BS EN 60835-3-1-1992 Methods of measurement for equipment used in digital microwave radio transmission systems - Measurements on satellite earth stations - General《数字微波无线电发射系统使用设备测.pdf

《BS EN 60835-3-1-1992 Methods of measurement for equipment used in digital microwave radio transmission systems - Measurements on satellite earth stations - General《数字微波无线电发射系统使用设备测.pdf》由会员分享，可在线阅读，更多相关《BS EN 60835-3-1-1992 Methods of measurement for equipment used in digital microwave radio transmission systems - Measurements on satellite earth stations - General《数字微波无线电发射系统使用设备测.pdf（10页珍藏版）》请在麦多课文档分享上搜索。

1、BRITISH STANDARD BS EN 60835-3-1:1994 BS 7573-3.1: 1992 IEC 835-3-1: 1990 Incorporating Amendment No. 1 Methods of measurement for equipment used in digital microwave radio transmission systems Part 3: Measurements on satellite earth stations Section 3.1 General The European Standard EN 60835-3-1:19

2、92 has the status of a British Standard UDC 621.396.6:629.783:621.317.08BSEN60835-3-1:1994 This British Standard, having been prepared under the directionof the Electronic Equipment Standards Policy Committee, was published underthe authority of the Standards Board and comesintoeffect on 1 April 199

3、2 BSI 04-2000 The following BSI references relate to the work on this standard: Committee reference EEL/25 Draft for comment 91/22366 DC ISBN 0 580 20758 7 Committees responsible for this British Standard The preparation of this British Standard was entrusted by the Electronic Equipment Standards Po

4、licy Committee (EEL/-) to Technical Committee EEL/25, upon which the following bodies were represented: British Broadcasting Corporation British Radio and Electronic Equipment Manufacturers Association British Telecommunications plc Independent Television Commission Institution of Electrical Enginee

5、rs Radio, Electrical and Television Retailers Association Radiocommunications Agency The following bodies were also represented in the drafting of the standard, through subcommittees and panels: EEA (the Association of the Electronics, Telecommunications and Business Equipment Industries) ERA Techno

6、logy Ltd. GAMBICA (BEAMA Ltd.) Amendments issued since publication Amd. No. Date Comments 8340 October 1994 Indicated by a sideline in the marginBSEN60835-3-1:1994 BSI 04-2000 i Contents Page Committees responsible Inside front cover National foreword ii Foreword 2 Text of EN 60835-3-1 3 Publication

7、(s) referred to Inside back coverBSEN60835-3-1:1994 ii BSI 04-2000 National foreword This Section of BS 7573 has been prepared under the direction of the Electronic Equipment Standards Policy Committee. It is identical with IEC 835-3-1 “Methods of measurement for equipment used in digital microwave

8、radio transmission systems Part 3: Measurements on satellite earth stations Section 1 General”, published by the International Electrotechnical Commission (IEC). In 1992 the European Committee for Electrotechnical Standardization (CENELEC) accepted IEC 835-3-1:1990 as European Standard EN 60835-3-1:

9、1992. As a consequence of implementing the European Standard this British Standard is renumbered as BS EN 60835-3-1 and any reference to BS7573-3.1 should be read as a reference to BS EN 60835-3-1. BS 7573 is published in three Parts. The other Parts are: Part 1: Measurements common to terrestrial r

10、adio-relay systems and satellite earth stations; Part 2: Measurements on terrestrial radio-relay systems. This Section of BS 7573 is intended to be used in conjunction with BS7573-1.1. A British Standard does not purport to include all the necessary provisions of a contract. Users of British Standar

11、ds are responsible for their correct application. Compliance with a British Standard does not of itself confer immunity from legal obligations. Cross-reference International Standard Corresponding British Standard IEC 835-1-1:1990 BS 7573 Methods of measurement for equipment used in digital microwav

12、e radio transmission systems Part 1 Measurements common to terrestrial radio-relay systems and satellite earth stations Section 1.1:1992 General (Identical) Summary of pages This document comprises a front cover, an inside front cover, pagesi andii, theEN title page, pages2 to4, an inside back cover

13、 and a back cover. This standard has been updated (see copyright date) and may have had amendments incorporated. This will be indicated in the amendment table on the inside front cover.EUROPEAN STANDARD NORME EUROPENNE EUROPISCHE NORM EN 60835-3-1 November 1992 UDC 621.396.6:629.783:621.317.08 Descr

14、iptors: Radiocommunications, telecommunications, communication equipment, earth stations, satellite broadcasting, microwave frequencies, measurements, characteristics, general English version Methods of measurement for equipment used in digital microwave radio transmission systems Part3:Measurements

15、 on satellite earth stations Section1:General (IEC 835-3-1:1990) Mthodes de mesure applicables au matriel utilis pour les systmes de transmission numrique en hyperfrquence Troisime partie: Mesures applicables aux stations terriennes de tlcommunications parsatellite Section un: Gnralits (CEI 835-3-1:

16、1990) Meverfahren fr Gerte in digitalen Mikrowellen-Funkbertragungssystemen Teil3: Messungen an Satelliten-Erdfunkstellen Hauptabschnitt eins: Allgemeines (IEC 835-3-1:1990) This European Standard was approved by CENELEC on 1992-09-15. CENELEC members are bound to comply with the CEN/CENELEC Interna

17、l Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the Central Secretariat or to any CENELEC memb

18、er. This European Standard exists in three official versions (English, French, German). A version in any other language made by translation under the responsibility of a CENELEC member into its own language and notified to the Central Secretariat has the same status as the official versions. CENELEC

19、 members are the national electrotechnical committees of Austria, Belgium, Denmark, Finland, France, Germany, Greece, Iceland, Ireland, Italy, Luxembourg, Netherlands, Norway, Portugal, Spain, Sweden, Switzerland and United Kingdom. CENELEC European Committee for Electrotechnical Standardization Com

20、it Europen de Normalisation Electrotechnique Europisches Komitee fr Elektrotechnische Normung Central Secretariat: rue de Stassart 35, B-1050 Brussels 1992 Copyright reserved to CENELEC members Ref. No. EN 60835-3-1:1992 EEN60835-3-1:1992 BSI 04-2000 2 Foreword The CENELEC questionnaire procedure, p

21、erformed for finding out whether or not the International Standard IEC 835-3-1:1990 could be accepted without textual changes, has shown that no common modifications were necessary for the acceptance as a European Standard. The reference document was submitted to the CENELEC members for formal vote

22、and was approved by CENELEC as EN 60835-3-1 on15September 1992. The following dates were fixed: Annexes designated “normative” are part of the body of the standard. In this standard, Annex ZA is normative. Contents Page Foreword 2 Section 1. General 1 Scope 3 2 Normative references 3 Annex ZA (norma

23、tive) Other international publications quoted in this standard with thereferences of the relevant European publications 4 latest date of publication of an identical national standard (dop) 1993-09-01 latest date of withdrawal of conflicting national standards (dow) 1993-09-01EN60835-3-1:1992 BSI 04-

24、2000 3 Section 1. General 1 Scope This part of the standard, which is supplementary to Part 1, IEC 835-1-1, describes methods of measurement applicable to satellite earth station systems using digital modulation. The object of this part is to provide recommended methods of measurement for assessing

25、the essential properties of satellite earth station systems as well as the associated sub-systems and it is intended to be used in conjunction with Part 1, IEC 835-1-1. Where measurements common to terrestrial radio-relay and satellite earth station systems are required, reference is made to the app

26、ropriate section of Part 1, IEC835-1-1. In such cases, only those special aspects of the measurement appropriate to satellite earth station systems are described in the sections of this Part 3. Where parameters or methods of measurement are applicable only to satellite earth station systems, they ar

27、e fully described within the appropriate sections of this part. 2 Normative references The following IEC publication is quoted in this standard: Publication No. 835-1-1 (1990), Methods of measurement for equipment used in digital microwave radio transmission systems, Part1:Measurements common to ter

28、restrial radio-relay systems and satellite earth stations. Section 1: General. EN60835-3-1:1992 4 BSI 04-2000 Annex ZA (normative) Other international publications quoted in this standard with the references of the relevant European publications When the international publication has been modified b

29、y CENELEC common modifications, indicated by (mod), the relevant EN/HD applies. IEC Publication Date Title EN/HD Date 835-1-1 1990 Methods of measurement for equipment used in digital microwave radio transmission systems Part 1: Measurements common to terrestrial radio-relay systems and satellite ea

30、rth stations Section 1: General EN 60835-1-1 1992BSEN60835-3-1:1994 BSI 04-2000 Publication(s) referred to See national foreword.BS EN 60835-3-1:1994 BS 7573-3.1: 1992 IEC 835-3-1: 1990 BSI 389 Chiswick High Road London W4 4AL BSIBritishStandardsInstitution BSI is the independent national body respo

31、nsible for preparing BritishStandards. It presents the UK view on standards in Europe and at the international level. It is incorporated by Royal Charter. Revisions BritishStandards are updated by amendment or revision. Users of BritishStandards should make sure that they possess the latest amendmen

32、ts or editions. It is the constant aim of BSI to improve the quality of our products and services. We would be grateful if anyone finding an inaccuracy or ambiguity while using this BritishStandard would inform the Secretary of the technical committee responsible, the identity of which can be found

33、on the inside front cover. Tel:02089969000. Fax:02089967400. BSI offers members an individual updating service called PLUS which ensures that subscribers automatically receive the latest editions of standards. Buying standards Orders for all BSI, international and foreign standards publications shou

34、ld be addressed to Customer Services. Tel:02089969001. Fax:02089967001. In response to orders for international standards, it is BSI policy to supply the BSI implementation of those that have been published as BritishStandards, unless otherwise requested. Information on standards BSI provides a wide

35、 range of information on national, European and international standards through its Library and its Technical Help to Exporters Service. Various BSI electronic information services are also available which give details on all its products and services. Contact the Information Centre. Tel:02089967111

36、. Fax:02089967048. Subscribing members of BSI are kept up to date with standards developments and receive substantial discounts on the purchase price of standards. For details of these and other benefits contact Membership Administration. Tel:02089967002. Fax:02089967001. Copyright Copyright subsist

37、s in all BSI publications. BSI also holds the copyright, in the UK, of the publications of the international standardization bodies. Except as permitted under the Copyright, Designs and Patents Act 1988 no extract may be reproduced, stored in a retrieval system or transmitted in any form or by any m

38、eans electronic, photocopying, recording or otherwise without prior written permission from BSI. This does not preclude the free use, in the course of implementing the standard, of necessary details such as symbols, and size, type or grade designations. If these details are to be used for any other purpose than implementation then the prior written permission of BSI must be obtained. If permission is granted, the terms may include royalty payments or a licensing agreement. Details and advice can be obtained from the Copyright Manager. Tel:02089967070.