ANSI ANSLG C78.60432.3-2007 Incandescent Lamps - Safety Specifications - Part III Tungsten Halogen Lamps (non vehicle)《白炽灯.安全规范.第III部分 卤素电灯(非车辆用)》.pdf

《ANSI ANSLG C78.60432.3-2007 Incandescent Lamps - Safety Specifications - Part III Tungsten Halogen Lamps (non vehicle)《白炽灯.安全规范.第III部分 卤素电灯(非车辆用)》.pdf》由会员分享，可在线阅读，更多相关《ANSI ANSLG C78.60432.3-2007 Incandescent Lamps - Safety Specifications - Part III Tungsten Halogen Lamps (non vehicle)《白炽灯.安全规范.第III部分 卤素电灯(非车辆用)》.pdf（7页珍藏版）》请在麦多课文档分享上搜索。

1、 ANSI_ANSLG C78.60432:3-2007 Revision and Redesignation of ANSI_IEC C78.60432:3-2004 American National Standard For Electric Lamps Incandescent Lamps Safety Specifications Part 3: Tungsten Halogen Lamps (non-vehicle) Copyright National Electrical Manufacturers Association Provided by IHS under licen

2、se with NEMANot for ResaleNo reproduction or networking permitted without license from IHS-,-,-Copyright National Electrical Manufacturers Association Provided by IHS under license with NEMANot for ResaleNo reproduction or networking permitted without license from IHS-,-,-ANSI_ANSLG C78.60432:32007

3、Revision and Redesignation of ANSI_IEC C78.60432:3-2004 American National Standard Approved: October 31, 2007 Secretariat: ANSLG for electric lamps Incandescent Lamps Safety Specifications Part 3 : Tungsten halogen lamps (non-vehicle) Copyright 2007 by American National Standard Lighting Group Page

4、1 of 5 Copyright National Electrical Manufacturers Association Provided by IHS under license with NEMANot for ResaleNo reproduction or networking permitted without license from IHS-,-,-ANSI_ANSLG C78.60432:32007 Revision and Redesignation of ANSI_IEC C78.60432:3-2004 American National Standard Appro

5、val of an American National Standard requires verification by ANSI that the requirements for due process, consensus, and other criteria for approval have been met by the standards developer. An American National Standard implies a consensus of those substantially concerned with its scope and provisi

6、ons. Consensus is established when, in the judgment of the ANSI Board of Standards Review, substantial agreement has been reached by directly and materially affected interests. Substantial agreement means much more than a simple majority, but not necessarily unanimity. Consensus requires that all vi

7、ews and objections be considered, and that a concerted effort be made toward their resolution. The existence of an American National Standard does not in any respect preclude anyone, whether s/he has approved the standard or not, from manufacturing, marketing, purchasing, or using products, processe

8、s, or procedures not conforming to the standards. It is intended as a guide to aid the manufacturer, the consumer, and the general public. The American National Standards Institute does not develop standards and will in no circumstances give an interpretation of any American National Standard. Moreo

9、ver, no person shall have the right or authority to issue an interpretation of an American National Standard in the name of the American National Standards Institute. Requests for interpretations should be addressed to the Committee Secretariat referred to on the title page. CAUTION NOTICE: This Ame

10、rican National Standard may be revised or withdrawn at any time. The procedures of the American National Standards Institute require that action be taken periodically to reaffirm, revise, or withdraw this standard. Purchasers of American National Standards may receive current information on all stan

11、dards by calling or writing the American National Standards Institute. Copyright 2007 by American National Standard Lighting Group All rights reserved. No part of this publication may be reproduced in any form, in an electronic retrieval system or otherwise, without prior written permission of the p

12、ublisher. Printed in the United States of America Copyright 2007 by American National Standard Lighting Group Page 2 of 5 2Copyright National Electrical Manufacturers Association Provided by IHS under license with NEMANot for ResaleNo reproduction or networking permitted without license from IHS-,-,

13、-ANSI_ANSLG C78.60432:32007 Revision and Redesignation of ANSI_IEC C78.60432:3-2004 Foreword (This foreword is not part of ANSI_ANSLG C78.60432:3-2007) Suggestions for improvement of this standard should be submitted to the Secretariat C78, American National Standard Lighting Group, 1300 North 17th

14、Street, Suite 1752, Rosslyn, VA 22209. This standard was processed and approved by Accredited Standards Committee on Electric Lamps, C78, and its Work Group, C78 WG 01. Work Group approval of the standard does not necessarily imply that all work group members voted for that approval. In the case of

15、this standard, an IEC standard is being adopted as a Nationally Acknowledged International Standard with specific deviations for use in the United States. Chapter 1 describes the deviations. Chapter 2 provides a reference to the version of the IEC standard being adopted. Information concerning appro

16、val of this standard is based on the documents listed in the table below. Changes since 2004 version of this standard: Redesignated from ANSI_IEC to ANSI_ANSLG to conform to IEC Guide 21-2005 Section 1 Section 4 CDV RV Revision CDV C78(1)_4234 RV 78(1)_4235 Important Patent Disclaimer It is possible

17、 that some of the elements of this document may be the subject of patent rights. When this document was approved for publication, ANSLG did not know of any patent applications, patents pending, or existing patents. ANSLG shall not be held responsible for identifying any or all such patent rights. Co

18、pyright 2007 by American National Standard Lighting Group Page 3 of 5 3Copyright National Electrical Manufacturers Association Provided by IHS under license with NEMANot for ResaleNo reproduction or networking permitted without license from IHS-,-,-ANSI_ANSLG C78.60432:32007 Revision and Redesignati

19、on of ANSI_IEC C78.60432:3-2004 Chapter 1 United States of Americas Deviations to IEC 60432-3: 2002 including amendment 1: 2005 1. Add the following to Clause 2, Normative references: ANSI_ANSLG C81.61-2006 Electrical lamp bases ANSI_ANSLG C81.63-2006 Gauges for electric lamp bases and lampholders A

20、NSI C81.64-2005 Guidelines and general information for electrical lamp bases, lampholders, and gauges ANSI C78.260-2002 Tubular tungsten-halogen lamps physical characteristics Alternate standards may be substituted for the corresponding IEC standard as listed here. IEC 60061-1 ANSI_ANSLG C81.61 IEC

21、60061-3 ANSI_ANSLG C81.63 IEC 60061-4 ANSI_ANSLG C81.64 IEC 60357 ANSI C78.260 At the time of publication, the editions indicated were valid. All standards are subject to revision, and parties to agreements based on this American National Standard are encouraged to investigate the possibility of app

22、lying the most recent editions. 2. In Annex C: C.4 The marking requirements of 60598-1 do not apply. C.5 UL 1598 restricts such holders to 30 volts or less. C7.1 This fusing is not a luminaire requirement. 3. In Annex E: The referenced IEC standards may not be adopted in the U.S.A. The bulb wall tem

23、perature may be measured by appropriate thermocouple or infrared methods. 4. Add to Bibliography: UL 1598 Luminaires Note: Some of the standards listed in this bibliography have not been adopted in the U.S.A. Copyright 2007 by American National Standard Lighting Group Page 4 of 5 4Copyright National

24、 Electrical Manufacturers Association Provided by IHS under license with NEMANot for ResaleNo reproduction or networking permitted without license from IHS-,-,-ANSI_ANSLG C78.60432:32007 Revision and Redesignation of ANSI_IEC C78.60432:3-2004 Chapter 2 IEC 60432-3: 2002 including amendment 1: 2005 I

25、ncandescent Lamps Safety Specifications Part 3: Tungsten halogen lamps (non-vehicle) The reference IEC standard is not included in this document and must be obtained separately. IEC standards are available through the US National Committee of ANSI or IEC. This information is offered for your conveni

26、ence. American National Standards Institute Attn: “eStandard Store” 25 West 42ndStreet, 4thFloor New York, NY 10036 Or by calling 212 642-4900 during normal business hours. It may also be purchased electronically at the following URL www.ansi.org Or http:/webstore.ansi.org/ansidocstore/default.asp Copyright 2007 by American National Standard Lighting Group Page 5 of 5 5Copyright National Electrical Manufacturers Association Provided by IHS under license with NEMANot for ResaleNo reproduction or networking permitted without license from IHS-,-,-