ARMY MIL-C-12926 E (5)-1993 CARTRIDGE 4 2 INCH ILLUMINATING M335A2 LOADING ASSEMBLING AND PACKING《M335A2型4 2英寸照明弹的装配 组装及包装》.pdf

《ARMY MIL-C-12926 E (5)-1993 CARTRIDGE 4 2 INCH ILLUMINATING M335A2 LOADING ASSEMBLING AND PACKING《M335A2型4 2英寸照明弹的装配 组装及包装》.pdf》由会员分享，可在线阅读，更多相关《ARMY MIL-C-12926 E (5)-1993 CARTRIDGE 4 2 INCH ILLUMINATING M335A2 LOADING ASSEMBLING AND PACKING《M335A2型4 2英寸照明弹的装配 组装及包装》.pdf（2页珍藏版）》请在麦多课文档分享上搜索。

1、MIL-C-1272bE (5) 9979906 1853122 413 O * e * MIL-C-12926E (AR) AMENDMENT 5 23 March 1993 SUPERSEDING AMENDMENT 4 16 May 1990 MILITARY SPECIFICATION CARTRIDGE, 4.2 INCH, ILLUMINATING, M335A2 LOADING, ASSEMBLING AND PACKING This amendment forms a part of MIL-C-12926E (AR), dated 17 March 1981, and is

2、approved for use by the U.S. Army Armament, Munitions and Chemical Command and is available for use by all Departments and Agencies of the Department Of Defense. PAGE 1 1.1, Line 5, Delete “M565“ and substitute “M565/M577.“ PAGE 12 4.4.2.7, Major 102, Add “(if applicable)“ after “Adapter damaged. PA

3、GE 13 4.4.2.8, Delete Major 105 in its entirety. Delete Major 106 in its entirety and substitute the following: “106 Fifty inch pound disassembly torque, max. . 125 (c) . . . 3.2 . . .Gage“. Under Major category, add new 107 as follows: “107 Cartridge assembly fails to freely pass through profile an

4、d alignment gage after retouch with paint . . . 100% . . . 3 . 2 . . .Gage“ Under Major category add new 108 as follows: “108 Silicone rubber RTV adhesive sealant not present .125 (c) .,.3.2 . Visual“ Delete under “NOTES“ (a) and (b) in its entirety. a AMSC N/A 1 of 2 FSC 1315 DISTRIBUTION STATEMENT

5、 A. Approved for public release; distribution is unlimited. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-flIL-C-1292bE (5) 999990b 1853123 35T MIL-C-129 2 6E (AR) AMENDMENT 5 PAGE 13 (Contd) * Under “NOTES“, Add “(c) Acceptance/Rejection criteria

6、are Accept- O /Rej ect-1 I PAGE 18 4.4.3.1.2.2, Delete last sentence and substitute “In the event that any lot fails to comply with the requirement, the acceptance criteria shall revert to 4.4.3.1.2.1.“ PAGE 19 Table I, Change “Major - Functioning - 2-3-1-2.“ to “Major - Functioning - 3-4-1-2.“ PAGE

7、 20 4.5.1, Add the following after the last sentence: “The mortar tube at the beginning of the test shall have fired less than 4,000 rounds.“ NOTE: vertical line to indicate where changes (additions, modifications, corrections, deletions) from the previous amendment were made. This was done as a con

8、venience only and the Government assumes no liability whatsoever for any inaccuracies in these notations. Bidders and contractors are cautioned to evaluate the requirements of this document based on the entire content irrespective of the marginal notations and relationship to the last previous amendment. The margins of this amendment are marked with an asterisk or Custodian: Army-AR 2 Preparing activity: Army-AR ( Pro j ec t 13 1 5 - AE 7 9 1 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-