IEEE 430-2017 en Standard Procedures for the Measurement of Radio Noise from Overhead Power Lines and Substations.pdf

《IEEE 430-2017 en Standard Procedures for the Measurement of Radio Noise from Overhead Power Lines and Substations.pdf》由会员分享，可在线阅读，更多相关《IEEE 430-2017 en Standard Procedures for the Measurement of Radio Noise from Overhead Power Lines and Substations.pdf（34页珍藏版）》请在麦多课文档分享上搜索。

1、IEEE Standard Procedures for the Measurement of Radio Noise from Overhead Power Lines and Substations IEEE Std 430-2017 (Revision of IEEE Std 430-1986) IEEE Power and Energy Society Sponsored by the Transmission and Distribution Committee IEEE 3 Park Avenue New York, NY 10016-5997 USAIEEE Std 430-20

2、17 (Revision of IEEE Std 430-1986) IEEE Standard Procedures for the Measurement of Radio Noise from Overhead Power Lines and Substations Sponsor Transmission and Distribution Committee of the IEEE Power and Energy Society Approved 14 February 2017 IEEE-SA Standards BoardAbstract: Uniform procedures

3、for the measurement of radio noise generated by corona from over- head power lines and substations are established in this standard. Measurement procedures in this standard are also valid for other power-line noise sources such as gaps and harmonics; however, most of the precautionary information, a

4、nalysis, and data plotting techniques were written and de- veloped primarily for corona discharges. The procedures are not valid for measuring transient radio noise sources that occur during breaker or disconnect switching operations. The procedures apply in the frequency range of 0.010 MHz to 1000

5、MHz; however, the emphasis is on the standard am- plitude-modulation broadcasting (0.535 MHz to 1.605 MHz) and television broadcasting (54 MHz to 72 MHz, 76 MHz to 88 MHz, 174 MHz to 216 MHz, and 470 MHz to 698 MHz) bands. This standard is applicable to both ac and dc transmission lines and substati

6、ons. Keywords: corona, IEEE 430, measurements, radio noise, substations, transmission lines The Institute of Electrical and Electronics Engineers, Inc. 3 Park Avenue, New York, NY 10016-5997, USA Copyright 2017 by The Institute of Electrical and Electronics Engineers, Inc. All rights reserved. Publi

7、shed 17 March 2017. Printed in the United States of America. IEEE is a registered trademark in the U.S. Patent fitness for a particular purpose; non-infringement; and quality, accuracy, effectiveness, currency, or completeness of material. In addition, IEEE disclaims any and all conditions relating

8、to: results; and workmanlike effort. IEEE standards documents are supplied “AS IS” and “WITH ALL FAULTS.” Use of an IEEE standard is wholly voluntary. The existence of an IEEE standard does not imply that there are no other ways to produce, test, measure, purchase, market, or provide other goods and

9、 services related to the scope of the IEEE standard. Furthermore, the viewpoint expressed at the time a standard is approved and issued is subject to change brought about through developments in the state of the art and comments received from users of the standard. In publishing and making its stand

10、ards available, IEEE is not suggesting or rendering professional or other services for, or on behalf of, any person or entity nor is IEEE undertaking to perform any duty owed by any other person or entity to another. Any person utilizing any IEEE Standards document, should rely upon his or her own i

11、ndependent judgment in the exercise of reasonable care in any given circumstances or, as appropri- ate, seek the advice of a competent professional in determining the appropriateness of a given IEEE standard. IN NO EVENT SHALL IEEE BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY ,

12、 OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO: PROCURE- MENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY , WHETHER IN CON- TRACT, STRICT LIABILITY , OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARIS

13、ING IN ANY WAY OUT OF THE PUBLICATION, USE OF, OR RELIANCE UPON ANY STANDARD, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE AND REGARDLESS OF WHETHER SUCH DAMAGE WAS FORESEEABLE.4 Copyright 2017 IEEE. All rights reserved. Translations The IEEE consensus development process involves the review of

14、 documents in English only. In the event that an IEEE standard is translated, only the English version published by IEEE should be considered the approved IEEE standard. Official statements A statement, written or oral, that is not processed in accordance with the IEEE-SA Standards Board Operations

15、Manual shall not be considered or inferred to be the official position of IEEE or any of its committees and shall not be considered to be, or be relied upon as, a formal position of IEEE. At lectures, symposia, seminars, or educational courses, an individual presenting information on IEEE standards

16、shall make it clear that his or her views should be considered the personal views of that individual rather than the formal position of IEEE. Comments on standards Comments for revision of IEEE Standards documents are welcome from any interested party, regardless of membership affiliation with IEEE.

17、 However, IEEE does not provide consulting information or advice pertain- ing to IEEE Standards documents. Suggestions for changes in documents should be in the form of a proposed change of text, together with appropriate supporting comments. Since IEEE standards represent a consensus of concerned i

18、nterests, it is important that any responses to comments and questions also receive the concur- rence of a balance of interests. For this reason, IEEE and the members of its societies and Standards Coordi- nating Committees are not able to provide an instant response to comments or questions except

19、in those cases where the matter has previously been addressed. For the same reason, IEEE does not respond to interpretation requests. Any person who would like to participate in revisions to an IEEE standard is welcome to join the relevant IEEE working group. Comments on standards should be submitte

20、d to the following address: Secretary, IEEE-SA Standards Board 445 Hoes Lane Piscataway, NJ 08854 USA Laws and regulations Users of IEEE Standards documents should consult all applicable laws and regulations. Compliance with the provisions of any IEEE Standards document does not imply compliance to

21、any applicable regulatory require- ments. Implementers of the standard are responsible for observing or referring to the applicable regulatory requirements. IEEE does not, by the publication of its standards, intend to urge action that is not in compliance with applicable laws, and these documents m

22、ay not be construed as doing so. Copyrights IEEE draft and approved standards are copyrighted by IEEE under US and international copyright laws. They are made available by IEEE and are adopted for a wide variety of both public and private uses. These include both use, by reference, in laws and regul

23、ations, and use in private self-regulation, standardization, and the pro- motion of engineering practices and methods. By making these documents available for use and adoption by public authorities and private users, IEEE does not waive any rights in copyright to the documents.5 Copyright 2017 IEEE.

24、 All rights reserved. Photocopies Subject to payment of the appropriate fee, IEEE will grant users a limited, non-exclusive license to photocopy portions of any individual standard for company or organizational internal use or individual, non-commercial use only. To arrange for payment of licensing

25、fees, please contact Copyright Clearance Center, Customer Ser- vice, 222 Rosewood Drive, Danvers, MA 01923 USA; +1 978 750 8400. Permission to photocopy portions of any individual standard for educational classroom use can also be obtained through the Copyright Clearance Center. Updating of IEEE Sta

26、ndards documents Users of IEEE Standards documents should be aware that these documents may be superseded at any time by the issuance of new editions or may be amended from time to time through the issuance of amendments, corri- genda, or errata. An o cial IEEE document at any point in time consists

27、 of the current edition of the document together with any amendments, corrigenda, or errata then in e ect. Every IEEE standard is subjected to review at least every 10 years. When a document is more than 10 years old and has not undergone a revision process, it is reasonable to conclude that its con

28、tents, although still of some value, do not wholly re ect the present state of the art. Users are cautioned to check to determine that they have the latest edition of any IEEE standard. In order to determine whether a given document is the current edition and whether it has been amended through the

29、issuance of amendments, corrigenda, or errata, visit IEEE Xplore at http:/ieeexplore.ieee.org or contact IEEE at the address listed previously. For more information about the IEEE SA or IEEEs standards develop- ment process, visit the IEEE-SA Website at http:/standards.ieee.org. Errata Errata, if an

30、y, for all IEEE standards can be accessed on the IEEE-SA Website at the following URL: http:/ standards.ieee.org/ ndstds/errata/index.html. Users are encouraged to check this URL for errata periodically. Patents Attention is called to the possibility that implementation of this standard may require

31、use of subject matter covered by patent rights. By publication of this standard, no position is taken by the IEEE with respect to the existence or validity of any patent rights in connection therewith. If a patent holder or patent applicant has led a statement of assurance via an Accepted Letter of

32、Assurance, then the statement is listed on the IEEE- SA Website at http:/standards.ieee.org/about/sasb/patcom/patents.html. Letters of Assurance may indicate whether the Submitter is willing or unwilling to grant licenses under patent rights without compensation or under reasonable rates, with reaso

33、nable terms and conditions that are demonstrably free of any unfair discrim- ination to applicants desiring to obtain such licenses. Essential Patent Claims may exist for which a Letter of Assurance has not been received. The IEEE is not re- sponsible for identifying Essential Patent Claims for whic

34、h a license may be required, for conducting inquiries into the legal validity or scope of Patents Claims, or determining whether any licensing terms or conditions provided in connection with submission of a Letter of Assurance, if any, or in any licensing agreements are reasonable or non-discriminat

35、ory. Users of this standard are expressly advised that determination of the valid- ity of any patent rights, and the risk of infringement of such rights, is entirely their own responsibility. Further information may be obtained from the IEEE Standards Association.6 Copyright 2017 IEEE. All rights re

36、served. Participants At the time this IEEE standard was completed, the Corona and Field Effects Working Group had the following membership: Danna Liebhaber, Chair Robert Schaerer, Vice Chair Gordon Baker Tony Baker Bryan Beske David Boudreau John Chan Bill Chisholm Ross Clark Rich Collins Ben Cotts

37、Glenn Davidson Cody Davis James Dubay Kevin Edmonds Namal Fernando Buck Fife Bruce Freimark Michael Garrels Jennifer Havel Arjan Jagtiani Gary Johnson Barrett Kimball John Kuffel Tom McCarthy Rob Meert Mark Patterson Brian Reynolds Steve Roberts Tim Shaw Ross Smith Gerald Stewart Timothy Van Remmen

38、Jack Varner Mike Warntjes The following members of the individual balloting committee voted on this standard. Balloters may have voted for approval, disapproval, or abstention. Saleman Alibhay Mauricio Aristizabal Thomas Barnes Jeffrey Brogdon Gustavo Brunello William Bush William Byrd Robert Christ

39、man Benjamin Cotts Cody Davis Gary Donner Gearold O. H. Eidhin Namal Fernando Michael Garrels George Gela Mietek Glinkowski Waymon Goch Edwin Goodwin Randall Groves Stuart Hanebuth Timothy Harrington Lee Herron Werner Hoelzl Randy Hopkins Magdi Ishac Song Jin Lars Juhlin Chad Kiger James Kinney Jim

40、Kulchisky Chung-Yiu Lam Benjamin Lanz Michael Lauxman Danna Liebhaber Albert Livshitz Lawrenc Long William McBride Michael Newman Gary Nissen Matthew Norwalk Carl Orde Lorraine Padden Bansi Patel Branimir Petosic Percy Pool Douglas Proctor Iulian Profir Jerry Reding Thomas Rozek Daniel Sabin Bartien

41、 Sayogo Robert Schaerer Jeremy Smith Jerry Smith K Stump Roger Verdolin John Vergis Kenneth White David Zech7 Copyright 2017 IEEE. All rights reserved. When the IEEE-SA Standards Board approved this standard on 14 February 2017, it had the following membership: Jean-Philippe Faure, Chair Vacant Posi

42、tion, Vice Chair John D. Kulick, Past Chair Konstantinos Karachalios, Secretary Chuck Adams Masayuki Ariyoshi Ted Burse Stephen Dukes Doug Edwards J. Travis Gri th Gary Ho man Michael Janezic Thomas Koshy Joseph L. Koep nger* Kevin Lu Daleep Mohla Damir Novosel Ronald C. Petersen Annette D. Reilly Robby Robson Dorothy Stanley Adrian Stephens Mehmet Ulema Phil Wennblom Howard Wolfman Yu Yuan *Member Emeritus