 ARMORED) SIZE CAGE CODE 037Z3 DWG. NO. 08009 Original date of drawing 19 June 2008 A REV PAGE 1 OF 6 AMSC N/A 6145-E090-001 Provided by IHSNot for ResaleNo reproduction or networking permitted with

3、out license from IHS-,-,-SIZE CAGE CODE DWG NO. 037Z3 08009 DEFENSE SUPPLY CENTER, COLUMBUS COLUMBUS, OH 43218-3990 A REVPAGE2 FIGURE 1. General configuration. TABLE I. Description. Components Construction details Diameters Inner conductor Solid bare copper .065 .001 inch (1.65 0.03 mm) Dielectric c

4、ore Cellular polyethylene .285 .005 inch (7.24 0.13 mm) Inner shield .003 inch bonded aluminum tape .291 .005 inch (7.39 0.13 mm) Outer conductor Single braid of 34 AWG, tinned copper wire. Coverage: 91.2 percent, nominal. Carriers: 24 Ends: 8 Picks/inch: 6.3 .320 .005 inch (8.13 0.13 mm) Jacket Typ

5、e XIV, crosslinked polyolefin .405 .007 inch (10.29 0.18 mm) Armor Single braid of aluminum alloy wire. .475 inch (12.07 mm) maximum. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-SIZE CAGE CODE DWG NO. 037Z3 08009 DEFENSE SUPPLY CENTER, COLUMBUS C

6、OLUMBUS, OH 43218-3990 A REVPAGE3 ENGINEERING INFORMATION: Continuous working voltage: 1,680 V rms, maximum. Operating frequency: 2.5 GHz, maximum. Velocity of propagation: 83 percent, nominal. Power rating: See figure 2. Operating temperature range: -30 to +105C. Inner conductor properties: DC resi

7、stance, maximum, at 20C: 0.275 ohms per 100 feet. REQUIREMENTS: Dimensions, configuration and description: See figure 1 and table I. Requirements of DSCC drawing 86045 shall apply. Environmental and mechanical: Visual and mechanical examination: Applicable. Out-of-roundness: Not applicable. Eccentri

8、city: 10 percent, maximum. Adhesion of conductors: Inner conductor to core: 10 pounds, minimum; 50 pounds maximum. Aging stability: +98 2C. Cold bend: -30C 2C. Dimensional stability: +85C 2C. Inner conductor from core: 0.62 inch (mm), maximum. Inner conductor from jacket: .125 inch (mm), maximum. Co

9、ntamination: Not applicable. Flame propagation: Applicable. Acid gas generation: 2.0 percent, maximum. Halogen content: 0.2 percent, maximum. Immersion test: Tensile strength, percent of unaged minimum, 50. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS

10、-,-,-SIZE CAGE CODE DWG NO. 037Z3 08009 DEFENSE SUPPLY CENTER, COLUMBUS COLUMBUS, OH 43218-3990 A REVPAGE4 Elongation, percent of unaged minimum: 50. Smoke index: 25 maximum. Toxicity index: 5 maximum. Durometer hardness (type A) 80 minimum. Weathering: Applicable. Abrasion resistance: 75 cycles min

11、imum (jacket only). Tear strength: 35 pounds per inch. Heat distortion: 30 percent maximum. Physical tests on unaged jacket. Tensile strength: 1,300 psi, minimum. Elongation: 160 percent, minimum. Physical tests on aged jacket: Air oven: Tensile strength, percent minimum: 60. Elongation: percent min

12、imum: 60. Hot oil immersion: Tensile strength, percent minimum: 50. Elongation, percent minimum: 50. Tensile strength and elongation: 1,300psi, 160 percent minimum. Weight: 110 Lbs/1000 ft, maximum. 135 Lbs/1000 ft (armored), maximum. Electrical: Spark test: 3,000 V rms, minimum. Voltage withstandin

13、g: 3,000 V rms, minimum. Corona extinction voltage: 2,250 V rms, minimum. Characteristic impedance: 75 3 ohms. Attenuation: See figure 2. Structural return loss: See figure 3. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-SIZE CAGE CODE DWG NO. 037

14、Z3 08009 DEFENSE SUPPLY CENTER, COLUMBUS COLUMBUS, OH 43218-3990 A REVPAGE5 Capacitance: 18.0 pF per feet, maximum. Capacitance unbalance: Not applicable. Transmission unbalance: Not applicable. Mechanically induced noise: Not applicable. Time delay: Not applicable. Frequency MHz Attenuation dB Powe

15、r Watts 50 150 450 900 1500 2000 2500 1.25 2.05 3.73 5.38 7.03 8.28 9.38 2310 1320 740 520 390 330 300 FIGURE 2. Attenuation and power. Tabulated values are for reference only. The values on the graph represent the requirements for attenuation. The data regarding power rating are for information onl

16、y. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-SIZE CAGE CODE DWG NO. 037Z3 08009 DEFENSE SUPPLY CENTER, COLUMBUS COLUMBUS, OH 43218-3990 A REVPAGE6 FIGURE 3. Structural return loss. Part or Identifying Number (PIN): 08009CF75XX or 08009CF75XX-1

17、(armored). Approved sources of supply are listed herein. Additional sources will be added as they become available. The vendors listed on the requirements drawing have agreed to this drawing and a certificate of compliance has been submitted to DSCC-VAI. DSCC drawing PIN 1/ Vendor CAGE Number Vendor

18、 reference PIN 08009CF75XX 68999 AA-9647 08009CF75XX-1 68999 AA-9651 1/ Parts must be purchased to this DSCC PIN to assure that all performance requirements and tests are met. Vendor CAGE Vendor name and number address 68999 Times Microwave Systems 358 Hall Ave. Wallingford, CT 06492 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-