DIN EN 13538-3-2016 Determination of dimensional characteristics of sleeping bags - Part 3 Volume under load and easiness of packing German version EN 13538-3 2016《睡袋尺寸特性测定 第3部分 有效.pdf

《DIN EN 13538-3-2016 Determination of dimensional characteristics of sleeping bags - Part 3 Volume under load and easiness of packing German version EN 13538-3 2016《睡袋尺寸特性测定 第3部分 有效.pdf》由会员分享，可在线阅读，更多相关《DIN EN 13538-3-2016 Determination of dimensional characteristics of sleeping bags - Part 3 Volume under load and easiness of packing German version EN 13538-3 2016《睡袋尺寸特性测定 第3部分 有效.pdf（8页珍藏版）》请在麦多课文档分享上搜索。

1、September 2016 English price group 7No part of this translation may be reproduced without prior permission ofDIN Deutsches Institut fr Normung e. V., Berlin. Beuth Verlag GmbH, 10772 Berlin, Germany,has the exclusive right of sale for German Standards (DIN-Normen).ICS 97.200.30!%Zy“2555886www.din.de

2、DIN EN 13538-3Determination of dimensional characteristics of sleeping bags Part 3: Volume under load and easiness of packing;English version EN 13538-3:2016,English translation of DIN EN 13538-3:2016-09Bestimmung der Mahaltigkeit von Schlafscken Teil 3: Kompressionsvolumen und Verpackungsfreundlich

3、keit;Englische Fassung EN 13538-3:2016,Englische bersetzung von DIN EN 13538-3:2016-09Dtermination des caractristiques dimensionnelles des sacs de couchage Partie 3: Volume sous charge et facilit dempaquetage;Version anglaise EN 13538-3:2016,Traduction anglaise de DIN EN 13538-3:2016-09SupersedesDIN

4、 EN 13538-3:2002-11www.beuth.deDTranslation by DIN-Sprachendienst.In case of doubt, the German-language original shall be considered authoritative.Document comprises 8 pages 08.16 2 A comma is used as the decimal marker. National foreword This document (EN 13538-3:2016) has been prepared by Technica

5、l Committee CEN/TC 136 “Sports, playground and other recreational facilities and equipment”, Working Committee WG 11 “Sleeping bags” (Secretariat: DIN, Germany). The responsible German body involved in its preparation was DIN-Normenausschuss Sport- und Freizeitgert (DIN Standards Committee Sports Eq

6、uipment), Working Committee NA 112-02-03 AA Schlafscke. Amendments This standard differs from DIN EN 13538-3:2002-11 as follows: a) In Clause 7, “Procedure”, the measuring angle has been specified; b) Formula (1) in Subclause 8.1, “Volume of the sleeping bag under load”, has been amended; c) the sta

7、ndard has been editorially revised. Previous editions DIN 7943-1: 1995-02 DIN 7943-2: 1995-02 DIN EN 13538-3: 2002-11 DIN EN 13538-3:2016-09EUROPEAN STANDARD NORME EUROPENNE EUROPISCHE NORM EN 13538-3 June 2016 ICS 97.200.30 Supersedes EN 13538-3:2002English Version Determination of dimensional char

8、acteristics of sleeping bags - Part 3: Volume under load and easiness of packingDtermination des caractristiques dimensionnelles des sacs de couchage - Partie 3: Volume sous charge et facilit dempaquetage Bestimmung der Mahaltigkeit von Schlafscken - Teil3: Kompressionsvolumen und Verpackungsfreundl

9、ichkeit This European Standard was approved by CEN on 2 May 2016. CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical

10、references concerning such national standards may be obtained on application to the CEN-CENELEC Management Centre or to any CEN member. This European Standard exists in three official versions (English, French, German). A version in any other language made by translation under the responsibility of

11、a CEN member into its own language and notified to the CEN-CENELEC Management Centre has the same status as the official versions. CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia, Finland, Former Yugoslav Republic of Mace

12、donia, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and United Kingdom. EUROPEAN COMMITTEE FOR STANDARDIZATION COMIT EUROPEN DE NORMALISATION EUR

13、OPISCHES KOMITEE FR NORMUNG CEN-CENELEC Management Centre: Avenue Marnix 17, B-1000 Brussels 2016 CEN All rights of exploitation in any form and by any means reserved worldwide for CEN national Members. Ref. No. EN 13538-3:2016 EEN 13538-3:2016 (E) 2 Contents Page European foreword . 3 1 Scope 4 2 N

14、ormative references 4 3 Terms and definitions . 4 4 Principle . 4 4.1 Volume under load . 4 4.2 Easiness of packing . 4 5 Measuring device 4 6 Conditioning of test specimen 4 7 Procedure. 5 8 Test results 5 8.1 Volume of the sleeping bag under load . 5 8.2 Calculation of the easiness of packing . 5

15、9 Test report . 5 Bibliography 6 DIN EN 13538-3:2016-09 EN 13538-3:2016 (E) 3 European foreword This document (EN 13538-3:2016) has been prepared by Technical Committee CEN/TC 136 “Sports, playgrounds and other recreational facilities and equipment”, the secretariat of which is held by DIN. This Eur

16、opean Standard shall be given the status of a national standard, either by publication of an identical text or by endorsement, at the latest by December 2016, and conflicting national standards shall be withdrawn at the latest by December 2016. Attention is drawn to the possibility that some of the

17、elements of this document may be the subject of patent rights. CEN shall not be held responsible for identifying any or all such patent rights. This document supersedes EN 13538-3:2002. NOTE The text is based on an earlier draft prepared by CEN/TC 222 “Feather and down”. EN 13538, Determination of d

18、imensional characteristics of sleeping bags, consists of the following parts: Part 2: Thickness and elastic recovery; Part 3: Volume under load and easiness of packing. According to the CEN-CENELEC Internal Regulations, the national standards organizations of the following countries are bound to imp

19、lement this European Standard: Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia, Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romani

20、a, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and the United Kingdom. DIN EN 13538-3:2016-09 EN 13538-3:2016 (E) 4 1 Scope This European Standard specifies a method of measurement of the volume under load of sleeping bags and a method of calculation of easiness of packing of sleeping bag

21、s filled with feather and/or down. 2 Normative references The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition on the refer

22、enced document (including any amendments) applies. EN ISO 139, Textiles - Standard atmospheres for conditioning and testing (ISO 139) 3 Terms and definitions For the purposes of this document, the following terms and definitions apply. 3.1 volume under load volume occupied by a sleeping bag when com

23、pressed in a specific cylinder under a specific load 3.2 easiness of packing ratio between the volume under load and the volume inside the transport cover 4 Principle 4.1 Volume under load A sleeping bag is positioned inside a tube. A load is then applied to it and the residual volume occupied by th

24、e bag within the tube is measured. 4.2 Easiness of packing Calculation according to 8.2. 5 Measuring device The device consists of: a) a cylinder having an inside diameter of (400 10) mm and a height of 800 mm; b) a cylindrical load having an outside diameter corresponding to that of the cylinder wi

25、th 10 mm to 20 mm of clearance. The mass of the load is (50 1) kg; c) ruler graduated in millimetres; d) stopwatch with a resolution of at least 1 s. 6 Conditioning of test specimen The conditioning shall be done in accordance with EN ISO 139. The sleeping bag shall be conditioned for at least 12 h

26、in ambient conditions of the test at a temperature of (20 2) C and a relative humidity of (65 5) %. DIN EN 13538-3:2016-09 N1)N1) National footnote: In the German version, “volume inside the transport cover” has been literally translated. Howeverthe term Transportvolumen (“transport volume”) is the

27、conventional term.EN 13538-3:2016 (E) 5 7 Procedure The sleeping bag is stuffed unfolded inside the cylinder. Then the cylindrical load (see Clause 5 b) is lowered onto the sleeping bag inside the cylinder. After a period of (300 15) s determine the heights relevant to Formula (1). These measurement

28、s are conducted at three points on the circumference of the cylinder spaced (120 10). The mean value of these three measurements is calculated. 8 Test results 8.1 Volume of the sleeping bag under load The volume of the sleeping bag under load is calculated as follows: =21233,14221 000dhhhV (1) where

29、 V is the volume of the sleeping bag, in litres; h1is the total height of the cylinder, in centimetres; h2is the height remaining between the top of the cylinder and the top of the load, in centimetres; h3is the thickness of the load, in centimetres; d is the diameter of the cylinder, in centimetres

30、. 8.2 Calculation of the easiness of packing Calculate according to the following formula: =243,142VFDL(2) where F is the easiness of packing, index value; V is the volume of the sleeping bag according to 8.1, in litres; D is the diameter of the sleeping bag packed in its transport cover, in centime

31、tres; L is the length of the sleeping bag packed in its transport cover, in centimetres. 9 Test report The test report shall include at least the following information: a) reference to this European Standard, i.e. EN 13538-3:2016; b) date and place of the test; c) identification of the sample; d) re

32、sults rounded to the nearest centimetre; e) any deviation from this standard. DIN EN 13538-3:2016-09 EN 13538-3:2016 (E) 6 Bibliography prEN ISO 23537-1, Requirements for sleeping bags - Part 1: Thermal and dimensional requirements (ISO/DIS 23537-1) prEN ISO 23537-2, Requirements for sleeping bags - Part 2: Fabric and material properties (ISO/DIS 23537-2) EN 13538-2, Determination of dimensional characteristics of sleeping bags - Part 2: Thickness and elastic recovery DIN EN 13538-3:2016-09