DLA A-A-55564 1 B-2012 RESISTOR VOLTAGE SENSITIVE (VARISTOR) BASE MOUNT.pdf

《DLA A-A-55564 1 B-2012 RESISTOR VOLTAGE SENSITIVE (VARISTOR) BASE MOUNT.pdf》由会员分享，可在线阅读，更多相关《DLA A-A-55564 1 B-2012 RESISTOR VOLTAGE SENSITIVE (VARISTOR) BASE MOUNT.pdf（5页珍藏版）》请在麦多课文档分享上搜索。

1、Comments, suggestions, or questions on this document should be addressed to: DLA Land and Maritime, ATTN: VAT, Post Office Box 3990, Columbus, Ohio 43218-3990 or by email Resistordla.mil. Since contact information can change, you may want to verify the currency of this address information using the

2、ASSIST Online database at https:/assist.dla.mil/. AMSC N/A FSC 5905 INCH-POUND A-A-55564/1B 30 August 2012 SUPERSEDING A-A-55564/1A 15 February 2002 COMMERCIAL ITEM DESCRIPTION RESISTOR, VOLTAGE SENSITIVE (VARISTOR), BASE MOUNT The General Services Administration has authorized the use of this Comme

3、rcial item description (CID) for all agencies. Inactive for new design after 30 March 2008. Parts manufactured prior to the above date may only be used for replacement purposes. Parts manufactured after above date shall not be supplied to this CID. The complete requirements for procuring the transie

4、nt voltage suppression device, base mount described within shall consist of this document and the issue in effect of CID A-A-55564. CLASSIFICATION. This CID uses a classification system which is included in the Part Identification Number (PIN) as shown in the following example (see notes). AA55564 0

5、1 - 001 Abbreviated CID number Applicable CID sheet (two digits) Dash number (see applicable CID sheet) SALIENT CHARACTERISTICS Interface and physical dimensions. The varistors supplied to this CID shall be as specified herein (see figure 1). Power rating. The power rating for the varistor shall be

6、1.0 watt. Voltage rating. The voltage rating shall be as specified in table I. Energy rating. The energy rating shall be as specified in table I. Peak current. The peak current shall be as specified in table I. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from

7、 IHS-,-,-A-A-55564/1B 2 Capacitance. The capacitance shall be as specified in table I. Operating ambient temperature. The operating ambient temperature range shall be -55OC to +85OC. Storage temperature. The storage temperature shall be -55OC to +125OC. Marking. Varistors supplied to this CID shall

8、be marked with the manufacturers standard commercial PIN. Clamping voltage. The clamping voltage shall be as specified in table I. Dimensions Symbol Inches Millimeters Notes Min Max Min Max A 0.57 14.5 B 0.498 0.508 12.5 12.90 C 0.26 6.6 D 2.61 66.3 D11.32 33.5 G 0.248 0.260 6.30 6.60 3 H11.01 25.7

9、4 H21.12 28.4 4 H31.29 32.8 4 J 0.32 8.1 K 1.99 2.01 50.5 51.1 L 0.22 0.24 5.6 6.1 M 0.155 0.165 3.94 4.19 S 0.72 0.78 18.3 19.8 T 0.118 0.122 3.00 3.10 NOTES: 1. Dimensions are in millimeters. 2. Inch equivalents are given for general information only. 3. Tab is designed to fit .25 inch quick conne

10、ct terminal. 4. H1(130-150 V rms devices). H2(250-320 V rms devices). H3(420-660 V rms devices). FIGURE 1. Case dimensions and configuration. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-55564/1B 3 TABLE I. Rating and characteristics. CID dash

11、 number Nominal varistor voltage Max clamping voltage at test current Voltage rating (max) Typical capacitance (picofarads) Energy (max) (Joules) Peak current (V) (V) (I) (rms) (dc) 001 200 +43 -16 360 100 130 175 1900 70 6500 002 200 +20 -16 325 003 240 +44 -28 420 150 200 1600 80 004 240 +3 -28 36

12、0 005 390 +63 -36 675 250 330 1000 130 006 390 +23 -36 620 007 430 +64 -41 740 275 369 900 140 008 430 +23 -41 680 009 510 +55 -48 850 320 420 750 160 010 510 +30 -48 800 011 680 +110 -70 1160 420 560 600 170 012 680 +10 -70 1050 013 750 +110 -80 1280 480 640 550 180 014 750 +40 -80 1160 015 820 +14

13、3 -85 1410 510 675 500 190 016 820 +40 -85 1280 017 910 +140 -105 1560 575 730 450 220 018 910 +50 -105 1410 019 1050 +160 -110 1820 660 850 400 250 020 1050 +50 -110 1650 NOTES. PIN. The PIN should be used for Government purposes to buy commercial products to this CID. See classification informatio

14、n for PIN format example. Commercial and Government Entity (CAGE) code. For ordering purposes, inventory control, and submission of these resistors to DSCC under the Military Parts Control Advisory Group (MPCAG) evaluation program, CAGE code 58536 should be used. Source of documents. Commercial Item

15、 Description A-A-55564 - Resistor, Voltage Sensitive (Varistor). (Copies of these documents are available online at https:/assist.dla.mil/quicksearch/ or from the Standardization Document Order Desk, 700 Robbins Avenue, Building 4D, Philadelphia, PA 19111-5094). Ordering data. Ordering data is as sp

16、ecified in A-A-55564. Commercial products. As part of the market analysis and research effort, this CID was coordinated with the following manufacturers of commercial products. At the time of CID preparation and coordination, these manufacturers were known to have commercial products that would meet

17、 the requirements of this CID. (NOTE: This information should not be considered as a list of approved manufacturers or be used to restrict procurement to only the manufacturers shown). Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-55564/1B 4 TA

18、BLE II. Commercial products. MFRs CAGE MFRs name and address S6019 1/ Sales: Littelfuse, Inc. 8755 West Higgins Road Suite 500 Chicago, IL 60631 Phone: (773) 628.1000 Website: http:/ Plant: Littelfuse, Inc. The Demesne Dundalk, County Louth Republic of Ireland 1/ Parts manufactured prior to 30 March

19、 2008 may only be used for replacement purposes Parts manufactured after 30 March 2008 shall not be supplied to this CID. Part number (P/N) supersession data. These CID P/N supersede the following MFRs P/Ns as shown. This information is being provided to assist in reducing proliferation in the Gover

20、nment inventory system. TABLE III. P/N supersession data. CID dash number AA5556401- MFRs P/N 1/ 2/ CID dash number AA5556401- MFRs P/N 1/ 2/ MFRs CAGE 001 V130PA20A 011 V420PA40A S6019 002 V130PA20C 012 V420PA40C 003 V150PA20A 013 V480PA80A 004 V150PA20C 014 V480PA80C 005 V250PA40A 015 V510PA80A 00

21、6 V250PA40C 016 V510PA80C 007 V275PA40A 017 V575PA80A 008 V275PA40C 018 V575PA80C 009 V320PA40A 019 V660PA100A 1/ The manufacturers P/N shall not be used for procurement to the requirements of this CID. At the time of preparation of this CID, the aforementioned commercial products were reviewed and

22、could be replaced by the CID PIN shown. 2/ Parts manufactured prior to 30 March 2008 may only be used for replacement purposes Parts manufactured after 30 March 2008 shall not be supplied to this CID. National stock number (NSN). Not applicable Government users. To acquire information on obtaining t

23、hese resistors from the Government inventory system, contact DLA Land and Maritime, ATTN: FMX, Post Office Box 3990, Columbus, OH 43216-5000, or telephone (614) 692-3677. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-55564/1B 5 Changes from pre

24、vious issue. The margins of this CID are marked with vertical lines to indicate where changes from the previous issue were made. This was done as a convenience only and the Government assumes no liability whatsoever for any inaccuracies in these notations. Bidders and contractors are cautioned to ev

25、aluate the requirements of this document based on the entire content irrespective of the marginal notations and relationship to the last previous issue. GSA - FAS Custodians: Navy - EC Preparing Activity: DLA - CC DLA - CC Project 5905-2012-050 NOTE: The activities listed above were interested in th

26、is document as the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at https:/assist.dla.mil. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-