BS 684-2 36-1983 Methods of analysis of fats and fatty oils - Other methods - Determination of butylhydroxyanisole (BHA) and butylhydroxytoluene (BHT)《脂肪和油脂的分析方法 其他方法 丁基羟基茴香醚(BHA)和.pdf
《BS 684-2 36-1983 Methods of analysis of fats and fatty oils - Other methods - Determination of butylhydroxyanisole (BHA) and butylhydroxytoluene (BHT)《脂肪和油脂的分析方法 其他方法 丁基羟基茴香醚(BHA)和.pdf》由会员分享,可在线阅读,更多相关《BS 684-2 36-1983 Methods of analysis of fats and fatty oils - Other methods - Determination of butylhydroxyanisole (BHA) and butylhydroxytoluene (BHT)《脂肪和油脂的分析方法 其他方法 丁基羟基茴香醚(BHA)和.pdf(8页珍藏版)》请在麦多课文档分享上搜索。
1、BRITISH STANDARD CONFIRMED NOVEMBER 1992 BS 684-2.36: 1983 ISO 6463:1982 Methods of analysis of Fats and fatty oils Part 2: Other methods Section 2.36 Determination of butylhydroxyanisole (BHA) and butylhydroxytoluene (BHT) ISO title: Animal and vegetable fats and oils Determination of butylhydroxya
2、nisole (BHA) and butylhydroxytoluene (BHT) Gas-liquid chromatographic method IMPORTANT NOTE. It is essential that this Section be read in conjunction with the information in BS 684-0 “General Introduction” which is published separately. UDC 665.1.014:543.544.45:547.56BS684-2.36:1983 This British Sta
3、ndard, having been prepared under the directionof the Food and Agriculture Standards Committee,was published underthe authority of the BoardofBSI and comes into effect on 31 May 1983 BSI 09-1999 The following BSI references relate to the work on this standard: Committee reference FAC/18 Draft for co
4、mment 81/51283 DC ISBN 0 580 11943 2 National foreword This Section of BS 684 was prepared under the direction of the Food and Agriculture Standards Committee and is identical with ISO 6463:1982 “Animal and vegetable fats and oilsDetermination of butylhydroxyanisole (BHA) and butylhydroxytoluene (BH
5、T)Gas-liquid chromatographic method” published by the International Organization for Standardization (ISO). Terminology and conventions. The text of the International Standard has been approved as suitable for publication as a British Standard without deviation. Some terminology and certain conventi
6、ons are not identical with those used in British Standards; attention is drawn especially to the following. The comma has been used as a decimal marker. In British Standards it is current practice to use a full point on the baseline as the decimal marker. Wherever the words “International Standard”
7、appear, referring to this standard, they should be read as “British Standard”. Additional information. With reference to the note to clause 1, the method is not now considered suitable for the determination of TBHQ. There is a proposal to amend the text of the International Standard. With regard to7
8、.2.2.2 it is sometimes useful to use an additional solution containing 20 4g of antioxidant per millilitre. With regard to 7.2.3 it is recommended that a graph is always plotted. If the graph is a straight line, the mean value of K can be calculated. A British Standard does not purport to include al
9、l the necessary provisions of a contract. Users of British Standards are responsible for their correct application. Compliance with a British Standard does not of itself confer immunity from legal obligations. Summary of pages This document comprises a front cover, an inside front cover, pages i and
10、 ii, pages 1 and 2, an inside back cover and a back cover This standard has been updated (see copyright date) and may have had amendments incorporated. This will be indicated in the amendment table on the inside front cover. Cross-reference International Standard Corresponding British Standard ISO 5
11、558:1982 BS 684 Methods of analysis of fats and fatty oils Section2.33:1983 Detection and identification of antioxidants (Identical) Amendments issued since publication Amd. No. Date of issue CommentsBS684-2.36:1983 BSI 09-1999 i Contents Page National foreword Inside front cover 1 Scope and field o
12、f application 1 2 Reference 1 3 Principle 1 4 Reagents 1 5 Apparatus 1 6 Detection 1 7 Procedure 1 8 Expression of results 2 9 Test report 2 Publication referred to Inside back coverii blankBS684-2.36:1983 BSI 09-1999 1 1 Scope and field of application This International Standard specifies a gas-liq
13、uid chromatographic method for the determination of butylhydroxyanisole (tert-butyl-4-methoxyphenol) (BHA) and butylhydroxytoluene (2,6-di-tert-butyl-4-methylphenol) (BHT), used as antioxidants, in animal and vegetable fats and oils. NOTEThe method also permits quantitative determination of tertiobu
14、tylhydroquinone (TBHQ). 2 Reference ISO 5558, Animal and vegetable fats and oils Detection and identification of antioxidants Thin-layer chromatographic method. 3 Principle Dissolution of the fat or oil in a suitable solvent, direct injection into a gas chromatograph, and use of the internal standar
15、d method of calibration. 4 Reagents 4.1 Carrier gas: an inert gas (such as nitrogen, helium or argon), carefully dried and containing less than 10 mg of oxygen per kilogram. 4.2 Auxiliary gases: hydrogen, minimum purity 99,9 %, free from organic compounds; air or oxygen, free from organic compounds.
16、 4.3 Dichloromethane or, failing this, carbon disulphide, containing no impurities which could interfere with the determination of BHA or BHT by gas chromatography. WARNING Dichloromethane and carbon disulphide are toxic. In addition, carbon disulphide is very volatile and explosive and particular c
17、are must be exercised in using it. 4.4 Methyl undecanoate, minimum purity 99 %. 4.5 Butylhydroxyanisole, minimum purity 98 %. 4.6 Butylhydroxytoluene, minimum purity 98 %. 5 Apparatus Usual laboratory equipment, and in particular: 5.1 Gas chromatograph, with a flame ionization detector and recorder,
18、 comprising: 5.1.1 Injection device, together with one of the following systems to retain the non-volatile fats and oils: a) a pre-column packed with siliconized glass wool or glass beads; b) a sleeve lined with siliconized glass wool placed in the injector (only in the case of a horizontal injector
19、). 5.1.2 Column, made of stainless steel or glass, permitting good separation of BHA and BHT, of length about 2 m and 2 to 4 mm in internal diameter, packed, for example, with 10 % methylpolysiloxanes 1) on acid-washed, silylated brick dust. 2) 5.2 Volumetric flasks, of capacities 10, 20 and 100 ml.
20、 5.3 Graduated pipettes, of capacities 1 and 2 ml. 5.4 Analytical balance 6 Detection See ISO 5558. 7 Procedure 7.1 Setting up the apparatus 7.1.1 Injection device Temperature: 250 C The sleeve or pre-column (5.1.1) shall be removed after each day of analysis and conditioned overnight at the test te
21、mperature. NOTEVerify the proper condition of the sleeve or pre-column by passing, from time to time, a fat or oil of known composition through the chromatograph. 7.1.2 Oven and column Temperature under isothermal conditions: 160 C Flow rate of carrier gas: optimum value to be established by the ope
22、rator. Before first use, condition the filled columns for 24 h at 220 C with the carrier gas flowing. 7.1.3 Detector Temperature: 250 C Flow rate of auxiliary gases: hydrogen: approximately 20 ml/min air or oxygen: according to the manufacturers instructions. 1) DC 200 of kinematic viscosity 1,25 m
- 1.请仔细阅读文档,确保文档完整性,对于不预览、不比对内容而直接下载带来的问题本站不予受理。
- 2.下载的文档,不会出现我们的网址水印。
- 3、该文档所得收入(下载+内容+预览)归上传者、原创作者;如果您是本文档原作者,请点此认领!既往收益都归您。
下载文档到电脑,查找使用更方便
10000 积分 0人已下载
下载 | 加入VIP,交流精品资源 |
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- BS6842361983METHODSOFANALYSISOFFATSANDFATTYOILSOTHERMETHODSDETERMINATIONOFBUTYLHYDROXYANISOLEBHAANDBUTYLHYDROXYTOLUENEBHT

链接地址:http://www.mydoc123.com/p-546301.html