ARMY MIL-PRF-32271 1-2008 BATTERY NON-RECHARGEABLE LITHIUM《不可充电锂电池》.pdf

《ARMY MIL-PRF-32271 1-2008 BATTERY NON-RECHARGEABLE LITHIUM《不可充电锂电池》.pdf》由会员分享，可在线阅读，更多相关《ARMY MIL-PRF-32271 1-2008 BATTERY NON-RECHARGEABLE LITHIUM《不可充电锂电池》.pdf（8页珍藏版）》请在麦多课文档分享上搜索。

1、AMSC N/A Page 1 of 8 FSC 6135 DISTRIBUTION STATEMENT A: Approved for public release; distribution is unlimited INCH-POUND MIL-PRF-32271/1 30 October 2008 PERFORMANCE SPECIFICATION SHEET BATTERY, NON-RECHARGEABLE, LITHIUM This specification is approved for use by all Departments and Agencies of the D

2、epartment of Defense. The requirements for acquiring the product herein shall consist of this specification and MIL-PRF-32271. Figure 1 General View, M32271/1 Battery Shape REQUIREMENTS (see 1.2 for Type, Class, and Features descriptions): Type I II III Class 2 2 2 Features C D E C D E E PIN M32271/

3、1-12C M32271/1-12D M32271/1-12E M32271/1-22C M32271/1-22D M32271/1-22E M32271/1-32E Approved Chemistry Lithium Manganese Dioxide Lithium Sulfur Dioxide Lithium Manganese Dioxide Specification requirements: The following requirements of MIL-PRF-32271, identified therein by the phrase “when specified”

4、, are applicable as indicated below: See NOTES for nominal dimensions; see applicable drawing for dimensional requirements. Copyright Communications - Electronics Command Provided by IHS under license with CRAINot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-PRF

5、-32271/1 2 Applicability by PIN Suffix (M32271/1-) Requirement Specification Reference 12C 12D 12E 22C 22D 22E 32E Parallel cell arrangements13.4 Yes Yes Yes No No No Yes Connectors 3.4.5 Yes Yes Yes Yes Yes Yes Yes Battery charger connection 3.4.5.1 No No No No No No No Connection integrity 3.4.5.2

6、 No No No No No No No Terminal integrity 3.4.6 No No No No No No No Complete discharge device 3.4.7 Yes Yes Yes Yes Yes Yes Yes State of charge device 3.4.8 No Yes Yes No Yes Yes Yes State of charge data output 3.4.8e No No Yes No No Yes Yes Cell charging 3.5.3 Yes Yes Yes Yes Yes Yes Yes Nail penet

7、ration 3.5.4 Yes Yes Yes No No No Yes Cell series short circuit 3.5.6 Yes Yes Yes No No No Yes Parallel string charge protection23.5.6.1 Yes Yes Yes No No No Yes Charge protection 3.5.11 Yes Yes Yes Yes Yes Yes Yes Over-current protection 3.5.13.1 Yes Yes Yes Yes Yes Yes Yes Over-temperature protect

8、ion 3.5.14 Yes Yes Yes Yes Yes Yes Yes Surface temperature 3.6h Yes Yes Yes Yes Yes Yes Yes Capacity LR Type II 2.33 lbs. (1,057 g); Type III 3.20 lbs. (1,451 g) State of charge (3.4.8 Type II 6.2 ampere-hours; Type III 10.8 ampere-hours. METHODS OF EXAMINATION AND TEST: Verification requirements. T

9、he following verification requirements of MIL-PRF-32271, identified therein by the phrase “when specified,” are applicable to each battery type as indicated below: Applicability by PIN Suffix (M32271/1-) Test Requirement Specification Reference 12C 12D 12E 22C 22D 22E 32E Parallel discharges Tables

10、III, IV, IX, 1.7 hours for Type II batteries; and 2.9 hours for Type III batteries. Abuse test, pulse discharge: When tested as specified in 4.6.2.12i, discharge in the series mode with a load of 2.5 amperes for 1 minute followed by 1.8 amperes for 4 minutes, cycled continuously to 20.00 volts. Batt

11、ery over-current protection: When tested as specified in 4.6.2.13, apply a load to the batteries with the battery sections connected in the series mode and subject to a load of either 4 amperes or 96 watts. Immersion: When tested as specified in 4.6.5.8, apply a load, with the battery connected in t

12、he series mode, of either 0.4 amperes or 4.6 watts during the storage and immersion time periods specified. 4This test only required if parallel cell arrangements are used for Type I or III batteries Copyright Communications - Electronics Command Provided by IHS under license with CRAINot for Resale

13、No reproduction or networking permitted without license from IHS-,-,-MIL-PRF-32271/1 6 Capacity tests (4.6.4): Test5Discharge Rate Duty Cycle I 2 amperes Continuous discharge to zero volts, followed by 2-ampere forced discharge for 10 minutes. IP 4 amperes Continuous discharge to zero volts, followe

14、d by 4-ampere forced discharge for 10 minutes L 2 amperes Continuous discharge to cut-off voltage LP 4 amperes Continuous discharge to cut-off voltage H 2 amperes Discharge for 5 minutes at 2 amperes, followed by 5 minutes on open circuit; repeat cycle continuously to cut-off voltage HP 4 amperes Di

15、scharge for 5 minutes at 4 amperes, followed by 5 minutes on open circuit; repeat cycle continuously to cut-off voltage LR 145 mA/5.5W Discharge in series mode at 145 milliamperes to 20.5 volts, then Discharge at 5.5 watts to cut-off voltage IT 2 amperes Continuous discharge to cut-off voltage ITP 4

16、 amperes Continuous discharge to cut-off voltage LT 2 amperes Continuous discharge to cut-off voltage LTP 4 amperes Continuous discharge to cut-off voltage HT 2 amperes Discharge for 5 minutes at 2 amperes, followed by 5 minutes on open circuit; repeat cycle continuously to cut-off voltage HTP 4 amp

17、eres Discharge for 5 minutes at 4 amperes, followed by 5 minutes on open circuit; repeat cycle continuously to cut-off voltage LRT 145 mA/5.5W Discharge in series mode at 145 milliamperes to 20.5 volts, then Discharge at 5.5 watts to cut-off voltage NOTES: (This section contains information of a gen

18、eral nature which may be helpful, but is not mandatory) Intended use: This battery is intended to operate portable military communications electronics equipment. It is used mainly in tactical radios, but is also used in sensors, chemical agent alarms, night vision equipment, and many other types of

19、electronic equipment. Some applications use the battery for powering electric motors. 6Nominal ratings: The following are the nominal ratings for each battery type described by this specification sheet. They are provided for information purposes. 5Discharge tests including the letter P require disch

20、arge with the two sections of the battery connected in parallel; all other capacity tests require discharge with the two sections connected in series. 6Capacity and energy delivered by a battery are significantly affected by usage conditions, such as temperature and loads applied. If you have any qu

21、estions about use of this battery in a particular device or circumstance, please visit the following web site (contact info is posted): http:/www.cerdec.army.mil/c2d/armypower. Copyright Communications - Electronics Command Provided by IHS under license with CRAINot for ResaleNo reproduction or netw

22、orking permitted without license from IHS-,-,-MIL-PRF-32271/1 7 Battery PIN: M32271/1-12C, 12D or 12E (Li/MnO2) M32271/1-22C, 22D or 22E (Li/SO2) M32271/1-32E (Li/MnO2) Overall Dimensions: 5 in H x 4.4 in W x 2.45 in D MAX Weight: 3.1 lbs (1.41 Kg) 2.33 lbs (1.06 Kg) 3.2 lbs (1.45 Kg) Connection Typ

23、e: Series Parallel Series Parallel Series Parallel Voltage Range: 20-33 10-16.5 20-30.5 10-15.25 20-33 10-16.5 Nominal Capacity (Ampere-hours): 10-11 Amp-hours 20-22 Amp-hours 6.8-7.2 Amp-hours 13.6-14.4 Amp-hours 11.6-13 Amp-hours 23.2-26 Amp-hours Nominal Energy (Watt-hours): 208-260 Watt-hours 16

24、0-200 Watt-hours 220-305 Watt-hours MAX Rated Power Output: 50 watts 50 watts 50 watts MAX Continuous load Rating: 2 Amps 4 Amps 2 Amps 4 Amps 2 Amps 4 Amps MAX Pulse Rating: 2.5 Amps 5 Amps 2.5 Amps 5 Amps 2.5 Amps 5 Amps Instantaneous Trip Rating: 4 Amps 8 Amps 4 Amps 8 Amps 4 Amps 8 Amps Operatin

25、g Temperature Range: -20 to 130F (-29 to 55C) -4 to 130F (-20 to 55C) Storage Temperature Range: -40 to 160F (-40 to 71C) MAX Abusive Temperature (non-operating): 195F (91C) 172F (78C) Other data: Military Type Designations. The military type designations that relate to the PINs covered by this spec

26、ification sheet are as follows: The BA-5390()/U designation has been used for the Type I PINs; the BA-5590()/U designation has been used for the Type II PINs; and the BA-7590()/U designation was used once for prototypes of the Type III PIN. All battery types described by this specification sheet hav

27、e two independent sections with each section designed to provide a nominal 12 volts in use. Sockets 1 and 4 on the connector are for one section; sockets 2 and 5 are the other. Using equipment can connect for either 12-volt or 24-volt operation by connecting these two sections in parallel or series

28、respectively. When required, the state of charge device is located in section 1-4. For batteries with State of Charge data output (PINs ending with “E”), the ground connection for the SOC device is located on the battery connector at pin 1. See table above for differences in performance among the th

29、ree types. All battery types are subject to the transportation requirements of 49 CFR 173.185. M32271/1-12C, -12D, 12E and -32E batteries (solid cathode) contain more than 1 gram of lithium per cell and more than 2 grams per battery; M32271/1-22C, -22D and -22E (liquid cathode) batteries contain mor

30、e than 0.5 grams per cell and 1 gram per battery. Check the appropriate Material Safety Data Sheet for actual lithium content. It should be noted that all non-rechargeable lithium batteries are restricted from shipment as cargo aboard passenger aircraft within, entering, or leaving the US. Copyright

31、 Communications - Electronics Command Provided by IHS under license with CRAINot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-PRF-32271/1 8 All battery types described by this specification sheet include a complete discharge device in order to render the battery

32、 non-reactive after use. If the battery is damaged, or if the device does not operate as indicated by an amber or yellow light, the battery is considered reactive waste. Any type, whether completely discharged or not, may be recycled after use. Universal waste rules, where applicable, apply only whe

33、n recycling is the chosen disposal method. The US Army CECOM Life Cycle Management Command (LCMC) publishes guidelines for the design of battery compartments for devices using both battery types I and II covered by this specification sheet: Technical Bulletin CECOM-TB-7. Please contact the CECOM LCM

34、C Directorate for Safety at monm-amselsfsecconus.army.mil for further information. Navy safety tests of NAVSEA S9310-AQ-SAF-010 are required for this battery during first article testing. The test data provided from the testing will be used to evaluate applications for specific using devices and Nav

35、y platforms. Devices using any battery described by this specification sheet will require US Navy Safety Approval prior to use by Department of Navy users unless such approval has already been granted. Please consult with NAVSEA Instruction 9310.1 for further information. Custodians: Preparing activ

36、ity: Army CR Army CR Navy NW (Project Number 6135-2006-004) Air Force 99 DLA GS Review activities: Navy SH, AS, MC Air Force 71 NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify t

37、he currency of the information above using the ASSIST Online database at http:/assist.daps.dla.mil or http:/assist.daps.dla.mil/quicksearch/. Copyright Communications - Electronics Command Provided by IHS under license with CRAINot for ResaleNo reproduction or networking permitted without license from IHS-,-,-