IEEE C63 17-2013 en American National Standard Methods of Measurement of the Electromagnetic and Operational Compatibility of Unlicensed Personal Communications.pdf

《IEEE C63 17-2013 en American National Standard Methods of Measurement of the Electromagnetic and Operational Compatibility of Unlicensed Personal Communications.pdf》由会员分享，可在线阅读，更多相关《IEEE C63 17-2013 en American National Standard Methods of Measurement of the Electromagnetic and Operational Compatibility of Unlicensed Personal Communications.pdf（74页珍藏版）》请在麦多课文档分享上搜索。

1、 American National Standard Methods of Measurement of the Electromagnetic and Operational Compatibility of Unlicensed Personal Communications Services (UPCS) Devices Accredited by the American National Standards Institute IEEE 3 Park Avenue New York, NY 10016-5997 USA Accredited Standards Committee

2、C63 Electromagnetic Compatibility ANSI C63.17-2013C63ANSI C63.17-2013 American National Standard Methods of Measurement of the Electromagnetic and Operational Compatibility of Unlicensed Personal Communications Services (UPCS) Devices Accredited Standards Committee C63 Electromagnetic Compatibility

3、accredited by the American National Standards Institute Secretariat Institute of Electrical and Electronics Engineers, Inc. Approved 12 August 2013 American National Standards Institute Abstract: Specific test procedures for verifying the compliance of unlicensed personal communications services (UP

4、CS) devices (including wideband voice and data devices) are established including applicable regulatory requirements regarding radio-frequency emission levels and spectrum access procedures. Keywords: ANSI C63.17, etiquette, personal communications, RF emissions, spectrum access, unlicensed devices,

5、 UPCS, wideband The Institute of Electrical and Electronics Engineers, Inc. 3 Park Avenue, New York, NY 10016-5997, USA Copyright 2013 by The Institute of Electrical and Electronics Engineers, Inc. All rights reserved. Published 9 October 2013. Printed in the United States of America. IEEE is a regi

6、stered trademark in the U.S. Patent (978) 750-8400. Permission to photocopy portions of any individual standard for educational classroom use can also be obtained through the Copyright Clearance Center. Errata and interpretations Users are encouraged to check periodically for errata and interpretati

7、ons at the following URL http:/www.c63.org/explanations_interpretations_request.htm from the ASC C63Website. Notice to users Laws and regulations Users of IEEE Standards documents should consult all applicable laws and regulations. Compliance with the provisions of any IEEE Standards document does n

8、ot imply compliance to any applicable regulatory requirements. Implementers of the standard are responsible for observing or referring to the applicable regulatory requirements. IEEE does not, by the publication of its standards, intend to urge action that is not in compliance with applicable laws,

9、and these documents may not be construed as doing so. Copyrights This document is copyrighted by the IEEE. It is made available for a wide variety of both public and private uses. These include both use, by reference, in laws and regulations, and use in private self-regulation, standardization, and

10、the promotion of engineering practices and methods. By making this document available for use and adoption by public authorities and private users, the IEEE does not waive any rights in copyright to this document. Updating of IEEE documents Users of IEEE Standards documents should be aware that thes

11、e documents may be superseded at any time by the issuance of new editions or may be amended from time to time through the issuance of amendments, corrigenda, or errata. An official IEEE document at any point in time consists of the current edition of the document together with any amendments, corrig

12、enda, or errata then in effect. In order to determine whether a given document is the current edition and whether it has been amended through the issuance of amendments, corrigenda, or errata, visit the IEEE-SA Website at http:/standards.ieee.org/index.html or contact the IEEE at the address listed

13、previously. For more information about the IEEE Standards Association or the IEEE standards development process, visit IEEE-SA Website at http:/standards.ieee.org/index.html. Errata Errata, if any, for this and all other standards can be accessed at the following URL: http:/standards.ieee.org/findst

14、ds/errata/index.html. Users are encouraged to check this URL for errata periodically. Copyright 2013 IEEE. All rights reserved. ivCopyright 2013 IEEE. All rights reserved. vPatents Attention is called to the possibility that implementation of this guide may require use of subject matter covered by p

15、atent rights. By publication of this guide, no position is taken by the IEEE with respect to the existence or validity of any patent rights in connection therewith. If a patent holder or patent applicant has filed a statement of assurance via an Accepted Letter of Assurance, then the statement is li

16、sted on the IEEE-SA Website http:/standards.ieee.org/about/sasb/patcom/patents.html. Letters of Assurance may indicate whether the Submitter is willing or unwilling to grant licenses under patent rights without compensation or under reasonable rates, with reasonable terms and conditions that are dem

17、onstrably free of any unfair discrimination to applicants desiring to obtain such licenses. Essential Patent Claims may exist for which a Letter of Assurance has not been received. The IEEE is not responsible for identifying Essential Patent Claims for which a license may be required, for conducting

18、 inquiries into the legal validity or scope of Patents Claims, or determining whether any licensing terms or conditions provided in connection with submission of a Letter of Assurance, if any, or in any licensing agreements are reasonable or non-discriminatory. Users of this guide are expressly advi

19、sed that determination of the validity of any patent rights, and the risk of infringement of such rights, is entirely their own responsibility. Further information may be obtained from the IEEE Standards Association. Participants At the time this standard was published, Accredited Standards Committe

20、e C63 Electromagnetic Compatibility had the following membership: Daniel Hoolihan, Chair Jerry Ramie, Secretary Organization Represented Name of Representative American Council of Independent Laboratories (ACIL) .Harry Hodes John Repella (Alt.) Alcatel-Lucent .Dheena Moongilan Apple Manjit Walia Ind

21、randil Sen (Alt.) American Radio Relay League (ARRL).Edward F. Hare Kermit Carlson (Alt.) Bureau Veritas Jonathan Stewart Mairaj Hussain (Alt.) Cisco Systems. Andy Griffin Dave Case (Alt.) Dell Inc. Richard Worley ETS-Lindgren Zhong Chen Michael Foegelle (Alt.) Federal Communications Commission (FCC

22、) William Hurst Food and Drug Administration (FDA) Jeffrey L. Silberberg Donald Witters (Alt.) Industry Canada. Dan Sigouin Information Technology Industry Council (ITIC) .John Hirvela Joshua Rosenberg (Alt.) IEEE-EMCS Andy Drozd Motorola Mobility Tom Knipple Motorola Solutions William Elliott Deann

23、a Zakharia (Alt.) National Institute of Standards and Technology Dennis Camell Northwest EMC.Dean Ghizzone Greg Kiemel (Alt.) PCTest Engineering Laboratory Greg Snyder Dennis Ward (Alt.) Research in Motion (RIM). Masud Attayi Daoud Attayi (Alt.) Society of Automotive Engineers (SAE) Poul Andersen Ga

24、ry Fenical (Alt.) Sony Ericsson Mobile Communications. Mats Hansson Telecommunications Industry Association (TIA). Stephen Whitesell Telecommunications Certification Body (TCB) Council Art Wall Bill Stumpf (Alt.) TV-SD America, Inc.Chip Fleury David Schaefer (Alt.) UL-LLC.Robert DeLisi Jeffrey Moser

25、 (Alt.) U.S. Department of DefenseJoint Spectrum Center. Marcus Shellman Michael Duncanson (Alt.) U.S. Department of the NavySPAWAR Chris Dilay Dave Southworth (Alt.) vi Copyright 2013 IEEE. All rights reserved. vii Copyright 2013 IEEE. All rights reserved. Individual MembersH. Stephen Berger Don He

26、irman Daniel Hoolihan John Lichtig Werner Schaefer Dave Zimmerman Members Emeritus.Warren Kesselman Herbert Mertel Robert Hofmann At the time this standard was completed, ASC C63Subcommittee 7 had the following membership: H. Stephen Berger, Chair Seth Seidman, Vice Chair Joseph Dichoso Chris Dilay

27、Edward F. Hare Daniel Hoolihan William Hurst Dheena Moongilan Jeffrey L. Silberberg Stephen Whitesell Donald WittersAt the time this standard was completed, the ANSI C63Working Group had the following membership: H. Stephen Berger, Chair Steve Cahill, Vice Chair and Technical Editor Dag kerberg Greg

28、ory Czumak Joseph Dichoso William HurstIntroduction This introduction is not part of ANSI C63.17-2013, American National Standard Methods of Measurement of the Electromagnetic and Operational Compatibility of Unlicensed Personal Communications Services (UPCS) Devices. In November 1993, the Federal C

29、ommunications Commission (FCC) invited ANSI C63 “to consider development of standard measurement procedures to support” proposed new provisions to Part 15 of Volume 47 of the Code of Federal Regulations (47CFR15) for unlicensed personal communications services (UPCS) devices.aAt its December 1993 me

30、eting, ANSI C63 established a subcommittee (SC 7) to attempt to develop such standards in cooperation with representatives of the Wireless Information Networks Forum (WINForum) and other interested parties. The standard ANSI C63.17-1998 was the result of the efforts of SC 7. In the Fall of 2004, the

31、 FCC revised provisions of 47CFR15 governing the 1920 MHz to 1930 MHz UPCS band. A working group was formed under the aegis of SC 7 to rewrite ANSI C63.17-1998 to reflect the changes in 47CFR15. This revised standard is, again, the result of the efforts of SC 7. In July of 2012, the FCC released rev

32、ised provisions of 47CFR15 governing the 1920 MHz to 1930 MHz UPCS band. These revisions facilitate the implementation of improved services utilizing this band. A working group was again formed under the aegis of SC 7 to revise ANSI C63.17-2006 to reflect the changes in 47CFR15. This revised standar

33、d is also the result of the efforts of SC 7. a Information on references can be found in Clause 2. viii Copyright 2013 IEEE. All rights reserved. Contents 1. Overview 1 1.1 Scope . 1 1.2 Applications. 2 1.3 Roadmap to the document . 2 2. Normative references 3 3. Definitions, symbols, acronyms, and

34、abbreviations . 3 3.1 Definitions . 3 3.2 Symbols . 6 3.3 Acronyms and abbreviations . 7 4. Radiated and conducted emissions test methodology. 8 4.1 Test facilities and equipment. 9 4.2 Test configurations and setup 10 4.3 Transmitted power and monitoring threshold limits 11 4.4 Limits for radiated

35、and conducted tests . 12 4.5 Conducted measurements of products with identical collocated transmitting and monitoring antennas 13 4.6 Conducted measurements of products with collocated transmitting and monitoring antennas of different types 13 4.7 Conducted measurements of products with arbitrarily

36、placed transmitting and monitoring antennas 13 4.8 Radiated measurements of products with identical collocated transmitting and monitoring antennas 14 4.9 Radiated measurements of products with collocated transmitting and monitoring antennas of different types 15 4.10 Radiated measurements of produc

37、ts with arbitrarily placed transmitting and monitoring antennas 15 4.11 Manufacturers declarations and descriptions 15 5. Measurement instrumentation 16 6. RF measurements . 17 6.1 Emissions tests. 17 6.2 Frequency and time stability 21 7. Monitoring tests 24 7.1 Introduction . 24 7.2 Calibration of

38、 levels. 28 7.3 Threshold limits and channel selection 29 7.4 Threshold and LIC monitoring bandwidth 31 7.5 Reaction time and monitoring interval 33 8. Time and spectrum window access procedure . 34 8.1 Timing for EUTs using control and signaling channel-type transmissions . 35 8.2 Timing for EUTs u

39、sing communications channel-type transmissions. 37 8.3 Duplex connections . 38 8.4 Alternative monitoring interval . 42 ix Copyright 2013 IEEE. All rights reserved. x Copyright 2013 IEEE. All rights reserved. 9. Test report. 42 9.1 Test report contents . 42 9.2 Applicable standards 43 9.3 Equipment

40、units tested. 43 9.4 Test configuration 43 9.5 List of test equipment 43 9.6 Units of measurement 43 9.7 Location of test site 43 9.8 Measurement procedures. 44 9.9 Reporting measurement data . 44 9.10 General and special conditions 44 9.11 Summary of results 44 9.12 Required signatures . 44 9.13 Te

41、st report appendixes. 44 9.14 Test report disposition . 45 Annex A (informative) 47CFR15, Subpart DRules and test cases for UPCS devices 46 Annex B (informative) Radiated and conducted measurement of power output and monitoring thresholds. 53 Annex C (informative) Options for implementing the tests

42、of Clause 7 and Clause 8. 58 American National Standard Methods of Measurement of the Electromagnetic and Operational Compatibility of Unlicensed Personal Communications Services (UPCS) Devices IMPORTANT NOTICE: IEEE Standards documents are not intended to ensure safety, health, or environmental pro

43、tection, or ensure against interference with or from other devices or networks. Implementers of IEEE Standards documents are responsible for determining and complying with all appropriate safety, security, environmental, health, and interference protection practices and all applicable laws and regul

44、ations. This IEEE document is made available for use subject to important notices and legal disclaimers. These notices and disclaimers appear in all publications containing this document and may be found under the heading “Important Notice” or “Important Notices and Disclaimers Concerning IEEE Docum

45、ents.” They can also be obtained on request from IEEE or viewed at http:/standards.ieee.org/IPR/disclaimers.html. 1. Overview 1.1 Scope This standard sets forth uniform methods of measurement of the electromagnetic and operational compatibility of unlicensed personal communications services (UPCS) d

46、evices. This standard does not cover licensed personal communications services (PCS) devices. The recommended methods are applicable to the radio transmitter and monitoring devices contained in the UPCS device. These methods apply to the measurement of individual UPCS devices. Additional methods may

47、 be added to this standard to fulfill future requirements. In addition to the measurements specified herein, UPCS devices may also be required to be tested in accordance with other standards. Examples are listed in Annex A. 1 Copyright 2013 IEEE. All rights reserved. ANSI C63.17-2013 American Nation

48、al Standard Methods of Measurement of the Electromagnetic and Operational Compatibility of Unlicensed Personal Communications Services (UPCS) Devices 1.2 Applications The procedures given herein may be used to test UPCS devices permitted under 47CFR15, Subpart D.1The emissions and operational charac

49、teristics of UPCS devices are the basic parameters affecting UPCS coexistence with other electronic devices and systems. In particular, compliance with this standard may be used to demonstrate electromagnetic compatibility with other UPCS systems and other systems operating in the same and adjacent frequency bands. This standard describes preferred test methods, test facilities and, in some cases, alternative test methods and facilities. If these methods and facilities do not apply to the equipment under test (EUT), the manufacturer must explain why a