BS 3762-3 16-1985 Analysis of formulated detergents - Quantitative test methods - Method for determination of chloride content《配制洗涤剂分析 第3部分 定量试验方法 第16节 氯化物含量测定方法》.pdf

《BS 3762-3 16-1985 Analysis of formulated detergents - Quantitative test methods - Method for determination of chloride content《配制洗涤剂分析 第3部分 定量试验方法 第16节 氯化物含量测定方法》.pdf》由会员分享，可在线阅读，更多相关《BS 3762-3 16-1985 Analysis of formulated detergents - Quantitative test methods - Method for determination of chloride content《配制洗涤剂分析 第3部分 定量试验方法 第16节 氯化物含量测定方法》.pdf（8页珍藏版）》请在麦多课文档分享上搜索。

1、BRITISH STANDARD CONFIRMED JULY1990 BS3762-3.16: 1985 Analysis of formulated detergents Part 3: Quantitative test methods Section 3.16 Method for determination of chloride content NOTEIt is recommended that this Section be read in conjunction with the information in the “General Introduction”, publi

2、shed separately as BS3762-0. UDC 661.185:543.257:546.161BS3762-3.16:1985 This BritishStandard, having been prepared under the directionof the Chemicals Standards Committee, was published under the authority ofthe Board of BSI and comes intoeffect on 31January1985 BSI12-1999 The committees responsibl

3、e for this BritishStandard are shown inPart0. The following BSI references relate to the work on this standard: Committee reference CIC/34 Draft for comment84/50246 DC ISBN 0 580 14134 9 Foreword This Section of BS3762 has been prepared under the direction of the Chemicals Standards Committee and su

4、persedes methodD5 of BS3762:1964. This standard describes a method of test only and should not be referred to as a specification defining limits of purity. Reference to the standard should indicate that the method of test used is in conformity with BS3762-3.16. A British Standard does not purport to

5、 include all the necessary provisions of a contract. Users of British Standards are responsible for their correct application. Compliance with a British Standard does not of itself confer immunity from legal obligations. Summary of pages This document comprises a front cover, an inside front cover,

6、pagesi andii, pages1 and2, an inside back cover and a back cover. This standard has been updated (see copyright date) and may have had amendments incorporated. This will be indicated in the amendment table on the inside front cover. Amendments issued since publication Amd. No. Date of issue Comments

7、BS3762-3.16:1985 BSI 12-1999 i Contents Page Foreword Inside front cover 1 Scope 1 2 Principle 1 3 Reagents 1 4 Apparatus 1 5 Procedure 1 6 Expression of results 1 7 Test report 1 Publication referred to Inside back coverii blankBS3762-3.16:1985 BSI 12-1999 1 1 Scope This Section of BS3762 describes

8、 a method of analysis for the determination of chloride content of formulated detergents. The chloride content is expressed as sodium chloride. NOTEThe title of the publication referred to in this Section is given on the inside back cover. 2 Principle The chloride is directly titrated with silver ni

9、trate and a silver electrode is used to detect the end-point. 3 Reagents The reagents shall be of a recognized analytical reagent quality. Water complying with the requirements of BS3978 shall be used throughout. 3.1 Nitric acid solution, c(HNO 3 )=5mol/L. 3.2 Silver nitrate solution, c(AgNO 3 )=0.1

10、00mol/L. 3.3 Methyl orange indicator solution 4 Apparatus Ordinary laboratory apparatus and the following are required. 4.1 pH meter, or other apparatus suitable for potentiometric titrations. 4.2 Silver electrode 4.3 Mercury (I) sulphate reference electrode 5 Procedure 5.1 Test portion Weigh, to0.0

11、1g, approximately5g of the well mixed sample or proportionally less in the case of asample containing more than5% of chloride (asNaCl). 5.2 Determination Dissolve the test portion in50mL to100mL of water and add a few drops of methyl orange indicator. If the solution is alkaline, neutralize with nit

12、ric acid. Add3mL of nitric acid solution(3.1) in excess. Introduce the silver and mercury sulphate electrodes connected to the pH meter(4.1) and, while stirring, titrate with the silver nitrate solution. Plot a graph of millivolts or pH scale units as ordinates against millilitres of0.100mol/L silve

13、r nitrate solution(3.2). Read off the volume, T, in millilitres corresponding to the steepest part of the graph. 6 Expression of results The chloride content, expressed as a percentage by mass of sodium chloride (NaCl), is given by the following expression: 7 Test report The test report shall includ

14、e the following information: a) a reference to this BritishStandard, i.e.BS3762-3.16; b) the results and the method of expression used; c) the test conditions. where T is the volume of silver nitrate solution; c is the actual concentration of the silver nitrate solution(3.2) (in mol/L); m is the mas

15、s of the test portion (in g).2 blankBS3762-3.16:1985 BSI 12-1999 Publication referred to BS3978, Water for laboratory use. BS3762-3.16: 1985 BSI 389 Chiswick High Road London W4 4AL BSIBritishStandardsInstitution BSI is the independent national body responsible for preparing BritishStandards. It pre

16、sents the UK view on standards in Europe and at the international level. It is incorporated by Royal Charter. Revisions BritishStandards are updated by amendment or revision. Users of BritishStandards should make sure that they possess the latest amendments or editions. It is the constant aim of BSI

17、 to improve the quality of our products and services. We would be grateful if anyone finding an inaccuracy or ambiguity while using this BritishStandard would inform the Secretary of the technical committee responsible, the identity of which can be found on the inside front cover. Tel:02089969000. F

18、ax:02089967400. BSI offers members an individual updating service called PLUS which ensures that subscribers automatically receive the latest editions of standards. Buying standards Orders for all BSI, international and foreign standards publications should be addressed to Customer Services. Tel:020

19、89969001. Fax:02089967001. In response to orders for international standards, it is BSI policy to supply the BSI implementation of those that have been published as BritishStandards, unless otherwise requested. Information on standards BSI provides a wide range of information on national, European a

20、nd international standards through its Library and its Technical Help to Exporters Service. Various BSI electronic information services are also available which give details on all its products and services. Contact the Information Centre. Tel:02089967111. Fax:02089967048. Subscribing members of BSI

21、 are kept up to date with standards developments and receive substantial discounts on the purchase price of standards. For details of these and other benefits contact Membership Administration. Tel:02089967002. Fax:02089967001. Copyright Copyright subsists in all BSI publications. BSI also holds the

22、 copyright, in the UK, of the publications of the international standardization bodies. Except as permitted under the Copyright, Designs and Patents Act 1988 no extract may be reproduced, stored in a retrieval system or transmitted in any form or by any means electronic, photocopying, recording or o

23、therwise without prior written permission from BSI. This does not preclude the free use, in the course of implementing the standard, of necessary details such as symbols, and size, type or grade designations. If these details are to be used for any other purpose than implementation then the prior written permission of BSI must be obtained. If permission is granted, the terms may include royalty payments or a licensing agreement. Details and advice can be obtained from the Copyright Manager. Tel:02089967070.