BS 3668-1963 Specification for red and green filters used in ophthalmic dichromatic and dissociation tests《眼科二色性和分离试验用红绿滤光片规范》.pdf

《BS 3668-1963 Specification for red and green filters used in ophthalmic dichromatic and dissociation tests《眼科二色性和分离试验用红绿滤光片规范》.pdf》由会员分享，可在线阅读，更多相关《BS 3668-1963 Specification for red and green filters used in ophthalmic dichromatic and dissociation tests《眼科二色性和分离试验用红绿滤光片规范》.pdf（8页珍藏版）》请在麦多课文档分享上搜索。

1、BRITISH STANDARD BS3668:1963 Specification for Red and green filters used in ophthalmic dichromatic and dissociation testsBS3668:1963 This BritishStandard, having been approved by the OphthalmicStandards Committee, was published underthe authority of the GeneralCouncil on 9 October1963 BSI02-2000 Th

2、e following BSI references relate to the work on this standard: Committee reference M/48/3 Draft for comment D62/11524 ISBN 0 580 343596 Co-operating organizations The Ophthalmic Standards Committee, under whose supervision this BritishStandard was prepared, consists of representatives from the foll

3、owing Government departments and professional and industrial organizations: Admiralty Association of Dispensing Opticians* British Medical Association* Faculty of Ophthalmologists* Federation of Manufacturing Opticians* Guild of British Dispensing Opticians* Joint Committee of Ophthalmic Opticians*

4、Ministry of Education Ministry of Health* National Physical Laboratory (D.S.I.R.) The Government department and professional and industrial organizations marked with an asterisk in the above list, together with the following, were directly represented on the Committee entrusted with the preparation

5、of this standard: Scottish National Committee of Ophthalmic Opticians Amendments issued since publication Amd. No. Date CommentsBS 3668:1963 BSI 02-2000 i Contents Page Co-operating organizations Inside front cover Foreword ii 1 Scope 1 2 Definitions 1 Section 1. Filters for use in dichromatic tests

6、 3 Weighted spectral transmission 1 4 Luminous transmission factor 1 Section 2. Filters for use in dissociation tests 5 Spectral transmission 1 6 Luminous transmission factor 1 7 Quality of viewing goggles 2BS 3668:1963 ii BSI 02-2000 Foreword This BritishStandard defines some necessary characterist

7、ics of the complementary colour filters which are used in certain tests in an examination of the eyes. Complementary filters are used in two main classes of ophthalmic tests, one of which (dichromatic test) is applicable to either eye separately; the other (dissociation test) is not thus applicable

8、because its purpose is to distinguish one eye from the other while both are in use at the same time. Filters transmitting mainly in the red and the green respectively are alone considered in this BritishStandard, but this should not be taken as either rejection or disapprobation of tests employing f

9、ilters of other colours and based on different theoretical considerations. Requirements for red and green filters for use in dichromatic tests have been specified on the following assumptions: a) that the charts or panels projected or viewed through the filters will be illuminated with lamps approxi

10、mating to C.I.E. Standard Illuminant A, b) that the zero point for the axial chromatic aberration of the eye should be taken as570m, the wavelength for which the relative luminous efficiency of the light-adapted eye is assumed to be the maximum when the relative energy values of Standard Illuminant

11、A are taken into account, and c) that, in terms of generally accepted values of the eyes axial chromatic aberration, the wavelengths at which the two filters have their maximum weighted transmission factor should be equally spaced about the zero point and separated by a total interval corresponding

12、to0.25 to0.50 dioptres. BritishStandards relating to ophthalmic subjects include the following: BS2738, Spectacle lenses. BS3062, Spectacle lens materials. BS3162, Ophthalmic trial case lenses. BS3172, Screw threads of Unified form for spectacle frames including screwing taps and gauges. BS3186, Cel

13、lulose acetate sheet for spectacle frames. BS3199, Measurement of spectacles: method and glossary. BS3352, Spectacle frames made of cellulose acetate. BS3462, Metal spectacle frames. BS3521, Glossary of terms relating to ophthalmic lenses and spectacle frames. A British Standard does not purport to

14、include all the necessary provisions of a contract. Users of British Standards are responsible for their correct application. Compliance with a British Standard does not of itself confer immunity from legal obligations. Summary of pages This document comprises a front cover, an inside front cover, p

15、agesi andii, pages1 and 2, an inside back cover and a back cover. This standard has been updated (see copyright date) and may have had amendments incorporated. This will be indicated in the amendment table on the inside front cover.BS 3668:1963 BSI 02-2000 1 1 Scope This BritishStandard specifies re

16、quirements for red and green filters of glass or plastics materials used in ophthalmic tests as follows: a) dichromatic tests for ametropia, and b) dissociating the eyes in various tests of binocular co-operation. 2 Definitions For the purposes of this BritishStandard the following definitions apply

17、: 2.1 radiant flux power emitted, transferred or received in the form of radiation 2.2 luminous flux that quantity characteristic of radiant flux which expresses its capacity to produce visual sensation, evaluated according to the figures of relative luminous efficiency adopted by C.I.E. for the lig

18、ht-adapted eye 2.3 filter a device, normally a sheet of tinted material of substantially uniform thickness, designed to modify the spectral distribution of energy of the light passing through it 2.4 spectral transmission factor for a specified wavelength, the ratio of the radiant flux transmitted by

19、 a filter to the incident radiant flux 2.5 weighted spectral transmission factor the spectral transmission factor multiplied by thedistribution coefficient of the C.I.E. system weighted by the relative energy values for Standard Illuminant A 1) 2.6 weighted spectral transmission curve a graph in whi

20、ch the weighted spectral transmission factor is plotted against wavelength 2.7 luminous transmission factor the ratio of the luminous flux transmitted by a filter to the incident flux, found by calculation or integration from the weighted spectral transmission curve Section 1. Filters for use in dic

21、hromatic tests 3 Weighted spectral transmission The weighted spectral transmission curves shall have the following characteristics: a) for the green filter, a peak within the waveband530 to550m, b) for the red filter, a peak within the waveband600 to620m, c) for each filter, a maximum separation of6

22、0m between the two wave lengths for which the weighted spectral transmission factor is0.5 of themaximum. 4 Luminous transmission factor The luminous transmission factors of the two filters shall not differ from each other by more than15 per cent of the higher value. Section 2. Filters for use in dis

23、sociation tests 5 Spectral transmission The following requirements apply to filters both for presenting and for viewing the test objects: a) For the green filter the spectral transmission factor shall not exceed0.02 for all wavelengths from595 to605m and0.001 for all wavelengths from605 to700m. b) F

24、or the red filter the spectral transmission factor shall not exceed0.02 for all wavelengths from595 to605m and0.001 for all wavelengths from400 to595m. 6 Luminous transmission factor The luminous transmission factor for the pair of filters of one colour taken together (one before the light source an

25、d one in the goggles) shall not differ significantly from the corresponding factor for the pair of filters of the other colour. 1) See Commission Internationale de LEclairage, Compte Rendu des Sances,1931, page19; also W. D. Wright(1958), “TheMeasurement of Colour”, Hilger & Watts Limited, London.yB

26、S 3668:1963 2 BSI 02-2000 NOTEThis condition may not be satisfied if goggles of one manufacture are used with dissociation apparatus of different manufacture. 7 Quality of viewing goggles Goggles for dissociation tests shall be so made as not to introduce significant distortion or doubling of the im

27、ages under normal conditions of use. They shall not introduce a significant prismatic error between the two eyes in any direction of gaze within the field of binocular fixation.BS 3668:1963 BSI 02-2000 British Standards The following are available on application: YEARBOOK Including subject index and

28、 numerical list of BritishStandards15s. SECTIONAL LISTS. Gratis Acoustics Aircraft materials and components Building materials and components Chemical engineering Chemicals, fats, oils, scientific apparatus, etc. Cinematography and photography Coal, coke and colliery requisites Codes of Practice Con

29、sumer goods Documentation, including Universal Decimal Classification Drawing practice Electrical engineering Farming, dairying and allied interests Furniture, bedding and furnishings Gas and solid fuel Glassware including scientific apparatus Hospital equipment Illumination and lighting fittings Ir

30、on and steel Mechanical engineering Nomenclature, symbols and abbreviations Non-ferrous metals Packaging and containers Paints, varnishes and colours for paints Personal safety equipment Petroleum industry Plastics Printing, paper and stationery Road engineering Rubber Shipbuilding Textiles and clot

31、hing WeldingBS3668:1963 BSI 389 Chiswick High Road London W4 4AL BSIBritishStandardsInstitution BSI is the independent national body responsible for preparing BritishStandards. It presents the UK view on standards in Europe and at the international level. It is incorporated by Royal Charter. Revisio

32、ns BritishStandards are updated by amendment or revision. Users of BritishStandards should make sure that they possess the latest amendments or editions. It is the constant aim of BSI to improve the quality of our products and services. We would be grateful if anyone finding an inaccuracy or ambigui

33、ty while using this BritishStandard would inform the Secretary of the technical committee responsible, the identity of which can be found on the inside front cover. Tel:02089969000. Fax:02089967400. BSI offers members an individual updating service called PLUS which ensures that subscribers automati

34、cally receive the latest editions of standards. Buying standards Orders for all BSI, international and foreign standards publications should be addressed to Customer Services. Tel:02089969001. Fax:02089967001. In response to orders for international standards, it is BSI policy to supply the BSI impl

35、ementation of those that have been published as BritishStandards, unless otherwise requested. Information on standards BSI provides a wide range of information on national, European and international standards through its Library and its Technical Help to Exporters Service. Various BSI electronic in

36、formation services are also available which give details on all its products and services. Contact the Information Centre. Tel:02089967111. Fax:02089967048. Subscribing members of BSI are kept up to date with standards developments and receive substantial discounts on the purchase price of standards

37、. For details of these and other benefits contact Membership Administration. Tel:02089967002. Fax:02089967001. Copyright Copyright subsists in all BSI publications. BSI also holds the copyright, in the UK, of the publications of the international standardization bodies. Except as permitted under the

38、 Copyright, Designs and Patents Act 1988 no extract may be reproduced, stored in a retrieval system or transmitted in any form or by any means electronic, photocopying, recording or otherwise without prior written permission from BSI. This does not preclude the free use, in the course of implementin

39、g the standard, of necessary details such as symbols, and size, type or grade designations. If these details are to be used for any other purpose than implementation then the prior written permission of BSI must be obtained. If permission is granted, the terms may include royalty payments or a licensing agreement. Details and advice can be obtained from the Copyright Manager. Tel:02089967070.