BS ISO 21323-2016 Space data and information transfer systems Bundle protocol specification《航天数据和信息传输系统 束协议规范》.pdf

《BS ISO 21323-2016 Space data and information transfer systems Bundle protocol specification《航天数据和信息传输系统 束协议规范》.pdf》由会员分享，可在线阅读，更多相关《BS ISO 21323-2016 Space data and information transfer systems Bundle protocol specification《航天数据和信息传输系统 束协议规范》.pdf（98页珍藏版）》请在麦多课文档分享上搜索。

1、BS ISO 21323:2016Space data and information transfer systems Bundle protocol specificationBSI Standards PublicationWB11885_BSI_StandardCovs_2013_AW.indd 1 15/05/2013 15:06BS ISO 21323:2016 BRITISH STANDARDNational forewordThis British Standard is the UK implementation of ISO 21323:2016.The UK partic

2、ipation in its preparation was entrusted to Technical Committee ACE/68, Space systems and operations.A list of organizations represented on this committee can be obtained on request to its secretary.This publication does not purport to include all the necessary provisions of a contract. Users are re

3、sponsible for its correct application. The British Standards Institution 2016.Published by BSI Standards Limited 2016ISBN 978 0 580 93026 3 ICS 49.140 Compliance with a British Standard cannot confer immunity from legal obligations.This British Standard was published under the authority of the Stand

4、ards Policy and Strategy Committee on 30 November 2016.Amendments/corrigenda issued since publicationDate T e x t a f f e c t e dBS ISO 21323:2016Reference number ISO 21323:2016(E) ISO 2016INTERNATIONAL STANDARDISO 21323Space data and information transfer systems Bundle protocol specificationSystmes

5、 de transfert des donnes et informations spatiales Spcifications du protocole group CCSDS First edition 2016-11-15BS ISO 21323:2016ISO 21323:2016(E) COPYRIGHT PROTECTED DOCUMENT ISO 2016 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherw

6、ise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISOs member body in the country of the requester. ISO copyright office C

7、h. de Blandonnet 8 CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 copyrightiso.org Web www.iso.org Published in Switzerland ii ISO 2016 All rights reservedBS ISO 21323:2016ISO 21323:2016(E) ISO 2016 All rights reserved iiiForeword ISO (the International Orga

8、nization for Standardization) is a worldwide federation of national standards bodies (ISO member bodies). The work of preparing International Standards is normally carried out through ISO technical committees. Each member body interested in a subject for which a technical committee has been establis

9、hed has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization

10、. The procedures used to develop this document and those intended for its further maintenance are described in the ISO/IEC Directives, Part 1. In particular the different approval criteria needed for the different types of ISO documents should be noted. This document was drafted in accordance with t

11、he editorial rules of the ISO/IEC Directives, Part 2. www.iso.org/directives Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. ISO shall not be held responsible for identifying any or all such patent rights. Details of any patent ri

12、ghts identified during the development of the document will be in the Introduction and/or on the ISO list of patent declarations received. www.iso.org/patents Any trade name used in this document is information given for the convenience of users and does not constitute an endorsement. For an explana

13、tion on the meaning of ISO specific terms and expressions related to conformity assessment, as well as information about ISOs adherence to the WTO principles in the Technical Barriers to Trade (TBT) see the following URL: Foreword - Supplementary information ISO 21323 was prepared by the Consultativ

14、e Committee for Space Data Systems (CCSDS) (as CCSDS 734.2-B-1, September 2015) and was adopted (without modifications except those stated in clause 2 of this International Standard) by Technical Committee ISO/TC 20, Aircraft and space vehicles, Subcommittee SC 13, Space data and information transfe

15、r systems. BS ISO 21323:2016CCSDS RECOMMENDED STANDARD FOR CCSDS BUNDLE PROTOCOL SPECIFICATION CCSDS 734.2-B-1 Page ii September 2015 STATEMENT OF INTENT The Consultative Committee for Space Data Systems (CCSDS) is an organization officially established by the management of its members. The Committe

16、e meets periodically to address data systems problems that are common to all participants, and to formulate sound technical solutions to these problems. Inasmuch as participation in the CCSDS is completely voluntary, the results of Committee actions are termed Recommended Standards and are not consi

17、dered binding on any Agency. This Recommended Standard is issued by, and represents the consensus of, the CCSDS members. Endorsement of this Recommendation is entirely voluntary. Endorsement, however, indicates the following understandings: o Whenever a member establishes a CCSDS-related standard, t

18、his standard will be inaccord with the relevant Recommended Standard. Establishing such a standarddoes not preclude other provisions which a member may develop.o Whenever a member establishes a CCSDS-related standard, that member willprovide other CCSDS members with the following information:- The s

19、tandard itself. - The anticipated date of initial operational capability. - The anticipated duration of operational service. o Specific service arrangements shall be made via memoranda of agreement. Neitherthis Recommended Standard nor any ensuing standard is a substitute for amemorandum of agreemen

20、t.No later than five years from its date of issuance, this Recommended Standard will be reviewed by the CCSDS to determine whether it should: (1) remain in effect without change; (2) be changed to reflect the impact of new technologies, new requirements, or newdirections; or (3) be retired or cancel

21、ed.In those instances when a new version of a Recommended Standard is issued, existing CCSDS-related member standards and implementations are not negated or deemed to be non-CCSDS compatible. It is the responsibility of each member to determine when such standards or implementations are to be modifi

22、ed. Each member is, however, strongly encouraged to direct planning for its new standards and implementations towards the later version of the Recommended Standard. ISO 21323:2016(E) ISO 2016 All rights reservedBS ISO 21323:2016CCSDS RECOMMENDED STANDARD FOR CCSDS BUNDLE PROTOCOL SPECIFICATION CCSDS

23、 734.2-B-1 Page iii September 2015 FOREWORD Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. CCSDS has processes for identifying patent issues and for securing from the patent holder agreement that all licensing policies are reason

24、able and non-discriminatory. However, CCSDS does not have a patent law staff, and CCSDS shall not be held responsible for identifying any or all such patent rights. Through the process of normal evolution, it is expected that expansion, deletion, or modification of this document may occur. This Reco

25、mmended Standard is therefore subject to CCSDS document management and change control procedures, which are defined in Organization and Processes for the Consultative Committee for Space Data Systems (CCSDS A02.1-Y-4). Current versions of CCSDS documents are maintained at the CCSDS Web site: http:/w

26、ww.ccsds.org/ Questions relating to the contents or status of this document should be sent to the CCSDS Secretariat at the e-mail address indicated on page i. ISO 21323:2016(E) ISO 2016 All rights reservedBS ISO 21323:2016CCSDS RECOMMENDED STANDARD FOR CCSDS BUNDLE PROTOCOL SPECIFICATION CCSDS 734.2

27、-B-1 Page iv September 2015 At time of publication, the active Member and Observer Agencies of the CCSDS were: Member Agencies Agenzia Spaziale Italiana (ASI)/Italy. Canadian Space Agency (CSA)/Canada. Centre National dEtudes Spatiales (CNES)/France. China National Space Administration (CNSA)/People

28、s Republic of China. Deutsches Zentrum fr Luft- und Raumfahrt (DLR)/Germany. European Space Agency (ESA)/Europe. Federal Space Agency (FSA)/Russian Federation. Instituto Nacional de Pesquisas Espaciais (INPE)/Brazil. Japan Aerospace Exploration Agency (JAXA)/Japan. National Aeronautics and Space Adm

29、inistration (NASA)/USA. UK Space Agency/United Kingdom. Observer Agencies Austrian Space Agency (ASA)/Austria. Belgian Federal Science Policy Office (BFSPO)/Belgium. Central Research Institute of Machine Building (TsNIIMash)/Russian Federation. China Satellite Launch and Tracking Control General, Be

30、ijing Institute of Tracking and Telecommunications Technology (CLTC/BITTT)/China. Chinese Academy of Sciences (CAS)/China. Chinese Academy of Space Technology (CAST)/China. Commonwealth Scientific and Industrial Research Organization (CSIRO)/Australia. Danish National Space Center (DNSC)/Denmark. De

31、partamento de Cincia e Tecnologia Aeroespacial (DCTA)/Brazil. Electronics and Telecommunications Research Institute (ETRI)/Korea. European Organization for the Exploitation of Meteorological Satellites (EUMETSAT)/Europe. European Telecommunications Satellite Organization (EUTELSAT)/Europe. Geo-Infor

32、matics and Space Technology Development Agency (GISTDA)/Thailand. Hellenic National Space Committee (HNSC)/Greece. Indian Space Research Organization (ISRO)/India. Institute of Space Research (IKI)/Russian Federation. KFKI Research Institute for Particle ability to cope with intermittent connectivit

33、y; ability to take advantage of scheduled, predicted, and opportunistic connectivity (in addition to continuous connectivity); notional data accountability with built-in status reporting. 1.2 SCOPE This Recommended Standard is designed to be applicable to any kind of space mission or infrastructure

34、that is communication-resource poor and is subject to long latencies and/or temporary network partitions, regardless of complexity. It is intended that this Recommended Standard become a uniform standard among all CCSDS Agencies. In addition, this specification exists to utilize the underlying servi

35、ce of various internetworking protocols both onboard and in transit between ground and space-based assets. This Recommended Standard is intended to be applied to all systems that claim conformance to the CCSDS Bundle Protocol. It is agnostic to the choice of underlying transmission protocol in that

36、BP can function over AOS, Space Packet, Proximity-1 Space Link Protocol, and various Internet and ground based protocols. The CCSDS believes it is important to document the rationale underlying the recommendations chosen, so that future evaluations of proposed changes or improvements will not lose s

37、ight of previous decisions. The concept and rationale for the use of a bundle protocol in space links may be found in reference H1. 1.3 ORGANIZATION OF THIS RECOMMENDED STANDARD This Recommended Standard is organized as follows: Section 2 contains an overview of the Bundle Protocol and the reference

38、s from which it is derived. Section 3 contains the CCSDS modification to RFC 5050. Section 4 contains the service descriptions. Section 5 contains services BP requires of the system. ISO 21323:2016(E) ISO 2016 All rights reservedBS ISO 21323:2016CCSDS RECOMMENDED STANDARD FOR CCSDS BUNDLE PROTOCOL S

39、PECIFICATION CCSDS 734.2-B-1 Page 1-2 September 2015 Section 6 contains conformance requirements. Annex A contains the Implementation Conformance Statement for the protocol. Annex B contains the Convergence Layer Adapters (CLAs). Annex C contains the Extended Class of Service specification. Annex D

40、contains the Aggregate Custody Signal specification. Annex E contains the Delay Tolerant Payload Conditioning specification. Annex F contains BP managed information. Annex G contains Security, Space Assigned Numbers Authority (SANA), and Patent Considerations. Annex H contains Informative References

41、. Annex I contains abbreviations and acronyms used in this document. 1.4 DEFINITIONS 1.4.1 DEFINITIONS FROM OPEN SYSTEMS INTERCONNECTION (OSI) SERVICE DEFINITION CONVENTIONS This Recommended Standard makes use of a number of terms defined in reference 2. As used in this Recommended Standard those te

42、rms are to be interpreted in a generic sense, i.e., in the sense that those terms are generally applicable to any of a variety of technologies that provide for the exchange of information between real systems. Those terms are: indication; primitive; request; response. 1.4.2 DEFINITIONS FROM OSI BASI

43、C REFERENCE MODEL This Recommended Standard makes use of a number of terms defined in reference 3. As used in this Recommended Standard those terms are to be understood in a generic sense, i.e., in the sense that those terms are generally applicable to any of a variety of technologies that provide f

44、or the exchange of information between real systems. Those terms are: entity; Protocol Data Unit (PDU); service; Service Data Unit (SDU). ISO 21323:2016(E) ISO 2016 All rights reservedBS ISO 21323:2016CCSDS RECOMMENDED STANDARD FOR CCSDS BUNDLE PROTOCOL SPECIFICATION CCSDS 734.2-B-1 Page 1-3 Septemb

45、er 2015 1.4.3 DEFINITIONS FROM RFC 5050 1.4.3.1 Overview This Recommended Standard makes use of a number of terms defined in reference 1. Some of the definitions needed for section 2 of this document are reproduced here for convenience. A graphical representation of a bundle node is given in figure

46、1-1. A bundle node is any entity that can send and/or receive bundles. Each bundle node has three conceptual components described in more detail below: a bundle protocol agent, a set of zero or more convergence layer adapters, and an application agent. The major components are illustrated in figure

47、1-1 and include the addition of storage for enqueued traffic and a Management Information Base (MIB) element. Figure 1-1: Graphical Representation of a Bundle Node It should be noted that there is one application agent per conceptual bundle node. That application may register in multiple endpoints (

48、may provide multiple endpoint identifiers to the bundle protocol agent, requesting delivery of bundles to any of those endpoints). 1.4.3.2 RFC 5050 Terms bundle: A protocol data unit of the DTN Bundle Protocol. NOTE Each bundle comprises a sequence of two or more blocks of protocol data, which serve

49、 various purposes. Multiple instances of the same bundle (the same unit of DTN protocol data) might exist concurrently in different parts of a network, possibly in different representations, in the memory local to one or more bundle nodes, and/or in transit between nodes. In the context of the operation of a bundle node, a bundle is an instance of some bundle in the network that is in that nodes local memory. ISO 21323:20