IEC 62870-2015 Electrical installations for lighting and beaconing of aerodromes - Safety secondary circuits in series circuits - General safety requirements《机场照明和信标用电气设备 串联电路中的二次安全电路 通用安全要求》.pdf

《IEC 62870-2015 Electrical installations for lighting and beaconing of aerodromes - Safety secondary circuits in series circuits - General safety requirements《机场照明和信标用电气设备 串联电路中的二次安全电路 通用安全要求》.pdf》由会员分享，可在线阅读，更多相关《IEC 62870-2015 Electrical installations for lighting and beaconing of aerodromes - Safety secondary circuits in series circuits - General safety requirements《机场照明和信标用电气设备 串联电路中的二次安全电路 通用安全要求》.pdf（38页珍藏版）》请在麦多课文档分享上搜索。

1、 IEC 62870 Edition 1.0 2015-09 INTERNATIONAL STANDARD NORME INTERNATIONALE Electrical installations for lighting and beaconing of aerodromes Safety secondary circuits in series circuits General safety requirements Installations lectriques pour lclairage et le balisage des arodromes Circuits secondai

2、res de scurit dans des circuits srie Exigences gnrales de scurit IEC 62870:2015-09(en-fr) colour inside THIS PUBLICATION IS COPYRIGHT PROTECTED Copyright 2015 IEC, Geneva, Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any fo

3、rm or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either IEC or IECs member National Committee in the country of the requester. If you have any questions about IEC copyright or have an enquiry about obtaining additional rights to t

4、his publication, please contact the address below or your local IEC member National Committee for further information. Droits de reproduction rservs. Sauf indication contraire, aucune partie de cette publication ne peut tre reproduite ni utilise sous quelque forme que ce soit et par aucun procd, lec

5、tronique ou mcanique, y compris la photocopie et les microfilms, sans laccord crit de lIEC ou du Comit national de lIEC du pays du demandeur. Si vous avez des questions sur le copyright de lIEC ou si vous dsirez obtenir des droits supplmentaires sur cette publication, utilisez les coordonnes ci-aprs

6、 ou contactez le Comit national de lIEC de votre pays de rsidence. IEC Central Office Tel.: +41 22 919 02 11 3, rue de Varemb Fax: +41 22 919 03 00 CH-1211 Geneva 20 infoiec.ch Switzerland www.iec.ch About the IEC The International Electrotechnical Commission (IEC) is the leading global organization

7、 that prepares and publishes International Standards for all electrical, electronic and related technologies. About IEC publications The technical content of IEC publications is kept under constant review by the IEC. Please make sure that you have the latest edition, a corrigenda or an amendment mig

8、ht have been published. IEC Catalogue - webstore.iec.ch/catalogue The stand-alone application for consulting the entire bibliographical information on IEC International Standards, Technical Specifications, Technical Reports and other documents. Available for PC, Mac OS, Android Tablets and iPad. IEC

9、 publications search - www.iec.ch/searchpub The advanced search enables to find IEC publications by a variety of criteria (reference number, text, technical committee,). It also gives information on projects, replaced and withdrawn publications. IEC Just Published - webstore.iec.ch/justpublished Sta

10、y up to date on all new IEC publications. Just Published details all new publications released. Available online and also once a month by email. Electropedia - www.electropedia.org The worlds leading online dictionary of electronic and electrical terms containing more than 30 000 terms and definitio

11、ns in English and French, with equivalent terms in 15 additional languages. Also known as the International Electrotechnical Vocabulary (IEV) online. IEC Glossary - std.iec.ch/glossary More than 60 000 electrotechnical terminology entries in English and French extracted from the Terms and Definition

12、s clause of IEC publications issued since 2002. Some entries have been collected from earlier publications of IEC TC 37, 77, 86 and CISPR. IEC Customer Service Centre - webstore.iec.ch/csc If you wish to give us your feedback on this publication or need further assistance, please contact the Custome

13、r Service Centre: csciec.ch. A propos de lIEC La Commission Electrotechnique Internationale (IEC) est la premire organisation mondiale qui labore et publie des Normes internationales pour tout ce qui a trait llectricit, llectronique et aux technologies apparentes. A propos des publications IEC Le co

14、ntenu technique des publications IEC est constamment revu. Veuillez vous assurer que vous possdez ldition la plus rcente, un corrigendum ou amendement peut avoir t publi. Catalogue IEC - webstore.iec.ch/catalogue Application autonome pour consulter tous les renseignements bibliographiques sur les No

15、rmes internationales, Spcifications techniques, Rapports techniques et autres documents de lIEC. Disponible pour PC, Mac OS, tablettes Android et iPad. Recherche de publications IEC - www.iec.ch/searchpub La recherche avance permet de trouver des publications IEC en utilisant diffrents critres (numr

16、o de rfrence, texte, comit dtudes,). Elle donne aussi des informations sur les projets et les publications remplaces ou retires. IEC Just Published - webstore.iec.ch/justpublished Restez inform sur les nouvelles publications IEC. Just Published dtaille les nouvelles publications parues. Disponible e

17、n ligne et aussi une fois par mois par email. Electropedia - www.electropedia.org Le premier dictionnaire en ligne de termes lectroniques et lectriques. Il contient plus de 30 000 termes et dfinitions en anglais et en franais, ainsi que les termes quivalents dans 15 langues additionnelles. Egalement

18、 appel Vocabulaire Electrotechnique International (IEV) en ligne. Glossaire IEC - std.iec.ch/glossary Plus de 60 000 entres terminologiques lectrotechniques, en anglais et en franais, extraites des articles Termes et Dfinitions des publications IEC parues depuis 2002. Plus certaines entres antrieure

19、s extraites des publications des CE 37, 77, 86 et CISPR de lIEC. Service Clients - webstore.iec.ch/csc Si vous dsirez nous donner des commentaires sur cette publication ou si vous avez des questions contactez-nous: csciec.ch. IEC 62870 Edition 1.0 2015-09 INTERNATIONAL STANDARD NORME INTERNATIONALE

20、Electrical installations for lighting and beaconing of aerodromes Safety secondary circuits in series circuits General safety requirements Installations lectriques pour lclairage et le balisage des arodromes Circuits secondaires de scurit dans des circuits srie Exigences gnrales de scurit INTERNATIO

21、NAL ELECTROTECHNICAL COMMISSION COMMISSION ELECTROTECHNIQUE INTERNATIONALE ICS 29.140.50; 93.120 ISBN 978-2-8322-2896-8 Registered trademark of the International Electrotechnical Commission Marque dpose de la Commission Electrotechnique Internationale Warning! Make sure that you obtained this public

22、ation from an authorized distributor. Attention! Veuillez vous assurer que vous avez obtenu cette publication via un distributeur agr. colour inside 2 IEC 62870:2015 IEC 2015 CONTENTS FOREWORD . 3 INTRODUCTION . 5 1 Scope 6 2 Normative references 6 3 Terms and definitions 7 4 Requirements for the SE

23、LV/PELV supply . 9 4.1 General . 9 4.2 SELV/PELV-safety demarcation line in an AGL series circuit 10 4.3 Environmental conditions 11 4.4 Degree of protection provided by enclosures 11 4.5 Electromagnetic compatibility (EMC) . 11 4.5.1 Limits of electromagnetic emission 11 4.5.2 Limits of immunity 12

24、 4.6 Marking . 12 4.6.1 Marking of the SELV/PELV power supply . 12 4.6.2 Marking at the installation locations . 12 4.7 Protection against electric shock . 12 4.7.1 Basic requirements 12 4.7.2 Protective measure to be applied . 12 4.7.3 Protective separation from the primary series circuit 13 4.7.4

25、Assemblies in the SELV/PELV supply 13 4.7.5 Load of the SELV/PELV supply 13 4.8 Interfaces 14 4.8.1 Supply unit 14 4.8.2 Connectors 14 5 Testing 14 5.1 Type tests . 14 5.2 Routine tests. 14 Annex A (informative) System design selection 15 Bibliography 16 Figure 1 Safety demarcation line in a SELV sy

26、stem . 10 Figure 2 Safety demarcation line in a PELV system . 11 Table A.1 Comparison of characteristics of PELV and SELV 15 IEC 62870:2015 IEC 2015 3 INTERNATIONAL ELECTROTECHNICAL COMMISSION _ ELECTRICAL INSTALLATIONS FOR LIGHTING AND BEACONING OF AERODROMES SAFETY SECONDARY CIRCUITS IN SERIES CIR

27、CUITS GENERAL SAFETY REQUIREMENTS FOREWORD 1) The International Electrotechnical Commission (IEC) is a worldwide organization for standardization comprising all national electrotechnical committees (IEC National Committees). The object of IEC is to promote international co-operation on all questions

28、 concerning standardization in the electrical and electronic fields. To this end and in addition to other activities, IEC publishes International Standards, Technical Specifications, Technical Reports, Publicly Available Specifications (PAS) and Guides (hereafter referred to as “IEC Publication(s)”)

29、. Their preparation is entrusted to technical committees; any IEC National Committee interested in the subject dealt with may participate in this preparatory work. International, governmental and non- governmental organizations liaising with the IEC also participate in this preparation. IEC collabor

30、ates closely with the International Organization for Standardization (ISO) in accordance with conditions determined by agreement between the two organizations. 2) The formal decisions or agreements of IEC on technical matters express, as nearly as possible, an international consensus of opinion on t

31、he relevant subjects since each technical committee has representation from all interested IEC National Committees. 3) IEC Publications have the form of recommendations for international use and are accepted by IEC National Committees in that sense. While all reasonable efforts are made to ensure th

32、at the technical content of IEC Publications is accurate, IEC cannot be held responsible for the way in which they are used or for any misinterpretation by any end user. 4) In order to promote international uniformity, IEC National Committees undertake to apply IEC Publications transparently to the

33、maximum extent possible in their national and regional publications. Any divergence between any IEC Publication and the corresponding national or regional publication shall be clearly indicated in the latter. 5) IEC itself does not provide any attestation of conformity. Independent certification bod

34、ies provide conformity assessment services and, in some areas, access to IEC marks of conformity. IEC is not responsible for any services carried out by independent certification bodies. 6) All users should ensure that they have the latest edition of this publication. 7) No liability shall attach to

35、 IEC or its directors, employees, servants or agents including individual experts and members of its technical committees and IEC National Committees for any personal injury, property damage or other damage of any nature whatsoever, whether direct or indirect, or for costs (including legal fees) and

36、 expenses arising out of the publication, use of, or reliance upon, this IEC Publication or any other IEC Publications. 8) Attention is drawn to the Normative references cited in this publication. Use of the referenced publications is indispensable for the correct application of this publication. 9)

37、 Attention is drawn to the possibility that some of the elements of this IEC Publication may be the subject of patent rights. IEC shall not be held responsible for identifying any or all such patent rights. International Standard IEC 62870 has been prepared by IEC technical committee 97: Electrical

38、installations for lighting and beaconing of aerodromes. The text of this standard is based on the following documents: FDIS Report on voting 97/167/FDIS 97/169/RVD Full information on the voting for the approval of this standard can be found in the report on voting indicated in the above table. This

39、 publication has been drafted in accordance with the ISO/IEC Directives, Part 2. 4 IEC 62870:2015 IEC 2015 The committee has decided that the contents of this publication will remain unchanged until the stability date indicated on the IEC website under “http:/webstore.iec.ch“ in the data related to

40、the specific publication. At this date, the publication will be reconfirmed, withdrawn, replaced by a revised edition, or amended. IMPORTANT The colour inside logo on the cover page of this publication indicates that it contains colours which are considered to be useful for the correct understanding

41、 of its contents. Users should therefore print this document using a colour printer. IEC 62870:2015 IEC 2015 5 INTRODUCTION With a few exceptions, aeronautical ground lighting is designed for series circuit technology operating with a constant current and a maximum input voltage of 5 000 V a.c. rms,

42、 including tolerances. The input voltage to the series circuit is constantly adjusted by the constant current regulator to maintain the series circuit current irrespective of the variations in the load. The properties and characteristics of the constant current regulators are provided in IEC 61822.

43、Due to the structure of the series circuit, i.e. a series connection of all loads, the usual protective devices for personnel protection of an IT, TT or TN network cannot be applied. Aeronautical ground lighting is defined as any light provided as an aid to air navigation and as such is subject to s

44、pecific requirements with respect to its resilience, availability, and serviceability levels. Therefore, insulation faults in the series circuit are often tolerated, and do not lead to the automatic disconnection of the electrical supply to the series circuit. In view of the above IEC 61821 states t

45、hat no work of any kind is normally permitted on live series circuits without first conducting a suitable and sufficient Risk Assessment and using appropriate protective equipment according to IEC 61821. The electrical characteristics of the constant current series circuits are often confused with t

46、hose of IT, TT or TN networks, i.e. constant input voltage, equipment connected in parallel, and a load-dependent current. In practice, it is not always easy to assign rated voltages correctly to individual components of the series circuit or to determine possible touch voltages. In a constant curre

47、nt series circuits, the rated voltage of the equipment in the series circuit and the maximum touch voltage frequently exceed the normal mains input voltage. In a series circuit installation the series circuit input voltage is divided in proportion to the internal resistances of the various loads. Th

48、e rated voltage, i.e. the voltage between the input lines of the equipment, is defined by the series circuit current that flows through the equipment and its input impedance. Since input impedance depends on the equipment design and the series circuit current is constant, the input voltage remains t

49、he same for each item of equipment. As a result of the provision of current control in the series circuit the series circuit input voltage is load-dependent and corresponds to the sum of all partial voltages in the series circuit. This is different to determining the maximum possible touch voltage to earth in a series circuit. Since one or more earth faults, of varying resistance to earth, maybe present, the touc