DLA A-A-59262 B-2012 BATTERY DRY BA-2.pdf
《DLA A-A-59262 B-2012 BATTERY DRY BA-2.pdf》由会员分享,可在线阅读,更多相关《DLA A-A-59262 B-2012 BATTERY DRY BA-2.pdf(5页珍藏版)》请在麦多课文档分享上搜索。
1、Beneficial comments, recommendations, additions, deletions, clarifications, etc., and any data that may improve this document should be sent to: DLA Land and Maritime, ATTN: VAT, P.O. Box 3990, Columbus, OH 43218-3990, or email mailto:CircuitProtectdla.mil. Since contact information can change you m
2、ay want to verify the currency of the address information using the ASSIST Online database at https:/assist.dla.mil/. AMSC N/A FSC 6135 INCH-POUND A-A-59262B 18 October 2012 SUPERSEDING A-A-59262A 21 June 2006 COMMERCIAL ITEM DESCRIPTION BATTERY, DRY, BA-2 The General Services Administration has aut
3、horized the use of this commercial item description for all federal agencies. 1. SCOPE. This commercial item description (CID) covers the general requirements for a +22.5 VDC dry-cell battery. The battery is intended for use in test equipment, radio sets, and other portable electronic and communicat
4、ion equipment powered by non-rechargeable dry cell batteries. Batteries covered by this CID are intended for commercial/industrial applications. 2. CLASSIFICATION/PART OR IDENTIFICATION NUMBER (PIN). This CID uses a classification system which is included in the PIN. The PIN shall be AA59262BA-2 (se
5、e 7.1). 3. SALIENT CHARACTERISTICS. 3.1 Interface and physical dimensions. Batteries supplied to this CID shall be as specified herein and shall meet the requirements of ANSI C18.1M, Part 2, for portable primary cells and batteries with aqueous electrolytes. 3.2 Nominal voltage. The battery shall pr
6、ovide a voltage of +22.5 VDC. 3.3 Weight. The battery weight shall not exceed 1 pound 4 ounces. 3.4 Terminal type. Terminals shall consist of wire leads appropriately insulated to prevent electrical shorting during shipping. 3.5 Cell type. Cells shall meet the requirements of ANSI C18.1M Part 2, bat
7、tery specification 15. 3.6 Dimensions. The battery shall meet the dimensional requirements shown in figure 1. 3.7 Marking. Batteries supplied to this CID shall be marked with the manufacturers (MFRs) standard commercial PIN. (NOTE: The part number marked on the unit pack shall be the CID PIN.) 3.8 R
8、ecycled, recovered, or environmentally preferable materials. Recycled, recovered, or environmentally preferable materials should be used to the maximum extent possible provided that the material meets or exceeds the operational and maintenance requirements, and promotes economically advantageous lif
9、e cycle costs. 3.9 Workmanship. Battery charger/analyzers shall be processed in such a manner as to be uniform in quality and shall be free from other defects that will affect life, serviceability, or appearance. Provided by IHSNot for ResaleNo reproduction or networking permitted without license fr
10、om IHS-,-,-A-A-59262B 2 ltr Inches mm Min Max Min Max A 0.563 0.688 14.30 17.48 B 2.750 2.875 69.85 73.03 C 3.375 3.500 85.73 88.90 D 1.969 2.093 50.01 53.16 E 1.344 1.469 34.14 37.31 F 2.531 2.656 64.29 67.46 NOTES: 1. Dimensions are in inches. FIGURE 1. Configuration and dimensions. Provided by IH
11、SNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-59262B 3 4. REGULATORY REQUIREMENTS. The offeror/contractor is encouraged to use recovered materials to the maximum extent practicable, in accordance with 23.403 of the Federal Acquisition Regulation (FAR). 5. PR
12、ODUCT CONFORMANCE PROVISIONS 5.1 Product conformance. The products provided shall meet the salient characteristics of this CID, conform to the producers own drawings, specifications, standards, and quality assurance practices, and be the same product offered for sale in the commercial market. The Go
13、vernment reserves the right to require proof of such conformance. 6. PACKAGING. Preservation, packing, and marking shall be as specified in the contract or order. 7. NOTES. 7.1 PIN. The PIN should be used for Government purposes to buy commercial products to this CID. See section 2 for PIN format ex
14、ample. 7.2 Environmentally preferable materials. Environmentally preferable materials should be used to the maximum extent possible to meet the requirements of this specification. As of the dating of this document, the U.S. Environmental Protection Agency (EPA) is focusing efforts on reducing 31 pri
- 1.请仔细阅读文档,确保文档完整性,对于不预览、不比对内容而直接下载带来的问题本站不予受理。
- 2.下载的文档,不会出现我们的网址水印。
- 3、该文档所得收入(下载+内容+预览)归上传者、原创作者;如果您是本文档原作者,请点此认领!既往收益都归您。
下载文档到电脑,查找使用更方便
10000 积分 0人已下载
下载 | 加入VIP,交流精品资源 |
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- DLAAA59262B2012BATTERYDRYBA2PDF
