DLA A-A-55117-1993 SKIS MILITARY ALL TERRAIN《所有地形军事指派》.pdf

《DLA A-A-55117-1993 SKIS MILITARY ALL TERRAIN《所有地形军事指派》.pdf》由会员分享，可在线阅读，更多相关《DLA A-A-55117-1993 SKIS MILITARY ALL TERRAIN《所有地形军事指派》.pdf（5页珍藏版）》请在麦多课文档分享上搜索。

1、A-A-55117 9999974 014L943 T90 IINCH POUND A-A-5 5 117 11 JANUARY 1993 COMMERCIAL ITEM DESCRIPTION SKIS, MILITARY, ALL TERRAIN The General Service Administration has authorized the use of this Commercial Item Description in preference to MIL-S-44300. Abstract. The skis are intended for use by Militar

2、y personnel in downhill and cross-country tactical operations for mass movement of troops over snow. Classification. The Skis shall be in the following sizes, as specified: Size 1 - 180 centimeters overall length Size 2 - 190 centimeters overall length Size 3 - 200 centimeters overall length Size 4

3、- 210 centimeters overall length Salient Characteristics. The design and construction of the ski being procured shall be in accordance with the approved standard sample. Each ski shall have a 13/16 inch groove in the heel and the 3/8 inch diameter hole in the tip as shown in figure 1. Beneficial com

4、ments (recommendations, additions, deletions) and any pertinent data which may be of use in improving this document should be addressed to: Defense Personnel Support Center, Clothing and Textiles Directorate, Attn: DPSC-FSSD, 2800 South 20th Street, Philadelphia, PA 19101-8419, by using the self-add

5、ressed Standardization Document Improvement Proposal (DD Form 1426) appearing at the end of this document or by letter. I I AMSC N/A FSC 8465 DISTRIBUTION STATEMENT A. Approved for public release; distribution is unlimited. Provided by IHSNot for ResaleNo reproduction or networking permitted without

6、 license from IHS-,-,-A-A-55117 9999974 0141944 927 A-A-55117 Finish. The color of the ski surface (top) shall approximate lusterless white color No. 37875 of FED-STD-595. Material. the contractor provided the completed item complies with all provisions of the approved samples. The materials shall b

7、e of the quality and type used by Label/markiB. indented or marked with the manufacturers name or trademark of such characters as to be identifiable with the manufacturer. Each ski shall be permanently and legibly Workmanship. After completion, the finished ski shall be thoroughly cleaned, and all r

8、ough edges, burrs and surface shall be smooth, and all foreign matter removed. Color shall approximate lusterless white No. 37875. Any groove in heel or hole in tip of ski is missing or dimensions incorrect, and identification markings missing, illegible, or incomplete will be considered defects. Pr

9、oduct Demonstration Model. When required, offerers shall submit samples of their intended production and style. The Product Demonstration Model will consist of units independently developed. Product Demonstration Models will be analyzed and evaluated by the government. Evaluation criteria and basis

10、for award are contained in the solicitation. Product Demonstration Models will be retained by the government. One (1) Product Demonstration Model approved by DPSC under the resultant contract will serve as a manufacturing standard for the corresponding production items delivered under this contract.

11、 Offerers are advised that the Product Demonstration Model does not relieve the successful offerer of his responsibility to perform in accordance with the Commercial Item Description specified above. Qualitv Assurance Certification. offered meets the salient characteristics and the requirements of t

12、his commercial item description, and where certificates of compliance are submitted, the government reserves the right to require proof of such conformance prior or to the first delivery and thereafter as may be provided for, under provisions of the contract. The contractor shall certify that the pr

13、oduct Examination. Ski lots shall be inspected in accordance with “Sampling Procedures and Tables for Inspection by Attributes“, ANSI/ASQC 21.4, published by the American Society for Quality Control. Visual Examination. The Skis shall be examined for the defects listed below. The lot size shall be e

14、xpressed in units of skis. The sample unit is one pair of skis. The inspection level shall be II and the acceptable quality level (AQL), expressed in terms of defects per hundred units, shall be 2.5. 2 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-

15、O A-A-55117 9999974 0141945 63 D A-A-5 5 11 7 Packaains Examination. shall be examined in accordance with defects listed below. The lot size shall be the number of shipping containers in the inspection lot. expressed in terms of defects per hundred units, shall be 2.5. The fully packaged shipping co

16、ntainers The inspection level shall be S-2 and AQL, Examination Defect Material Any components missing, damaged, not as required. Marking (exterior Omitted, incorrect, illegible, of and interior) improper size, location, sequence or method of application. Workmanship Content Palletization incomplete

17、 closure of container flaps, loose or inadequate strapping. Number of skis per shipping container is more or less than required. Length, width, or height exceeds specified maximum requirements Pallet type not as specified Load not bonded as specified Defects. any groove in heel missing; any hole in

18、toe missing; any holes or groves not as specified; color of surface not as specified; dimensions not as specified; any identification marks missing, illegible or incomplete; rough edges or burrs; dimensions that do not concur with the standard sample. The skis shall be examined for the following def

19、ects: Resulatorv Reauirements. use recovered materials in accordance with Public Law 94-580 to the maximum extent practicable. The offeror/contractor is encouraged to Preservation, Packinq, and Markinq. and marking shall be as specified in the contract or order. The preservation, packing, Source of

20、Government Documents. documents are available from: Copies of Military and Federal Standardization Documents Order Desk Bldg. 4D 700 Robbins Avenue Philadelphia, PA 19111-5094 3 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-55317 9999974 Ol1419

21、4b 7TT M A-A-5 5 117 Sources of Nonaovernment Documents. ANSI/ASQC 21.4 - Sampling Procedures and Tab1 s For Inspection (Applications for copies should be addressed to American By Attributes National Standards Institute, 1430 Broadway, New York, Ny 10018- 3308. ) ASTM-D 3951 - Standard Practice for

22、Commercial Packaging (Applications for copies should be addressed to American Society For Testing and Materials, 1916 Race Street, Philadelphia, PA 19103.) Custodian: Civil Agency Coordinating Air Force - 99 Activity: Navy - NU GSA - FSS Review Activity: Preparing Activity: Air Force - 82 DLA - CT Air Force - 45 Army - GL Navy - MC Project No. 8465-0114 4 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-55lL7 = 9999974 OlUl947 b3b A-A-551 17 5 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-