ANSI INCITS ISO IEC 12087-5 CORR 2-2002 Information technology - Computer graphics and image processing - Image Processing and Interchange (IPI) Functional specification - Part 5 B.pdf

《ANSI INCITS ISO IEC 12087-5 CORR 2-2002 Information technology - Computer graphics and image processing - Image Processing and Interchange (IPI) Functional specification - Part 5 B.pdf》由会员分享，可在线阅读，更多相关《ANSI INCITS ISO IEC 12087-5 CORR 2-2002 Information technology - Computer graphics and image processing - Image Processing and Interchange (IPI) Functional specification - Part 5 B.pdf（4页珍藏版）》请在麦多课文档分享上搜索。

1、 INCITS/ISO/IEC 12087-5:1998/COR2:20022010 (ISO/IEC 12087-5/Cor2:2002, IDT) Information technology - Computer graphics and image processing - Image Processing and Interchange (IPI) Functional specification - Part 5: Basic Image Interchange Format (BIIF) - Corrigendum Reaffirmed as INCITS/ISO/IEC 120

2、87-5:1998/COR 2:2002 R2015INCITS/ISO/IEC 12087-5:1998/COR2:20022010 PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobes licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installe

3、d on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobes licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products

4、 used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event that a problem relating to it is found, plea

5、se inform the Central Secretariat at the address given below. Adopted by INCITS (InterNational Committee for Information Technology Standards) as an American National Standard. Date of ANSI Approval: 7/15/2010 Published by American National Standards Institute, 25 West 43rd Street, New York, New Yor

6、k 10036 Copyright 2010 by Information Technology Industry Council (ITI). All rights reserved. These materials are subject to copyright claims of International Standardization Organization (ISO), International Electrotechnical Commission (IEC), American National Standards Institute (ANSI), and Inform

7、ation Technology Industry Council (ITI). Not for resale. No part of this publication may be reproduced in any form, including an electronic retrieval system, without the prior written permission of ITI. All requests pertaining to this standard should be submitted to ITI, 1101 K Street NW, Suite 610,

8、 Washington DC 20005. Printed in the United States of America ii ITIC 2010 All rights reserved ICS 35.140 Ref. No. ISO/IEC 12087-5:1998/Cor.2:2002(E) ISO/IEC 2002 All rights reserved Printed in Switzerland INTERNATIONAL STANDARD ISO/IEC 12087-5:1998 TECHNICAL CORRIGENDUM 2 Published 2002-04-01 INTER

9、NATIONAL ORGANIZATION FOR STANDARDIZATION ORGANISATION INTERNATIONALE DE NORMALISATIONINTERNATIONAL ELECTROTECHNICAL COMMISSION COMMISSION LECTROTECHNIQUE INTERNATIONALEInformation technology Computer graphics and image processing Image Processing and Interchange (IPI) Functional specification Part

10、5: Basic Image Interchange Format (BIIF) TECHNICAL CORRIGENDUM 2 Technologies de linformation Infographie et traitement de limage Spcification fonctionnelle pour le traitement de limage et lchange (IPI) Partie 5: Format dchange de limage de base (BIIF) RECTIFICATIF TECHNIQUE 2 Technical Corrigendum

11、2 to International Standard ISO/IEC 12087-5:1998 was prepared by Joint Technical Committee ISO/IEC JTC 1, Information technology, Subcommittee SC 24, Computer graphics and image processing. Page 39, Table 4 The calculation for total length of Block Mask Records in these two fields is only correct fo

12、r IMODE S. The calculation for IMODEs B, P and R is missing. For Field BMRLNTH, replace the third sentence with the following: “For IMODEs B, P and R the total length of the Block Mask Records is equal to BMRLNTH x NBPR x NBPC . For IMODE S the total length of the Block Mask Records is equal to BMRL

13、NTH x NBPR x NBPC x NBANDS. ISO/IEC 12087-5:1998/Cor.2:2002(E) 2 ISO/IEC 2002 All rights reservedFor Field TMRLNTH, replace the third sentence with the following: For IMODEs B, P and R the total length of the Block Mask Records is equal to TMRLNTH x NBPR x NBPC. For IMODE S the total length of the Block Mask Records is equal to TMRLNTH x NBPR x NBPC x NBANDS.