BS EN ISO 105-S02-1996 Textiles Tests for colour fastness Colour fastness to vulcanization Sulfur monochloride《纺织品 色牢度试验 第S02部分 耐硫化的色牢度 一氯化硫试验》.pdf

《BS EN ISO 105-S02-1996 Textiles Tests for colour fastness Colour fastness to vulcanization Sulfur monochloride《纺织品 色牢度试验 第S02部分 耐硫化的色牢度 一氯化硫试验》.pdf》由会员分享，可在线阅读，更多相关《BS EN ISO 105-S02-1996 Textiles Tests for colour fastness Colour fastness to vulcanization Sulfur monochloride《纺织品 色牢度试验 第S02部分 耐硫化的色牢度 一氯化硫试验》.pdf（12页珍藏版）》请在麦多课文档分享上搜索。

1、BRITISH STANDARD BS EN ISO 105-S02:1996 Textiles Tests for colour fastness Part S02: Colour fastness to vulcanization: Sulfur monochloride The European Standard EN ISO 105-S02:1995 has the status of a British Standard ICS 59.080.10BSENISO 105-S02:1996 This British Standard, having been prepared unde

2、r the directionof the Sector Board for Materials and Chemicals, was published under the authority of the Standards Board and comes into effect on 15February1996 BSI 12-1999 The following BSI references relate to the work on this standard: Committee reference TCI/25 Draft announced in BSINews Februar

3、y1995 ISBN 0 580 23977 2 Committees responsible for this British Standard The preparation of this British Standard was entrusted to Technical Committee TCI/25, Chemical properties, upon which the following bodies were represented: Association of Consulting Scientists Association of Suppliers to the

4、British Clothing Industry British Apparel and Textile Confederation British Clothing Industry Association British Measurement and Testing Association British Retail Consortium Chemical Industries Association Consumer Policy Committee of BSI Fabric Care Research Association Ltd. Home Laundering Consu

5、ltative Council International Wool Secretariat Mail Order Traders Association Ministry of Defence National Wool Textile Export Corporation SATRA Footwear Technology Centre Soap and Detergent Industry Association Society of Dyers and Colourists Textile Finishers Association Participation in the detai

6、led technical work was undertaken by the Society of Dyers and Colourists Amendments issued since publication Amd. No. Date CommentsBSENISO105-S02:1996 BSI 12-1999 i Contents Page Committees responsible Inside front cover National foreword ii Foreword 2 1 Scope 3 2 Normative references 3 3 Principle

7、3 4 Apparatus and reagents 3 5 Test specimen 3 6 Procedure 4 7 Test report 4 Annex ZA (normative) Normative references to international publications with their relevant European publications 5 Figure 1 Exposure chamber for vulcanizing with sulfur monochloride 4 List of references Inside back coverBS

8、ENISO 105-S02:1996 ii BSI 12-1999 National foreword This British Standard has been prepared by Technical Committee TCI/25 and is the English language version of EN ISO105-S02:1995 Textiles Tests for colour fastness Part S02 Colour fastness to vulcanization: Sulfur monochloride, published by the Euro

9、pean Committee for Standardization (CEN). It was derived by CEN from ISO105-S02:1993, published by the International Organization for Standardization (ISO). This British Standard supersedes the corresponding method in BS1006:1990, which is withdrawn by amendment. A British Standard does not purport

10、to include all the necessary provisions of a contract. Users of British Standards are responsible for their correct application. Compliance with a British Standard does not of itself confer immunity from legal obligations. Cross-references Publication referred to Corresponding British Standard ISO 1

11、05-A01:1989 BS EN ISO 105 Textiles Tests for colour fastness Part A01:1996 General principles of testing ISO 105-A02:1993 BS EN 20105 Textiles Tests for colour fastness Part A02:1995 Grey scale for assessing change in colour ISO 105-F:1985 BS 1006:1990 Methods of test for colour fastness of textiles

12、 and leather Summary of pages This document comprises a front cover, an inside front cover, pages i and ii, theEN ISO title page, pages 2 to 6, an inside back cover and a back cover. This standard has been updated (see copyright date) and may have had amendments incorporated. This will be indicated

13、in the amendment table on the inside front cover.EUROPEAN STANDARD NORME EUROPENNE EUROPISCHE NORM EN ISO 105-S02 November 1995 ICS 59.080.10 Descriptors: Textiles, dyes, tests, vulcanizing tests, determination, colour fastness English version Textiles Tests for colour fastness Part S02: Colour fast

14、ness to vulcanization: Sulfur monochloride (ISO 105-S02:1993) Textiles Essais de solidit des teintures PartieS02: Solidit la vulcanisation: Monochlorure de soufre (ISO 105-S02:1993) Textilien Farbechtheitsprfungen TeilS02: Farbechtheit gegen Vulkanisieren: Dischwefel-Dichlorid (ISO 105-S02:1993) Thi

15、s European Standard was approved by CEN on1995-07-28. CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references c

16、oncerning such national standards may be obtained on application to the Central Secretariat or to any CEN member. This European Standard exists in three official versions (English, French, German). A version in any other language made by translation under the responsibility of a CEN member into its

17、own language and notified to the Central Secretariat has the same status as the official versions. CEN members are the national standards bodies of Austria, Belgium, Denmark, Finland, France, Germany, Greece, Iceland, Ireland, Italy, Luxembourg, Netherlands, Norway, Portugal, Spain, Sweden, Switzerl

18、and and United Kingdom. CEN European Committee for Standardization Comit Europen de Normalisation Europisches Komitee fr Normung Central Secretariat: rue de Stassart 36, B-1050 Brussels 1995 All rights of reproduction and communication in any form and by any means reserved in all countries to CEN an

19、d its members Ref. No. EN ISO 105-S02:1995 EENISO 105-S02:1995 BSI 12-1999 2 Foreword The text of the International Standard from ISO/TC38, Textiles, of the International Organization for Standardization (ISO) has been taken over as a European Standard by the Technical Committee CEN/TC248, Textiles

20、and textile products. This European Standard shall be given the status of a national standard, either by publication of an identical text or by endorsement, at the latest by May1996, and conflicting national standards shall be withdrawn at the latest by May1996. According to CEN/CENELEC Internal Reg

21、ulations, the following countries are bound to implement this European Standard: Austria, Belgium, Denmark, Finland, France, Germany, Greece, Iceland, Ireland, Italy, Luxembourg, Netherlands, Norway, Portugal, Spain, Sweden, Switzerland and the United Kingdom. NOTENormative references to Internation

22、al Standards are listed in Annex ZA (normative).ENISO105-S02:1995 BSI 12-1999 3 1 Scope This part of ISO105specifies a method for determining the resistance of the colour of textiles of all kinds and in all forms to the action of sulfur monochloride under the conditions usually occurring during the

23、cold vulcanizing of rubber. 2 Normative references The following standards contain provisions which, through reference in this text, constitute provisions of this part of ISO105. At the time of publication, the editions indicated were valid. All standards are subject to revision, and parties to agre

24、ements based on this part of ISO105 are encouraged to investigate the possibility of applying the most recent editions of the standards indicated below. Members of IEC and ISO maintain registers of currently valid International Standards. ISO 105-A01:1989, Textiles Tests for colour fastness Part A01

25、: General principles of testing. ISO 105-A02:1993, Textiles Tests for colour fastness Part A02: Grey scale for assessing change in colour. ISO 105-F:1985, Textiles Tests for colour fastness Part F: Standard adjacent fabrics. 3 Principle A specimen of the textile is exposed to sulfur monochloride vap

26、our. The change in colour of the specimen is assessed with the grey scale before and after neutralizing with ammonium hydroxide. 4 Apparatus and reagents 4.1 Heated exposure chamber, in which the specimens are hung. Dry air can be aspirated through the apparatus and provision is made for putting a b

27、eaker containing sulfur monochloride, or ammonium hydroxide, inside the chamber (seeFigure 1). 4.2 Sulfur monochloride (S 2 Cl 2 ) NOTE 1The sulfur monochloride should not be darker than yellow, as a brown coloration indicates decomposition. 4.3 Ammonium hydroxide solution, containing300g of NH 3per

28、 litre (relative density0,88). 4.4 Grey scale for assessing change in colour, complying with ISO105-A02. 5 Test specimen 5.1 If the textile to be tested is fabric, use a specimen measuring40mm 100mm. 5.2 If the textile to be tested is yarn, knit it into a fabric and use a specimen measuring40mm 100m

29、m or wind it round a piece of thin inert material measuring40mm 100mm to obtain the specified area of the textile for test. 5.3 If the textile to be tested is loose fibre, comb and compress enough of it to form a sheet measuring40mm 100mm and sew it on to a cotton adjacent fabric complying with ISO1

30、05-F, section F02, to support the fibres.ENISO 105-S02:1995 4 BSI 12-1999 6 Procedure 6.1 Suspend the specimen in the exposure chamber(4.1). Heat the air in the chamber to50 C 4 C and aspirate dry air through the chamber for15min. Close the tap leading from the drying tower and disconnect the lead t

31、o the vacuum line. 6.2 Place a beaker containing0,01g of sulfur monochloride (4.2) for each litre of exposure chamber capacity inside the chamber and maintain the temperature at50 C 2 C for1h. 6.3 Switch off the heater and aspirate dry air through the chamber for2h. 6.4 Remove the specimen and cut i

32、t in half across the width; put one half back in the exposure chamber. Place inside the chamber a beaker containing0,05g of ammonium hydroxide solution(4.3) for each litre of exposure chamber capacity. Leave at room temperature for1h. 6.5 Assess the change in colour of the specimen with the grey sca

33、le (4.4) immediately before and after neutralizing with ammonium hydroxide. 7 Test report The test report shall include the following particulars: a) the number and date of publication of this part of ISO105, i.e. ISO105-S02:1993; b) all details necessary for the identification of the sample tested;

34、 c) the numerical rating for change of colour of the test specimen before and after neutralizing with ammonium hydroxide. Figure 1 Exposure chamber for vulcanizing with sulfur monochlorideENISO105-S02:1995 BSI 12-1999 5 Annex ZA (normative) Normative references to international publications with the

35、ir relevant European publications This European Standard incorporates by dated or undated reference, provisions from other publications. These normative references are cited at the appropriate places in the text and the publications are listed hereafter. For dated references, subsequent amendments t

36、o or revisions of any of these publications apply to this European Standard only when incorporated in it by amendment or revision. For undated references the latest edition of the publication referred to applies. Publication Year Title EN Year ISO 105-A01 1994 Textiles Tests for colour fastness Part

37、A01:General principles of testing EN ISO 105-A01 1994 ISO 105-A02 1993 Textiles Tests for colour fastness Part A02: Grey scale for assessing change in colour EN 20105-A02 1994 ISO 139 1973 Textiles Standard atmospheres for conditioning and testing EN 20139 19926 blankBSENISO 105-S02:1996 BSI 12-1999

38、 List of references See national foreword.BS EN ISO 105-S02:1996 BSI 389 Chiswick High Road London W4 4AL BSIBritishStandardsInstitution BSI is the independent national body responsible for preparing BritishStandards. It presents the UK view on standards in Europe and at the international level. It

39、is incorporated by Royal Charter. Revisions BritishStandards are updated by amendment or revision. Users of BritishStandards should make sure that they possess the latest amendments or editions. It is the constant aim of BSI to improve the quality of our products and services. We would be grateful i

40、f anyone finding an inaccuracy or ambiguity while using this BritishStandard would inform the Secretary of the technical committee responsible, the identity of which can be found on the inside front cover. Tel:02089969000. Fax:02089967400. BSI offers members an individual updating service called PLU

41、S which ensures that subscribers automatically receive the latest editions of standards. Buying standards Orders for all BSI, international and foreign standards publications should be addressed to Customer Services. Tel:02089969001. Fax:02089967001. In response to orders for international standards

42、, it is BSI policy to supply the BSI implementation of those that have been published as BritishStandards, unless otherwise requested. Information on standards BSI provides a wide range of information on national, European and international standards through its Library and its Technical Help to Exp

43、orters Service. Various BSI electronic information services are also available which give details on all its products and services. Contact the Information Centre. Tel:02089967111. Fax:02089967048. Subscribing members of BSI are kept up to date with standards developments and receive substantial dis

44、counts on the purchase price of standards. For details of these and other benefits contact Membership Administration. Tel:02089967002. Fax:02089967001. Copyright Copyright subsists in all BSI publications. BSI also holds the copyright, in the UK, of the publications of the international standardizat

45、ion bodies. Except as permitted under the Copyright, Designs and Patents Act 1988 no extract may be reproduced, stored in a retrieval system or transmitted in any form or by any means electronic, photocopying, recording or otherwise without prior written permission from BSI. This does not preclude t

46、he free use, in the course of implementing the standard, of necessary details such as symbols, and size, type or grade designations. If these details are to be used for any other purpose than implementation then the prior written permission of BSI must be obtained. If permission is granted, the terms may include royalty payments or a licensing agreement. Details and advice can be obtained from the Copyright Manager. Tel:02089967070.