DLA A-A-55469 1 C-2009 CONNECTORS ELECTRICAL PLUGS TIP SINGLE (BANANA PLUG).pdf

《DLA A-A-55469 1 C-2009 CONNECTORS ELECTRICAL PLUGS TIP SINGLE (BANANA PLUG).pdf》由会员分享，可在线阅读，更多相关《DLA A-A-55469 1 C-2009 CONNECTORS ELECTRICAL PLUGS TIP SINGLE (BANANA PLUG).pdf（5页珍藏版）》请在麦多课文档分享上搜索。

1、INCH- POUND A-A-55469/1C 6 February 2009 SUPERSEDING A-A-55469/1B 7 April 1995 COMMERCIAL ITEM DESCRIPTION CONNECTORS, ELECTRICAL, PLUGS, TIP, SINGLE (BANANA PLUG) The General Services Administration has authorized the use of this commercial item description for all federal agencies. The complete re

2、quirements for acquiring the connectors described herein shall consist of this document and CID A-A-55469. CLASSIFICATION/PART OR IDENTIFICATION NUMBER (PIN). This commercial item description (CID) specification sheet uses a classification system which is included in the PIN as shown in the followin

3、g example (see NOTES). AA55469 /01 - 01 Dash number (from table I) CID sheet CID number TABLE I. Design and identification data. Dash number AA55469/01- Color Current rating (amperes, maximum) Contact resistance (milliohms, maximum) 01 Black 5 10 02 Red 10 03 Black 15 10 04 Red 15 10 Comments, sugge

4、stions, or questions on this document should be addressed to: Defense Supply Center, Columbus, Attn: VAI, Post Office Box 3990, Columbus, Ohio, 43216-5000 or emailed to ami.chasedla.mil. Since contact information can change, you may want to verify the currency of this address information using the A

5、SSIST Online database at http:/assist.daps.dla.mil. AMSC N/A FSC 5935 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-55469/1C Inches mm .170 4.32 .195 4.95 .228 5.79 .35 8.9 .46 11.7 .56 14.2 1.00 25.4 1.52 38.6 1.65 41.9 NOTES : 1. Dimensions a

6、re in inches. Metric equivalents are given for information only. 2. Tolerance for internal diameter of .228 shall be .020. 3. Unless otherwise specified, tolerances are .010 (0.25 m) for three-place decimals and +.03 (0.8 m) for two-place decimals. 4. When set screw is used, the head shall be below

7、the surface of the insulating material. FIGURE 1. Configuration and dimensions. SALIENT CHARACTERISTICS. CID sheet. The electrical connectors shall be in accordance with the requirements specified herein in addition to the salient characteristics of A-A-55469. Design, construction, and dimensions. D

8、esign, construction, and dimensions shall be as specified on figure 1 and table I. Contact current rating. Contact current rating shall be as specified in table I. Contact resistance. Contact resistance shall be as specified in table I. Dielectric withstanding voltage (at sea level). Dielectric with

9、standing voltage (at sea level) shall be 3.500 V rms at 60 Hz. Operating voltage. Operating voltage is 300 volts rms. 60 hertz at sea level. 5.000 V dc maximum. Certificate of compliance. Each contractor desiring to be listed as a suggested source of supply shall submit a DSCC certificate of complia

10、nce to DSCC. This certificate shall state that the contractors product meets all the requirements of this CID. In addition a certificate of compliance shall accompany all test point connectors supplied to this CID. 2 Provided by IHSNot for ResaleNo reproduction or networking permitted without licens

11、e from IHS-,-,-A-A-55469/1C NOTES. PIN. The PIN should be used for Government purposes to buy commercial products to this CID specification sheet. See the classification section for PIN format example. Source of document. COMMERCIAL ITEM DESCRIPTION A-A-55469 - Connectors. Electrical, Plugs. (Copies

12、 of these documents are available online at http:/assist.daps.dla.mil/quicksearch/ or from the Standardization Document Order Desk, 700 Robbins Avenue, Building 4D, Philadelphia, PA 19111-5094.) Government users. To acquire information on obtaining these test point connectors from the Government inv

13、entory system, contact Defense Supply Center Columbus, ATTN: DSCC-VAI, P.O. Box 3990, Columbus, OH 43218-3990 or emailed to RFConnectordla.mil . Ordering data. Ordering data shall be as specified in A-A-55469. Part number (P/N) supersession data. These CID specification sheet PINs supersede the foll

14、owing MFRs P/Ns as shown (See table II). This information is being provided to assist in reducing proliferation in the Government inventory system. TABLE II. Supersession data. PIN supersession data. 1/ 3/ CID PIN AA55469/01- CAGE Code Vendor Commercial PIN 74970 108-1723-101 01 2/ 91967 211-103 749

15、70 108-1722-101 02 2/ 91967 211-102 74970 108-1723-101 03 91967 211-103 74970 108-1722-101 04 91967 211-102 1/ Mark using standard commercial practice using the commercial PINs. 2/ Inactive. Fifteen ampere item is to be used in lieu of 5 ampere item. Same form, fit, and function. 3/ The manufacturer

16、s P/N shall not be used for procurement to the requirements of this CID specification sheet. At the time of preparation of this CID specification sheet, the aforementioned commercial products were reviewed and could be replaced by the CID PIN shown. For actual part marking requirements, see A-A55469

17、. 3 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-55469/1C National stock number (NSN). The following is a list of NSNs assigned which correspond to this CID specification sheet. The list is for information only and may not be indicative of all

18、 possible NSNs associated with the CID specification sheet. For up to date information on assigned NSNs, please contact the aforementioned DSCC office listed in A-A-55469. TABLE III. NSNs. CID PIN AA55469/01- Applicable NSN 01 Inactive use -03 02 Inactive use -04 03 5935-01-230-0412 04 5935-01-245-9

19、359 Commercial products. As part of the market analysis and research effort, this CID specification sheet was coordinated with the following manufacturers of commercial products. At the time of CID specification sheet preparation and coordination, these manufacturers were known to have commercial pr

20、oducts that would meet the requirements of this CID specification sheet (NOTE: This information should not be considered as a list of approved manufacturers or be used to restrict procurement to only the manufacturers shown.) . MFRs CAGE Number MFRs name and address 74970 Emerson Network Power (EF J

21、ohnson) PO Box 1732 299 Johnson Ave. SW Ste. 100 Waseca, MN 56093 91967 ABBATRON LLC. 632 Arch St. Meadville, PA 16335-2720 Changes from previous issue. The margins of this CID specification sheet are marked with a vertical line to indicate where changes from the previous issue were made. This was d

22、one as a convenience only and the Government assumes no liability whatsoever for any inaccuracies in these notations. Bidders and contractors are cautioned to evaluate the requirements of this document based on the entire content irrespective of the marginal notations and relationship to the last pr

23、evious issue. 4 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-55469/1C 5 MILITARY INTERESTS: CIVIL AGENCY COORDINATING ACTIVITY: Custodians: Preparing activity: Army - CR DLA - CC Navy - EC Air Force 85 (Project 5935-2008-203) DLA - CC Review a

24、ctivities: Army - AR, CR4, MI Navy - AS, CG, MC, OS Air Force 19 NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at http:/assist.daps.dla.mil . Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-