IEEE 1729-2014 en Recommended Practice for Electric Power Distribution System Analysis《电力配电系统分析用推荐性操作规范》.pdf

《IEEE 1729-2014 en Recommended Practice for Electric Power Distribution System Analysis《电力配电系统分析用推荐性操作规范》.pdf》由会员分享，可在线阅读，更多相关《IEEE 1729-2014 en Recommended Practice for Electric Power Distribution System Analysis《电力配电系统分析用推荐性操作规范》.pdf（20页珍藏版）》请在麦多课文档分享上搜索。

1、 IEEE Recommended Practice for Electric Power Distribution System Analysis Sponsored by the Power System Analysis, Computing, and Economics Committee IEEE 3 Park Avenue New York, NY 10016-5997 USA IEEE Power and Energy Society IEEE Std 1729-2014IEEE Std 1729-2014 IEEE Recommended Practice for Electr

2、ic Power Distribution System Analysis Sponsor Power System Analysis, Computing, and Economics Committee of the IEEE Power and Energy Society Approved 3 November 2014 IEEE-SA Standards Board Abstract: The aim of this recommended practice is to expand the use of IEEE power distribution test feeders in

3、to a broader space of software developers, software users, and researchers. The need for new distribution software functionality evolves quickly in areas such as distributed resource modeling, load response to voltage and frequency, reliability improvement, neutral-earth voltage, harmonics, active c

4、ontrols, interoperability, etc. By leveraging and expanding the set of test feeders, more attention can focus on providing the new functionality. The scope of the recommended practice includes steady-state, event-based, probabilistic, stochastic, and dynamic analysis of medium-voltage (up to 35 kV)

5、electric utility power distribution systems. Industrial and commercial power distribution systems, harmonic analysis, and electromagnetic transient analysis are all excluded. Keywords: IEEE 1729, power distribution, power system analysis The Institute of Electrical and Electronics Engineers, Inc. 3

6、Park Avenue, New York, NY 10016-5997, USA Copyright 2014 by The Institute of Electrical and Electronics Engineers, Inc. All rights reserved. Published 5 December 2014. Printed in the United States of America. IEEE is a registered trademark in the U.S. Patent fitness for a particular purpose; non-inf

7、ringement; and quality, accuracy, effectiveness, currency, or completeness of material. In addition, IEEE disclaims any and all conditions relating to: results; and workmanlike effort. IEEE standards documents are supplied “AS IS” and “WITH ALL FAULTS.” Use of an IEEE standard is wholly voluntary. T

8、he existence of an IEEE standard does not imply that there are no other ways to produce, test, measure, purchase, market, or provide other goods and services related to the scope of the IEEE standard. Furthermore, the viewpoint expressed at the time a standard is approved and issued is subject to ch

9、ange brought about through developments in the state of the art and comments received from users of the standard. In publishing and making its standards available, IEEE is not suggesting or rendering professional or other services for, or on behalf of, any person or entity nor is IEEE undertaking to

10、 perform any duty owed by any other person or entity to another. Any person utilizing any IEEE Standards document, should rely upon his or her own independent judgment in the exercise of reasonable care in any given circumstances or, as appropriate, seek the advice of a competent professional in det

11、ermining the appropriateness of a given IEEE standard. IN NO EVENT SHALL IEEE BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO: PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPT

12、ION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE PUBLICATION, USE OF, OR RELIANCE UPON ANY STANDARD, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE AND REGARDLESS OF WHETHER SUCH DA

13、MAGE WAS FORESEEABLE. Translations The IEEE consensus development process involves the review of documents in English only. In the event that an IEEE standard is translated, only the English version published by IEEE should be considered the approved IEEE standard. Official statements A statement, w

14、ritten or oral, that is not processed in accordance with the IEEE-SA Standards Board Operations Manual shall not be considered or inferred to be the official position of IEEE or any of its committees and shall not be considered to be, or be relied upon as, a formal position of IEEE. At lectures, sym

15、posia, seminars, or educational courses, an individual presenting information on IEEE standards shall make it clear that his or her views should be considered the personal views of that individual rather than the formal position of IEEE. Comments on standards Comments for revision of IEEE Standards

16、documents are welcome from any interested party, regardless of membership affiliation with IEEE. However, IEEE does not provide consulting information or advice pertaining to IEEE Standards documents. Suggestions for changes in documents should be in the form of a proposed change of text, together w

17、ith appropriate supporting comments. Since IEEE standards represent a consensus of concerned interests, it is important that any responses to comments and questions also receive the concurrence of a balance of interests. For this reason, IEEE and the members of its societies and Standards Coordinati

18、ng Committees are not able to provide an instant response to comments or questions except in those cases where the matter has previously been addressed. For the same reason, IEEE does not respond to interpretation requests. Any person who would like to participate in revisions to an IEEE standard is

19、 welcome to join the relevant IEEE working group. Comments on standards should be submitted to the following address: Secretary, IEEE-SA Standards Board 445 Hoes Lane Piscataway, NJ 08854 USA Laws and regulations Users of IEEE Standards documents should consult all applicable laws and regulations. C

20、ompliance with the provisions of any IEEE Standards document does not imply compliance to any applicable regulatory requirements. Implementers of the standard are responsible for observing or referring to the applicable regulatory requirements. IEEE does not, by the publication of its standards, int

21、end to urge action that is not in compliance with applicable laws, and these documents may not be construed as doing so. Copyrights IEEE draft and approved standards are copyrighted by IEEE under U.S. and international copyright laws. They are made available by IEEE and are adopted for a wide variet

22、y of both public and private uses. These include both use, by reference, in laws and regulations, and use in private self-regulation, standardization, and the promotion of engineering practices and methods. By making these documents available for use and adoption by public authorities and private us

23、ers, IEEE does not waive any rights in copyright to the documents. Photocopies Subject to payment of the appropriate fee, IEEE will grant users a limited, non-exclusive license to photocopy portions of any individual standard for company or organizational internal use or individual, non-commercial u

24、se only. To arrange for payment of licensing fees, please contact Copyright Clearance Center, Customer Service, 222 Rosewood Drive, Danvers, MA 01923 USA; +1 978 750 8400. Permission to photocopy portions of any individual standard for educational classroom use can also be obtained through the Copyr

25、ight Clearance Center. Updating of IEEE Standards documents Users of IEEE Standards documents should be aware that these documents may be superseded at any time by the issuance of new editions or may be amended from time to time through the issuance of amendments, corrigenda, or errata. An official

26、IEEE document at any point in time consists of the current edition of the document together with any amendments, corrigenda, or errata then in effect. Every IEEE standard is subjected to review at least every ten years. When a document is more than ten years old and has not undergone a revision proc

27、ess, it is reasonable to conclude that its contents, although still of some value, do not wholly reflect the present state of the art. Users are cautioned to check to determine that they have the latest edition of any IEEE standard. In order to determine whether a given document is the current editi

28、on and whether it has been amended through the issuance of amendments, corrigenda, or errata, visit the IEEE-SA Website at http:/ieeexplore.ieee.org/xpl/standards.jsp or contact IEEE at the address listed previously. For more information about the IEEE SA or IEEEs standards development process, visi

29、t the IEEE-SA Website at http:/standards.ieee.org. Errata Errata, if any, for all IEEE standards can be accessed on the IEEE-SA Website at the following URL: http:/standards.ieee.org/findstds/errata/index.html. Users are encouraged to check this URL for errata periodically. Patents Attention is call

30、ed to the possibility that implementation of this standard may require use of subject matter covered by patent rights. By publication of this standard, no position is taken by the IEEE with respect to the existence or validity of any patent rights in connection therewith. If a patent holder or paten

31、t applicant has filed a statement of assurance via an Accepted Letter of Assurance, then the statement is listed on the IEEE-SA Website at http:/standards.ieee.org/about/sasb/patcom/patents.html. Letters of Assurance may indicate whether the Submitter is willing or unwilling to grant licenses under

32、patent rights without compensation or under reasonable rates, with reasonable terms and conditions that are demonstrably free of any unfair discrimination to applicants desiring to obtain such licenses. Essential Patent Claims may exist for which a Letter of Assurance has not been received. The IEEE

33、 is not responsible for identifying Essential Patent Claims for which a license may be required, for conducting inquiries into the legal validity or scope of Patents Claims, or determining whether any licensing terms or conditions provided in connection with submission of a Letter of Assurance, if a

34、ny, or in any licensing agreements are reasonable or non-discriminatory. Users of this standard are expressly advised that determination of the validity of any patent rights, and the risk of infringement of such rights, is entirely their own responsibility. Further information may be obtained from t

35、he IEEE Standards Association. Copyright 2014 IEEE. All rights reserved. vi Participants At the time this IEEE recommended practice was completed, the Recommended Practices for Distribution System Analysis Working Group had the following membership: Thomas E. McDermott, Chair Roger C. Dugan, Vice Ch

36、air Mesut Baran Mark Bowman Robert Broadwater William Byrd Sandoval Carneiro, Jr. Wayne Carr James Cleary Robert Damron Alireza Daneshpooy Stephen Fairfax Jerome Gathers Brian Gerzeny Bo Gong Randall Groves Adolfo Gutierrez William Hargenrader Bill Kersting Tanuj Khandelwal Pradeep Kumar HanWuen Low

37、 Martin Luckett Sujeet Mishra Edrin Murzaku A.B. M. Nasiruzzaman Joe Nims James Remich Tim Rohrer Kevin Schneider Matthew Seeley Michael Simms Jeremy Smith Brian Steinbrecher The following members of the individual balloting committee voted on this recommended practice. Balloters may have voted for

38、approval, disapproval, or abstention. William Ackerman Ali Al Awazi Mihaela Albu Thomas Blair William Bloethe Gustavo Brunello William Bush William Byrd Thomas Callsen Paul Cardinal George Clark James Cleary Jerry Corkran Darold Davis Davide De Luca Gary Donner Randall Dotson Neal Dowling Dana Dufie

39、ld Roger C. Dugan Keith Flowers Paul Forquer Marcel Fortin Doaa Galal Mel George V Frank Gerleve Randall Groves Ajit Gwal Donald Hall Werner Hoelzl Yi Hu Noriyuki Ikeuchi Song Jin Laszlo Kadar Innocent Kamwa John Kay Yuri Khersonsky Morteza Khodaie Gary Kobet Jim Kulchisky Saumen Kundu Theo Laughner

40、 Michael Lauxman Albert Livshitz Lawrenc Long Federico Lopez Russell Lowe Martin Luckett Jose Marrero Omar Mazzoni John McAlhaney, Jr. William McBride Thomas E. McDermott Sujeet Mishra Jerry Murphy Edrin Murzaku Arun Narang Dennis Neitzel Michael Newman Nick S. A. Nikjoo Joe Nims Lorraine Padden Ric

41、hard Paes Mirko Palazzo Bansi Patel Shawn Patterson Christopher Petrola Iulian Profir Charles Rogers Thomas Rozek Don Russell Bob Saint Steven Sano Sergio Santos Bartien Sayogo Ted Schoenberg Tony Seegers Robert Seitz Nikunj Shah Charles Simmons David Singleton Jerry Smith John Spare Robert Spiewak

42、K. Stump David Tepen Marcelo Valdes John Vergis Daniel Ward Yingli Wen Kenneth White James Wilson Jian Yu Oonpyo Zhu Michael Zuercher-Martinson Copyright 2014 IEEE. All rights reserved. vii When the IEEE-SA Standards Board approved this recommended practice on 3 November 2014, it had the following m

43、embership: John Kulick, Chair Jon Walter Rosdahl, Vice Chair Richard H. Hulett, Past Chair Konstantinos Karachalios, Secretary Peter Balma Farooq Bari Ted Burse Clint Chaplin Stephen Dukes Jean-Philippe Faure Gary Hoffman Michael Janezic Jeffrey Katz Joseph L. Koepfinger* David J. Law Hung Ling Oleg

44、 Logvinov T. W. Olsen Glenn Parsons Ron Petersen Adrian Stephens Peter Sutherland Yatin Trivedi Phil Winston Don Wright Yu Yuan *Member Emeritus Also included are the following nonvoting IEEE-SA Standards Board liaisons: Richard DeBlasio, DOE Representative Michael Janezic, NIST Representative Julie Alessi IEEE-SA Content Publishing Malia Zaman IEEE-SA Standards Technical Community