AECMA PREN 4435-2009 Aerospace series Rivets solid 100 degrees countersunk normal head in heat resisting nickel base alloy NI-PH2301 (Hastelloy X) inch based series Edition P 1《航空航.pdf

《AECMA PREN 4435-2009 Aerospace series Rivets solid 100 degrees countersunk normal head in heat resisting nickel base alloy NI-PH2301 (Hastelloy X) inch based series Edition P 1《航空航.pdf》由会员分享，可在线阅读，更多相关《AECMA PREN 4435-2009 Aerospace series Rivets solid 100 degrees countersunk normal head in heat resisting nickel base alloy NI-PH2301 (Hastelloy X) inch based series Edition P 1《航空航.pdf（1页珍藏版）》请在麦多课文档分享上搜索。

1、 ASD STANDARD NORME ASD ASD NORM prEN 4435 Edition P 1 April 2009 PUBLISHED BY THE AEROSPACE AND DEFENCE INDUSTRIES ASSOCIATION OF EUROPE - STANDARDIZATIONAvenue de Tervuren, 270 - B-1150 Brussels - Tel. + 32 2 775 8126 - Fax. + 32 2 775 8131 - www.asd-stan.orgICS: Descriptors: ENGLISH VERSION Aeros

2、pace series Rivets, solid, 100 countersunk normal head, in heat resisting nickel base alloy NI-PH2301 (Hastelloy X), inch based series Srie arospatiale Rivets ordinaires, tte fraise 100 normale, en alliage rsistant chaud base de nickel NI-PH2301 (Hastelloy X), srie base inches Luft- und Raumfahrt Vo

3、llniete, mit 100 normalem Senkkopf, aus hochwarmfester Nickelbasislegierung NI-PH2301 (Hastelloy X), Zoll-Reihe This “Aerospace Series“ Prestandard has been drawn up under the responsibility of ASD-STAN (The AeroSpace and Defence Industries Association of Europe - Standardization). It is published f

4、or the needs of the European Aerospace Industry. It has been technically approved by the experts of the concerned Domain following member comments. Subsequent to the publication of this Prestandard, the technical content shall not be changed to an extent that interchangeability is affected, physical

5、ly or functionally, without re-identification of the standard. After examination and review by users and formal agreement of ASD-STAN, it will be submitted as a draft European Standard (prEN) to CEN (European Committee for Standardization) for formal vote and transformation to full European Standard

6、 (EN). The CEN national members have then to implement the EN at national level by giving the EN the status of a national standard and by withdrawing any national standards conflicting with the EN. Edition approved for publication 30 April 2009 Comments should be sent within six months after the date of publication to ASD-STAN Mechanical Domain Copyright 2009 by ASD-STAN Copyright ASD-STAN Provided by IHS under license with AECMA Not for ResaleNo reproduction or networking permitted without license from IHS-,-,-