IEEE C63 4-2014 en American National Standard for Methods of Measurement of Radio-Noise Emissions from Low-Voltage Electrical and Electronic Equipment in the Ra.pdf

《IEEE C63 4-2014 en American National Standard for Methods of Measurement of Radio-Noise Emissions from Low-Voltage Electrical and Electronic Equipment in the Ra.pdf》由会员分享，可在线阅读，更多相关《IEEE C63 4-2014 en American National Standard for Methods of Measurement of Radio-Noise Emissions from Low-Voltage Electrical and Electronic Equipment in the Ra.pdf（170页珍藏版）》请在麦多课文档分享上搜索。

1、 Accredited Standards Committee C63 Electromagnetic Compatibility C63ANSI C63.4-2014 (Revision of ANSI C63.4-2009) American National Standard for Methods of Measurement of Radio-Noise Emissions from Low-Voltage Electrical and Electronic Equipment in the Range of 9 kHz to 40 GHz Accredited Standards

2、Committee C63Electromagnetic Compatibility Accredited by the American National Standards Institute Secretariat Institute of Electrical and Electronics Engineers, Inc. Approved 13 June 2014 American National Standards Institute Abstract: U.S. consensus standard methods, instrumentation, and facilitie

3、s for measurement of radio-frequency (RF) signals and noise emitted from electrical and electronic devices in the frequency range of 9 kHz to 40 GHz are specified. This standard does not include generic or product-specific emission limits. Where possible, the specifications herein are harmonized wit

4、h other national and international standards used for similar purposes. Keywords: ANSI C63.4, conducted emission testing, conducting ground plane, digital equipment, electric field measurement, line impedance stabilization network, low-voltage electrical equipment, low-voltage electronic equipment,

5、magnetic field measurement, normalized site attenuation, radiated emission testing, radio-noise emissions, radio-noise power, site attenuation, unintentional radiators The Institute of Electrical and Electronics Engineers, Inc. 3 Park Avenue, New York, NY 10016-5997, USA Copyright 2014 by The Instit

6、ute of Electrical and Electronics Engineers, Inc. All rights reserved. Published 20 June 2014. Printed in the United States of America. IEEE is a registered trademark in the U.S. Patent (978) 750-8400. Permission to photocopy portions of any individual standard for educational classroom use can also

7、 be obtained through the Copyright Clearance Center. Errata Users are encouraged to check the IEEE Errata URL (http:/standards.ieee.org/findstds/errata/index.html), and the one for ASC C63at (http:/www.c63.org/explanations_interpretations_request.htm, for errata periodically. Interpretations (ASC C6

8、3standards) Current interpretations are essential to the understanding of all ASC C63standards. To assist in the meanings of requirements, informative interpretations are available at the following URL: (http:/www.c63.org/standards_development.htm). Users are cautioned that, although interpretations

9、 do not and can not change the requirements of a standard, they serve to clarify the meanings of requirements. All interpretations are informative rather than normative, until such time as the standard is revised (consistent with ASC C63ANSI-accredited operating procedures) to incorporate the interp

10、retation as a normative requirement. Important Notices and Disclaimers Concerning IEEE Standards Documents IEEE documents are made available for use subject to important notices and legal disclaimers. These notices and disclaimers, or a reference to this page, appear in all standards and may be foun

11、d under the heading “Important Notice” or “Important Notices and Disclaimers Concerning IEEE Standards Documents.” Notice and Disclaimer of Liability Concerning the Use of IEEE Standards Documents IEEE Standards documents (standards, recommended practices, and guides), both full-use and trial-use, a

12、re developed within IEEE Societies and the Standards Coordinating Committees of the IEEE Standards Association (“IEEE-SA”) Standards Board. IEEE (“the Institute”) develops its standards through a consensus development process, approved by the American National Standards Institute (“ANSI”), which bri

13、ngs together volunteers representing varied viewpoints and interests to achieve the final product. Volunteers are not necessarily members of the Institute and participate without compensation from IEEE. While IEEE administers the process and establishes rules to promote fairness in the consensus dev

14、elopment process, IEEE does not independently evaluate, test, or verify the accuracy of any of the information or the soundness of any judgments contained in its standards. IEEE does not warrant or represent the accuracy or content of the material contained in its standards, and expressly disclaims

15、all warranties (express, implied and statutory) not included in this or any other document relating to the standard, including, but not limited to, the warranties of: merchantability; fitness for a particular purpose; non-infringement; and quality, accuracy, effectiveness, currency, or completeness

16、of material. In addition, IEEE disclaims any and all conditions relating to: results; and workmanlike effort. IEEE standards documents are supplied “AS IS” and “WITH ALL FAULTS.” Use of an IEEE standard is wholly voluntary. The existence of an IEEE standard does not imply that there are no other way

17、s to produce, test, measure, purchase, market, or provide other goods and services related to the scope of the IEEE standard. Furthermore, the viewpoint expressed at the time a standard is approved and issued is subject to change brought about through developments in the state of the art and comment

18、s received from users of the standard. In publishing and making its standards available, IEEE is not suggesting or rendering professional or other services for, or on behalf of, any person or entity nor is IEEE undertaking to perform any duty owed by any other person or entity to another. Any person

19、 utilizing any IEEE Standards document, should rely upon his or her own independent judgment in the exercise of reasonable care in any given circumstances or, as appropriate, seek the advice of a competent professional in determining the appropriateness of a given IEEE standard. IN NO EVENT SHALL IE

20、EE BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO: PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, ST

21、RICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE PUBLICATION, USE OF, OR RELIANCE UPON ANY STANDARD, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE AND REGARDLESS OF WHETHER SUCH DAMAGE WAS FORESEEABLE. Translations The IEEE consensus development process i

22、nvolves the review of documents in English only. In the event that an IEEE standard is translated, only the English version published by IEEE should be considered the approved IEEE standard. Official statements A statement, written or oral, that is not processed in accordance with the IEEE-SA Standa

23、rds Board Operations Manual shall not be considered or inferred to be the official position of IEEE or any of its committees and shall not be considered to be, or be relied upon as, a formal position of IEEE. At lectures, symposia, seminars, or educational courses, an individual presenting informati

24、on on IEEE standards shall make it clear that his or her views should be considered the personal views of that individual rather than the formal position of IEEE. Comments on standards Comments for revision of IEEE Standards documents are welcome from any interested party, regardless of membership a

25、ffiliation with IEEE. However, IEEE does not provide consulting information or advice pertaining to IEEE Standards documents. Suggestions for changes in documents should be in the form of a proposed change of text, together with appropriate supporting comments. Since IEEE standards represent a conse

26、nsus of concerned interests, it is important that any responses to comments and questions also receive the concurrence of a balance of interests. For this reason, IEEE and the members of its societies and Standards Coordinating Committees are not able to provide an instant response to comments or qu

27、estions except in those cases where the matter has previously been addressed. For the same reason, IEEE does not respond to interpretation requests. Any person who would like to participate in revisions to an IEEE standard is welcome to join the relevant IEEE working group. Comments on standards sho

28、uld be submitted to the following address: Secretary, IEEE-SA Standards Board 445 Hoes Lane Piscataway, NJ 08854 USA Laws and regulations Users of IEEE Standards documents should consult all applicable laws and regulations. Compliance with the provisions of any IEEE Standards document does not imply

29、 compliance to any applicable regulatory requirements. Implementers of the standard are responsible for observing or referring to the applicable regulatory requirements. IEEE does not, by the publication of its standards, intend to urge action that is not in compliance with applicable laws, and thes

30、e documents may not be construed as doing so. Copyrights IEEE draft and approved standards are copyrighted by IEEE under U.S. and international copyright laws. They are made available by IEEE and are adopted for a wide variety of both public and private uses. These include both use, by reference, in

31、 laws and regulations, and use in private self-regulation, standardization, and the promotion of engineering practices and methods. By making these documents available for use and adoption by public authorities and private users, IEEE does not waive any rights in copyright to the documents. Photocop

32、ies Subject to payment of the appropriate fee, IEEE will grant users a limited, non-exclusive license to photocopy portions of any individual standard for company or organizational internal use or individual, non-commercial use only. To arrange for payment of licensing fees, please contact Copyright

33、 Clearance Center, Customer Service, 222 Rosewood Drive, Danvers, MA 01923 USA; +1 978 750 8400. Permission to photocopy portions of any individual standard for educational classroom use can also be obtained through the Copyright Clearance Center. Updating of IEEE Standards documents Users of IEEE S

34、tandards documents should be aware that these documents may be superseded at any time by the issuance of new editions or may be amended from time to time through the issuance of amendments, corrigenda, or errata. An official IEEE document at any point in time consists of the current edition of the d

35、ocument together with any amendments, corrigenda, or errata then in effect. Every IEEE standard is subjected to review at least every ten years. When a document is more than ten years old and has not undergone a revision process, it is reasonable to conclude that its contents, although still of some

36、 value, do not wholly reflect the present state of the art. Users are cautioned to check to determine that they have the latest edition of any IEEE standard. In order to determine whether a given document is the current edition and whether it has been amended through the issuance of amendments, corr

37、igenda, or errata, visit the IEEE-SA Website at http:/ieeexplore.ieee.org/xpl/standards.jsp or contact IEEE at the address listed previously. For more information about the IEEE SA or IEEEs standards development process, visit the IEEE-SA Website at http:/standards.ieee.org. Errata Errata, if any, f

38、or all IEEE standards can be accessed on the IEEE-SA Website at the following URL: http:/standards.ieee.org/findstds/errata/index.html. Users are encouraged to check this URL for errata periodically. Patents Attention is called to the possibility that implementation of this standard may require use

39、of subject matter covered by patent rights. By publication of this standard, no position is taken by the IEEE with respect to the existence or validity of any patent rights in connection therewith. If a patent holder or patent applicant has filed a statement of assurance via an Accepted Letter of As

40、surance, then the statement is listed on the IEEE-SA Website at http:/standards.ieee.org/about/sasb/patcom/patents.html. Letters of Assurance may indicate whether the Submitter is willing or unwilling to grant licenses under patent rights without compensation or under reasonable rates, with reasonab

41、le terms and conditions that are demonstrably free of any unfair discrimination to applicants desiring to obtain such licenses. Essential Patent Claims may exist for which a Letter of Assurance has not been received. The IEEE is not responsible for identifying Essential Patent Claims for which a lic

42、ense may be required, for conducting inquiries into the legal validity or scope of Patents Claims, or determining whether any licensing terms or conditions provided in connection with submission of a Letter of Assurance, if any, or in any licensing agreements are reasonable or non-discriminatory. Us

43、ers of this standard are expressly advised that determination of the validity of any patent rights, and the risk of infringement of such rights, is entirely their own responsibility. Further information may be obtained from the IEEE Standards Association. vii Copyright 2014 IEEE. All rights reserved

44、. Participants At the time this standard was published, Accredited Standards Committee C63Electromagnetic Compatibility had the following membership: Daniel Hoolihan, Chair Dan Sigouin, Vice Chair Jerry D. Ramie, Secretary Patricia Roder, Secretariat Organization Represented Name of Representative A

45、lcatelLucent Dheena Moongilan American Council of Independent Laboratories (ACIL) . Harry H. Hodes . John Repella (Alt.) American Radio Relay League (ARRL) Edward F. Hare . Kermit Carlson (Alt.) Apple, Inc. Manjit Walia Indrandil Sen (Alt.) Blackberry Corporation . Masud Attayi Daoud Attayi (Alt.) B

46、ureau Veritas . Jonathan Stewart . Mairaj Hussain (Alt.) Cisco Systems . Andy Griffin Dave Case (Alt.) Dell Inc. . Richard Worley ETS-Lindgren Zhong Chen Michael Foegelle (Alt.) Federal Communications Commission (FCC) William Hurst Food and Drug Administration (FDA) Jeffrey L. Silberberg Donald M. W

47、itters (Alt.) Industry Canada . Dan Sigouin Information Technology Industry Council (ITIC) John Hirvela . Joshua Rosenberg (Alt.) IEEE-Electromagnetic Compatibility Society (EMCS) . Andy Drozd Liberty Labs Mike Howard Brandt Langer (Alt.) Motorola Mobility Tom Knipple Motorola Solutions William (Mac

48、) Elliot Deanna Zakharia (Alt.) National Institute of Standards and Technology (NIST) Dennis Camell . William Young (Alt.) Northwest EMC Dean Ghizzone . Greg Kiemel (Alt.) PCTEST Engineering Laboratory Greg Snyder Dennis Ward (Alt.) Society of Automotive Engineers (SAE) . Poul Andersen . Gary Fenica

49、l (Alt.) Sony Ericsson Mobile Communications . Mats Hansson Telecommunication Certification Body (TCB) Council Art Wall William Stumpf (Alt.) Telecommunications Industry Association (TIA) . Stephen Whitesell TUV SUD America, Inc. . Chip Fleury . David Schaefer (Alt.) Underwriters Laboratories (UL) . Robert DeLisi . Jeffrey Moser (Alt.) U.S. Department of DefenseJoint Spectrum Center . Marcus Shellman Michael Duncanson (Alt.) U.S. Department of the NavySPAWAR . Chris Dilay David Southworth (Alt.) viii Copyright 2014 IEEE. All rights reserved. Individual Members