BS EN ISO 105-X18-2007 Textiles - Tests for colour fastness - Assessment of the potential to phenolic yellowing of materials《纺织材料 色牢度试验 材料苯酚发黄的可能性评估》.pdf

《BS EN ISO 105-X18-2007 Textiles - Tests for colour fastness - Assessment of the potential to phenolic yellowing of materials《纺织材料 色牢度试验 材料苯酚发黄的可能性评估》.pdf》由会员分享，可在线阅读，更多相关《BS EN ISO 105-X18-2007 Textiles - Tests for colour fastness - Assessment of the potential to phenolic yellowing of materials《纺织材料 色牢度试验 材料苯酚发黄的可能性评估》.pdf（14页珍藏版）》请在麦多课文档分享上搜索。

1、 g49g50g3g38g50g51g60g44g49g42g3g58g44g55g43g50g56g55g3g37g54g44g3g51g40g53g48g44g54g54g44g50g49g3g40g59g38g40g51g55g3g36g54g3g51g40g53g48g44g55g55g40g39g3g37g60g3g38g50g51g60g53g44g42g43g55g3g47g36g58phenolic yellowing of materialsThe European Standard EN ISO 105-X18:2007 has the status of a Britis

2、h StandardICS 59.080.01Textiles Tests for colour fastness Part X18: Assessment of the potential to BRITISH STANDARDBS EN ISO 105-X18:2007BS EN ISO 105-X18:2007This British Standard was published under the authority of the Standards Policy and Strategy Committee on 28 September 2007 BSI 2007ISBN 978

3、0 580 56785 8Amendments issued since publicationAmd. No. Date CommentsCompliance with a British Standard cannot confer immunity from legal obligations.National forewordThis British Standard is the UK implementation of EN ISO 105-X18:2007. The UK participation in its preparation was entrusted to Tech

4、nical Committee TCI/81, Colour fastness and colour measurement of textiles.A list of organizations represented on this committee can be obtained on request to its secretary.This publication does not purport to include all the necessary provisions of a contract. Users are responsible for its correct

5、application.EUROPEAN STANDARDNORME EUROPENNEEUROPISCHE NORMEN ISO 105-X18September 2007ICS 59.080.01English VersionTextiles - Tests for colour fastness - Part X18: Assessment ofthe potential to phenolic yellowing of materials (ISO 105-X18:2007)Textiles - Essais de solidit des teintures - Partie X18:

6、valuation de la sensibilit au jaunissement phnolique desmatriaux (ISO 105-X18:2007)Textilien - Farbechtheitsprfungen - Teil X18: Bestimmungder Mglichkeit der Vergilbung durch Phenole (ISO 105-X18:2007)This European Standard was approved by CEN on 27 August 2007.CEN members are bound to comply with t

7、he CEN/CENELEC Internal Regulations which stipulate the conditions for giving this EuropeanStandard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such nationalstandards may be obtained on application to the CEN Management Centre

8、or to any CEN member.This European Standard exists in three official versions (English, French, German). A version in any other language made by translationunder the responsibility of a CEN member into its own language and notified to the CEN Management Centre has the same status as theofficial vers

9、ions.CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland,France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal,Romania, Slovakia, Slovenia, Spai

10、n, Sweden, Switzerland and United Kingdom.EUROPEAN COMMITTEE FOR STANDARDIZATIONCOMIT EUROPEN DE NORMALISATIONEUROPISCHES KOMITEE FR NORMUNGManagement Centre: rue de Stassart, 36 B-1050 Brussels 2007 CEN All rights of exploitation in any form and by any means reservedworldwide for CEN national Membe

11、rs.Ref. No. EN ISO 105-X18:2007: EForeword This document (EN ISO 105-X18:2007) has been prepared by Technical Committee ISO/TC 38 “Textiles“ in collaboration with Technical Committee CEN/TC 248 “Textiles and textile products“, the secretariat of which is held by BSI. This European Standard shall be

12、given the status of a national standard, either by publication of an identical text or by endorsement, at the latest by March 2008, and conflicting national standards shall be withdrawn at the latest by March 2008. According to the CEN/CENELEC Internal Regulations, the national standards organizatio

13、ns of the following countries are bound to implement this European Standard: Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania,

14、 Slovakia, Slovenia, Spain, Sweden, Switzerland and the United Kingdom. Endorsement notice The text of ISO 105-X18:2007 has been approved by CEN as a EN ISO 105-X18:2007 without any modification. EN ISO 105-X18:2007Reference numberISO 105-X18:2007(E)INTERNATIONAL STANDARD ISO105-X18First edition2007

15、-09-01Textiles Tests for colour fastness Part X18: Assessment of the potential to phenolic yellowing of materials Textiles Essais de solidit des teintures Partie X18: valuation de la sensibilit au jaunissement phnolique des matriaux EN ISO 105-X18:2007ii iiiForeword ISO (the International Organizati

16、on for Standardization) is a worldwide federation of national standards bodies (ISO member bodies). The work of preparing International Standards is normally carried out through ISO technical committees. Each member body interested in a subject for which a technical committee has been established ha

17、s the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. Inte

18、rnational Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publica

19、tion as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. ISO shall not be held responsible for identifying any or all such patent rig

20、hts. ISO 105-X18 was prepared by Technical Committee ISO/TC 38, Textiles, Subcommittee SC 1, Tests for coloured textiles and colorants. ISO 105-X18 is part of a series of standards which were originally published as 13 “parts”, under the general title Textiles Tests for colour fastness, each part be

21、ing designated by a letter (for example “Part A”), the publication dates being between 1978 and 1985. Each part included a series of “sections”, each designated by the letter corresponding to the part and by a series number with two figures (for example, “Section A01”). A complete list of these part

22、s is given in ISO 105-A01. EN ISO 105-X18:2007blank1Textiles Tests for colour fastness Part X18: Assessment of the potential to phenolic yellowing of materials 1 Scope This part of ISO 105 specifies a method intended for assessment of the potential to phenolic yellowing of textile materials. The met

23、hod is specific to phenolic yellowing and does not cover the many other possible causes of yellow discolouration found on textile materials. NOTE Use of the method does not guarantee that the materials tested will not exhibit yellowing in some form. It is intended as a screening test which, in pract

24、ice, has been found to significantly reduce the number of complaints of phenolic yellowing by enabling corrective action to be taken with materials which, after testing, exhibit yellowing. 2 Normative references The following referenced documents are indispensable for the application of this documen

25、t. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. ISO 105-A01, Textiles Tests for colour fastness Part A01: General principles of testing ISO 105-A03, Textiles Tests for colour fastness P

26、art A03: Grey scale for assessing staining ISO 105-A04, Textiles Tests for colour fastness Part A04: Method for the instrumental assessment of the degree of staining of adjacent fabrics 3 Terms and definitions For the purposes of this document, the following terms and definitions apply. 3.1 phenolic

27、 yellowing discolouration of textile materials caused by the action of oxides of nitrogen and phenolic compounds, which lead to the production of a yellow colour 3.2 potential to phenolic yellowing possibility or capability of phenolic yellowing EN ISO 105-X18:20072 4 Principle A test package is pre

28、pared, consisting of test papers, test specimens and one control fabric. Each specimen and the control fabric are individually placed between a folded test paper placed between two glass plates in a horizontal formation. The stack of plates, test papers, specimens and control fabric is then wrapped

29、firmly in BHT (butyl hydroxytoluene) free polyethylene film to create an airtight package. The package is loaded in a test device, which is placed in an incubator/oven, for a specified time at a specific temperature. On removal of the package from the incubator/oven and test device, it is allowed to

30、 cool. The package is opened, and the control fabric and specimens are assessed immediately by comparison with the grey scale for assessing staining. 5 Test specimens 5.1 Select the specimens to represent the sample, or as agreed between the interested parties. 5.2 If yarn or fibre is to be tested,

31、then take a mass of the yarn or loose fibre that is sufficient to form by hand a mat of material approximately 100 mm 30 mm. 6 Apparatus 6.1 Glass plates, each (100 1) mm (40 1) mm (3 0,5) mm. Clean the glass plates thoroughly between each test, using a cleaner that does not leave a residue (e.g. al

32、cohol). 6.2 Incubator or oven, to maintain (50 3) C. 6.3 Test device, consisting of a stainless-steel frame into which a weight of mass (5 0,1) kg and base of minimum (60 115) mm is closely fitted. The test device shall be constructed so that, if the weight is removed during the test, the pressure a

33、pplied to the specimens remains unchanged. 7 Materials 7.1 Test papers1), (100 2) mm (75 2) mm, density (88 7) g/m2at 20 C, of 98 % pure cellulose treated with 0,1 % 2,6-di-tert-butyl-4-nitrophenol to give a Grey Scale for Staining Grade 3 or worse (i.e. 2/3, 2, etc.) on the control fabric. Use new

34、test papers for each test. Store the test papers in resealable aluminium foil packaging in a cool dry environment or conditioned laboratory. Use within 6 months of opening. NOTE It is advisable to wear protective gloves when handling. 1) Test papers and control fabrics may be purchased from the foll

35、owing sources: James H Heal b) identification of the test sample and sampling procedure, if required; c) the numerical grey scale rating for staining to express the potential of phenolic yellowness of materials. EN ISO 105-X18:2007blankBS EN ISO BSI389 Chiswick High RoadLondonW4 4AL105-X18:2007BSI B

36、ritish Standards InstitutionBSI is the independent national body responsible for preparing British Standards. It presents the UK view on standards in Europe and at the international level. It is incorporated by Royal Charter.RevisionsBritish Standards are updated by amendment or revision. Users of B

37、ritish Standards should make sure that they possess the latest amendments or editions.It is the constant aim of BSI to improve the quality of our products and services. We would be grateful if anyone finding an inaccuracy or ambiguity while using this British Standard would inform the Secretary of t

38、he technical committee responsible, the identity of which can be found on the inside front cover. Tel: +44 (0)20 8996 9000. Fax: +44 (0)20 8996 7400.BSI offers members an individual updating service called PLUS which ensures that subscribers automatically receive the latest editions of standards.Buy

39、ing standardsOrders for all BSI, international and foreign standards publications should be addressed to Customer Services. Tel: +44 (0)20 8996 9001. Fax: +44 (0)20 8996 7001. Email: ordersbsi-. Standards are also available from the BSI website at http:/www.bsi-.In response to orders for internation

40、al standards, it is BSI policy to supply the BSI implementation of those that have been published as British Standards, unless otherwise requested.Information on standardsBSI provides a wide range of information on national, European and international standards through its Library and its Technical

41、Help to Exporters Service. Various BSI electronic information services are also available which give details on all its products and services. Contact the Information Centre. Tel: +44 (0)20 8996 7111. Fax: +44 (0)20 8996 7048. Email: infobsi-.Subscribing members of BSI are kept up to date with stand

42、ards developments and receive substantial discounts on the purchase price of standards. For details of these and other benefits contact Membership Administration. Tel: +44 (0)20 8996 7002. Fax: +44 (0)20 8996 7001. Email: membershipbsi-.Information regarding online access to British Standards via Br

43、itish Standards Online can be found at http:/www.bsi- information about BSI is available on the BSI website at http:/www.bsi-.CopyrightCopyright subsists in all BSI publications. BSI also holds the copyright, in the UK, of the publications of the international standardization bodies. Except as permi

44、tted under the Copyright, Designs and Patents Act 1988 no extract may be reproduced, stored in a retrieval system or transmitted in any form or by any means electronic, photocopying, recording or otherwise without prior written permission from BSI.This does not preclude the free use, in the course o

45、f implementing the standard, of necessary details such as symbols, and size, type or grade designations. If these details are to be used for any other purpose than implementation then the prior written permission of BSI must be obtained.Details and advice can be obtained from the Copyright & Licensing Manager. Tel: +44 (0)20 8996 7070. Fax: +44 (0)20 8996 7553. Email: copyrightbsi-.