BS ISO 860-2008 en_2755 Terminology work - Harmonization of concepts and terms《术语工作.概念和术语的统一》.pdf

《BS ISO 860-2008 en_2755 Terminology work - Harmonization of concepts and terms《术语工作.概念和术语的统一》.pdf》由会员分享，可在线阅读，更多相关《BS ISO 860-2008 en_2755 Terminology work - Harmonization of concepts and terms《术语工作.概念和术语的统一》.pdf（26页珍藏版）》请在麦多课文档分享上搜索。

1、BRITISH STANDARD BS ISO 860:2007 Terminology work Harmonization of concepts and terms ICS 01.020 BS ISO 860:2007 This British Standard was published under the authority of the Standards Policy and Strategy Committee on 29 February 2008 BSI 2008 ISBN 978 0 580 61273 2 National foreword This British S

2、tandard is the UK implementation of ISO 860:2007. The UK participation in its preparation was entrusted to Technical Committee TS/1, Terminology. A list of organizations represented on this committee can be obtained on request to its secretary. This publication does not purport to include all the ne

3、cessary provisions of a contract. Users are responsible for its correct application. Compliance with a British Standard cannot confer immunity from legal obligations. Amendments/corrigenda issued since publication Date Comments Reference number ISO 860:2007(E)INTERNATIONAL STANDARD ISO 860 Third edi

4、tion 2007-11-15 Terminology work Harmonization of concepts and terms Travaux terminologiques Harmonisation des concepts et des termesBS ISO 860:2007ii iii Contents Page Foreword iv Introduction v 1 Scope . 1 2 Normative references . 1 3 Terms and definitions. 1 4 Harmonization of concepts and concep

5、t systems 2 4.1 Concept variation 2 4.2 Feasibility study 2 4.3 Harmonization procedure 3 5 Harmonization of concept definitions 11 6 Harmonization of terms 11 6.1 General. 11 6.2 Term selection. 11 6.3 Establishment of equivalents, synonyms and term variants. 13 6.4 Terminology planning 14 Annex A

6、(informative) Concept harmonization process 15 Bibliography . 17 BS ISO 860:2007iv Foreword ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO member bodies). The work of preparing International Standards is normally carried out throu

7、gh ISO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. ISO collabora

8、tes closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2. The main task of technical committees is to prepare International Standar

9、ds. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of th

10、is document may be the subject of patent rights. ISO shall not be held responsible for identifying any or all such patent rights. ISO 860 was prepared by Technical Committee ISO/TC 37, Terminology and other language and content resources, Subcommittee SC 1, Principles and methods. This third edition

11、 cancels and replaces the second edition (ISO 860:1996), which has been technically revised. BS ISO 860:2007v Introduction 0.1 Overview In spite of all the efforts made to coordinate terminologies as they develop, it is inevitable that overlapping and inconsistent terminologies will continue to be u

12、sed because documents and policies are produced in different contexts. Differences between concepts and misleading similarities at the designation level create barriers to communication. Concepts and terms develop differently in individual languages and language communities, depending on professiona

13、l, technical, scientific, social, economic, linguistic, cultural or other factors. Harmonization is, therefore, desirable because differences between concepts do not necessarily become apparent at the designation level, similarity at the designation level does not necessarily mean that the concepts

14、behind the designations are identical, mistakes occur when a single concept is designated by two synonyms which by error are considered to designate two different concepts. Harmonization starts at the concept level and continues at the term level. It is an integral part of standardization. 0.2 Conve

15、ntions and notation In this International Standard, tree diagrams are used to represent generic concept relations. The following notation is used throughout this International Standard: concepts are indicated by single quotes; designations are in boldface; characteristics are underlined; alpha-2 lan

16、guage codes are in small letters, boldface and italics; country codes are in capital letters; examples are boxed. BS ISO 860:2007blank1 Terminology work Harmonization of concepts and terms 1 Scope This International Standard specifies a methodological approach to the harmonization of concepts, conce

17、pt systems, definitions and terms. This International Standard applies to the development of harmonized terminologies, at either the national or international level, in either a monolingual or a multilingual context. 2 Normative references The following referenced documents are indispensable for the

18、 application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. ISO 704:2000 1) , Terminology work Principles and methods ISO 1087-1:2000 2) , Terminology work Vocabulary Pa

19、rt 1: Theory and application ISO 10241:1992, International terminology standards Preparation and layout 3 Terms and definitions For the purposes of this document, the terms and definitions given in ISO 1087-1 and the following apply. 3.1 concept harmonization activity leading to the establishment of

20、 a correspondence between two or more closely related or overlapping concepts having professional, technical, scientific, social, economic, linguistic, cultural or other differences, in order to eliminate or reduce minor differences between them NOTE The purpose of concept harmonization is to improv

21、e communication. 3.2 concept system harmonization activity leading to the establishment of a correspondence between two or more closely related or overlapping concept systems having professional, technical, scientific, social, economic, linguistic, cultural or other differences, in order to eliminat

22、e or reduce minor differences between them NOTE The purpose of concept system harmonization is to improve communication. 1) Under revision. 2) To be revised. BS ISO 860:20072 3.3 definition harmonization activity leading to the description of a harmonized concept by an intensional definition that re

23、flects the position of the concept in the harmonized concept system 3.4 term harmonization activity leading to the selection of designations for a harmonized concept either in different languages or within the same language NOTE Harmonized terms between different languages are equivalent terms; harm

24、onized terms within the same language are either synonyms or term variants. 3.5 equivalence relation between designations in different languages representing the same concept ISO 1087-1:2000, definition 3.4.21 4 Harmonization of concepts and concept systems 4.1 Concept variation 4.1.1 General Since

25、concepts may vary slightly on account of differences in professional, technical, scientific, social, economic, linguistic, cultural or other environments, the harmonization of specific concepts or concept systems will assist in reducing ambiguity and misunderstanding in communication. Some examples

26、of concept variation are shown in Example 1. 4.1.2 Example 1 Concept variation due to differences in professional, scientific, cultural or socioeconomic environments Differences Example Professional Bachelor degree and licentiate degree in different countries are not exactly the same but are close e

27、nough to be considered equivalent degrees. Scientific word in the field of linguistics varies according to different linguistic theories. Cultural For Europeans, North America includes the US and Canada while in the Americas, North America is the region comprising Canada, the US and Mexico. Socioeco

28、nomic The minimum acceptable standard of living can have different extension within the context of the highly industrialized countries. 4.2 Feasibility study 4.2.1 Preliminary analysis Before conducting concept harmonization, differences and similarities between concepts and concept systems shall be

29、 examined in order to determine the feasibility of harmonization. Preliminary issues will be concerned with whether the concept systems to be harmonized are from the same subject field, the extent to which both contain the same concepts and, if the content is overlapping, whether the harmonization p

30、roject is to be directed towards the area of overlap, or all the concepts in the systems to be harmonized. See Annex A. BS ISO 860:20073 4.2.2 Analysis of the subject field Harmonization is more likely to be possible if the following conditions are met: a) a subset of the terminology of the subject

31、field has already been harmonized; b) the subject field is well established and relatively stable; c) the subject field has a tradition of standardization. 4.2.3 Similarity between concepts Whether the harmonization project will be carried out on concepts and concept systems in one language or acros

32、s languages, a cursory comparison of some key concepts to be harmonized in each concept system shall be performed. This analysis shall determine: a) which characteristics the concepts of each concept system have in common 1) within a language, 2) across languages; b) which characteristics of the con

33、cepts differ from one concept system to another 1) within a language, 2) across languages; c) which characteristics are essential to each key concept. Successful concept harmonization is more likely to be possible if the following conditions are met: the concepts are closely related to each other an

34、d have common characteristics; the essential characteristics are the same or similar and reflect a similar perspective within the particular professional, technical, scientific, social, economic, linguistic, cultural or other environment; a correspondence can be established between the key concepts

35、in each concept. 4.3 Harmonization procedure 4.3.1 Selection of concepts The scope of the harmonization project will determine the concepts and concept systems to be harmonized. 4.3.2 Comparison of concept systems All relevant concept systems shall be examined. Ideally, a new set of concept systems,

36、 containing all the material from all the sources to be harmonized, will be produced. However, there may be divergences in the criteria of subdivision which establish the need for separate displays. In this case, the point of divergence can be identified. BS ISO 860:20074 The comparative analysis of

37、 the different concept systems shall take account of the following: a) the number of concepts included; b) the relationships between concepts; c) the depth of structuring; d) the criteria of subdivision used to develop the concept system. 4.3.3 Harmonized concept system maintenance Having assembled

38、all relevant material into a set of concept systems for the purposes of overall control, it will be necessary to decide whether to retain them in this form for display purposes or to disaggregate them for particular applications. Another approach is to give the concept systems in their complete form

39、 even if only part is relevant to the specific context, distinguishing the relevant concepts, e.g. by emboldening or italics. Depending on the scope of the harmonization project, it shall be necessary to decide whether a) a harmonized concept system will be produced after harmonization has successfu

40、lly been carried out, or b) each concept system will be adapted to reflect the result of harmonization. 4.3.4 Harmonization of single concepts 4.3.4.1 General Concepts shall be analysed by comparing their characteristics and not their designations. In practice, characteristics shall be found in the

41、definition and sometimes in the explanatory note provided for each concept belonging to the concept system. Definitions shall be collected from reliable sources including all available expertise within the subject field. After completing a comparative analysis of the definitions for one concept, it

42、shall be determined which of the conditions described in 4.3.4.2 to 4.3.4.5 applies. 4.3.4.2 Concepts which are identical 4.3.4.2.1 General The concepts in the different concept systems are exactly the same and their characteristics coincide. In this case, there is no need for concept harmonization.

43、 See Example 2. However, term harmonization may be necessary at a later stage to select the designation in each language, and to establish term equivalence between languages and synonymy and term variation within each language. BS ISO 860:20075 4.3.4.2.2 Example 2 Identical concepts A concept in a m

44、onolingual and a bilingual context for which there is no need for harmonization. Harmonization within a language: en proenzyme 1. the precursor of an enzyme requiring proteolysis to render it active (source: Stedmans Medical dictionary) 2. an inactive precursor of an enzyme that can be converted to

45、the active enzyme by proteolysis (source: Dorlands Illustrated M.D.) 3. an inactive enzyme precursor that is converted to the active form of the enzyme by proteolitic cleavage source: Singleton, P. and Sainsbury, D. (1996): Dictionary of microbiology and molecular biology, Chichester / Toronto, Wile

46、y Characteristics used to define the concept: precursor of an enzyme (1) / inactive precursor of an enzyme (2, 3) requiring proteolysis to render it active (1, 2) / converted to an active enzyme by proteolitic cleavage (3) Regarding the difference found in the first characteristic precursor of an en

47、zyme (1) and inactive precursor of an enzyme (2, 3), the solution lies within the context of the second characteristic requiring proteolysis to render it active (1, 2) / converted into an active enzyme by proteolitic cleavage (3), as it can be implied that before the process of proteolysis / proteol

48、itic cleavage the precursor of the enzyme was not active. After the analysis of the possible difference between proteolysis and proteolytic cleavage (proteolysis: the cleavage of proteins by proteases; proteolytic cleavage: the process of breaking proteins by proteases), it can be concluded that the

49、re is no difference. Therefore, the same characteristics are used to define the concept of proenzyme; thus, there is no need for concept harmonization. Harmonization across two languages: en proenzyme 1. the precursor of an enzyme requiring proteolysis to render it active (source: Stedmans Medical dictionary) 2. an inactive precursor of an enzyme that can be converted to the active enzyme by proteolysis (source: