ARMY MIL-DTL-11484 303 A-2009 LAPEL BUTTON 9-11 RIBBON DEPARTMENT OF TRANSPORTATION《领徽 运输部9-11勋表领徽》.pdf

《ARMY MIL-DTL-11484 303 A-2009 LAPEL BUTTON 9-11 RIBBON DEPARTMENT OF TRANSPORTATION《领徽 运输部9-11勋表领徽》.pdf》由会员分享，可在线阅读，更多相关《ARMY MIL-DTL-11484 303 A-2009 LAPEL BUTTON 9-11 RIBBON DEPARTMENT OF TRANSPORTATION《领徽 运输部9-11勋表领徽》.pdf（2页珍藏版）》请在麦多课文档分享上搜索。

1、AMSC N/A Page 1 of 2 FSC 8455 INCH-POUND MIL-DTL-11484/303A 1 May 2009 SUPERSEDING MIL-DTL-11484/303 15 June 2004 DETAIL SPECIFICATION SHEET LAPEL BUTTON, 9-11 RIBBON, DEPARTMENT OF TRANSPORTATION This specification is approved for use by all Departments and Agencies of the Department of Defense. Th

2、e requirements for acquiring the product described herein shall consist of this specification sheet and the latest issue of MIL-DTL-11484. MATERIAL: Gilding Metal or Red Brass FINISH: Hard Enameled or Epoxied, Gold Plated, Mirror-like Polished, and shall match The Institute of Heraldry (TIOH) Metal

3、Finish Chip Number 6. DIMENSIONS: HEIGHT: 9/64 inch (REF) WIDTH: 21/32 inch (REF) THICKNESS (at edge): 0.055 0.005 inch NOTES: 1. The term (REF) refers to the measurements taken from the Government furnished hub or die. Provided by IHSNot for ResaleNo reproduction or networking permitted without lic

4、ense from IHS-,-,-MIL-DTL-11484/303A Page 2 of 2 2. Attaching device shall be prong with pick and wing type clutch. The prong shall be centered on the reverse side and fused or soldered to the lapel button. 3. Enameled/epoxied areas shall be as shown. Epoxy resin (stoning epoxy) may be at the option

5、 of the manufacturer. When hard enamel is used, the material requirement shall be gilding metal. When epoxy is used, the material requirement shall be either red brass or gilding material. Colors shall conform to TIOH Hard Enamel Color Chip Numbers listed below: COLOR CHIP NUMBER Blue 18 Scarlet 1 W

6、hite 28 4. Ribbon for the 9-11 Ribbon award shall conform to MIL-DTL-11589/587. CHANGES FROM PREVIOUS ISSUE: The margins of this specification are marked with vertical lines to indicate where changes from the previous issue were made. This was done as a convenience only and the Government assumes no

7、 liability whatsoever for any inaccuracies in these notations. Bidders and contractors are cautioned to evaluate the requirements of this document based on the entire content irrespective of the marginal notations and relationship to the last previous issue. Custodian: Preparing activity: Army - IH

8、Army - IH (Project No. 8455-2009-075) Review activities: DLA - CT NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at http:/assist.daps.dla.mil. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-