IEC 62642-3-2010 Alarm systems - Intrusion and hold-up systems - Part 3 Control and indicating equipment《报警系统.入侵和拦截系统.第3部分 控制和显示设备》.pdf

《IEC 62642-3-2010 Alarm systems - Intrusion and hold-up systems - Part 3 Control and indicating equipment《报警系统.入侵和拦截系统.第3部分 控制和显示设备》.pdf》由会员分享，可在线阅读，更多相关《IEC 62642-3-2010 Alarm systems - Intrusion and hold-up systems - Part 3 Control and indicating equipment《报警系统.入侵和拦截系统.第3部分 控制和显示设备》.pdf（164页珍藏版）》请在麦多课文档分享上搜索。

1、 IEC 62642-3 Edition 1.0 2010-10 INTERNATIONAL STANDARD NORME INTERNATIONALE Alarm systems Intrusion and hold-up systems Part 3: Control and indicating equipment Systmes dalarme Systmes dalarme contre lintrusion et les hold-up Partie 3: Equipement de contrle et de signalisation IEC 62642-3:2010 THIS

2、 PUBLICATION IS COPYRIGHT PROTECTED Copyright 2010 IEC, Geneva, Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in wr

3、iting from either IEC or IECs member National Committee in the country of the requester. If you have any questions about IEC copyright or have an enquiry about obtaining additional rights to this publication, please contact the address below or your local IEC member National Committee for further in

4、formation. Droits de reproduction rservs. Sauf indication contraire, aucune partie de cette publication ne peut tre reproduite ni utilise sous quelque forme que ce soit et par aucun procd, lectronique ou mcanique, y compris la photocopie et les microfilms, sans laccord crit de la CEI ou du Comit nat

5、ional de la CEI du pays du demandeur. Si vous avez des questions sur le copyright de la CEI ou si vous dsirez obtenir des droits supplmentaires sur cette publication, utilisez les coordonnes ci-aprs ou contactez le Comit national de la CEI de votre pays de rsidence. IEC Central Office 3, rue de Vare

6、mb CH-1211 Geneva 20 Switzerland Email: inmailiec.ch Web: www.iec.ch About the IEC The International Electrotechnical Commission (IEC) is the leading global organization that prepares and publishes International Standards for all electrical, electronic and related technologies. About IEC publication

7、s The technical content of IEC publications is kept under constant review by the IEC. Please make sure that you have the latest edition, a corrigenda or an amendment might have been published. Catalogue of IEC publications: www.iec.ch/searchpub The IEC on-line Catalogue enables you to search by a va

8、riety of criteria (reference number, text, technical committee,). It also gives information on projects, withdrawn and replaced publications. IEC Just Published: www.iec.ch/online_news/justpub Stay up to date on all new IEC publications. Just Published details twice a month all new publications rele

9、ased. Available on-line and also by email. Electropedia: www.electropedia.org The worlds leading online dictionary of electronic and electrical terms containing more than 20 000 terms and definitions in English and French, with equivalent terms in additional languages. Also known as the Internationa

10、l Electrotechnical Vocabulary online. Customer Service Centre: www.iec.ch/webstore/custserv If you wish to give us your feedback on this publication or need further assistance, please visit the Customer Service Centre FAQ or contact us: Email: csciec.ch Tel.: +41 22 919 02 11 Fax: +41 22 919 03 00 A

11、 propos de la CEI La Commission Electrotechnique Internationale (CEI) est la premire organisation mondiale qui labore et publie des normes internationales pour tout ce qui a trait llectricit, llectronique et aux technologies apparentes. A propos des publications CEI Le contenu technique des publicat

12、ions de la CEI est constamment revu. Veuillez vous assurer que vous possdez ldition la plus rcente, un corrigendum ou amendement peut avoir t publi. Catalogue des publications de la CEI: www.iec.ch/searchpub/cur_fut-f.htm Le Catalogue en-ligne de la CEI vous permet deffectuer des recherches en utili

13、sant diffrents critres (numro de rfrence, texte, comit dtudes,). Il donne aussi des informations sur les projets et les publications retires ou remplaces. Just Published CEI: www.iec.ch/online_news/justpub Restez inform sur les nouvelles publications de la CEI. Just Published dtaille deux fois par m

14、ois les nouvelles publications parues. Disponible en-ligne et aussi par email. Electropedia: www.electropedia.org Le premier dictionnaire en ligne au monde de termes lectroniques et lectriques. Il contient plus de 20 000 termes et dfinitions en anglais et en franais, ainsi que les termes quivalents

15、dans les langues additionnelles. Egalement appel Vocabulaire Electrotechnique International en ligne. Service Clients: www.iec.ch/webstore/custserv/custserv_entry-f.htm Si vous dsirez nous donner des commentaires sur cette publication ou si vous avez des questions, visitez le FAQ du Service clients

16、ou contactez-nous: Email: csciec.ch Tl.: +41 22 919 02 11 Fax: +41 22 919 03 00 IEC 62642-3 Edition 1.0 2010-10 INTERNATIONAL STANDARD NORME INTERNATIONALE Alarm systems Intrusion and hold-up systems Part 3: Control and indicating equipment Systmes dalarme Systmes dalarme contre lintrusion et les ho

17、ld-up Partie 3: Equipement de contrle et de signalisation INTERNATIONAL ELECTROTECHNICAL COMMISSION COMMISSION ELECTROTECHNIQUE INTERNATIONALE XC ICS 13.320 PRICE CODE CODE PRIX ISBN 978-2-88912-198-4 Registered trademark of the International Electrotechnical Commission Marque dpose de la Commission

18、 Electrotechnique Internationale 2 62642-3 IEC:2010 CONTENTS FOREWORD.6 INTRODUCTION.8 1 Scope.9 2 Normative references .9 3 Terms, definitions and abbreviations 10 3.1 Terms and definitions 10 3.2 Abbreviations 13 4 Equipment attributes 13 4.1 General .13 4.2 Functionality14 5 CIE construction.14 6

19、 Security grade14 7 Environmental performance14 7.1 Requirements14 7.2 Environmental and EMC tests .15 8 Functional requirements .15 8.1 Inputs15 8.1.1 Intruder detection 15 8.1.2 Hold-up device 15 8.1.3 Tamper15 8.1.4 Fault15 8.1.5 User input16 8.1.6 Masking.16 8.1.7 Movement detector range reducti

20、on.16 8.1.8 Non-I any IEC National Committee interested in the subject dealt with may participate in this preparatory work. International, governmental and non- governmental organizations liaising with the IEC also participate in this preparation. IEC collaborates closely with the International Orga

21、nization for Standardization (ISO) in accordance with conditions determined by agreement between the two organizations. 2) The formal decisions or agreements of IEC on technical matters express, as nearly as possible, an international consensus of opinion on the relevant subjects since each technica

22、l committee has representation from all interested IEC National Committees. 3) IEC Publications have the form of recommendations for international use and are accepted by IEC National Committees in that sense. While all reasonable efforts are made to ensure that the technical content of IEC Publicat

23、ions is accurate, IEC cannot be held responsible for the way in which they are used or for any misinterpretation by any end user. 4) In order to promote international uniformity, IEC National Committees undertake to apply IEC Publications transparently to the maximum extent possible in their nationa

24、l and regional publications. Any divergence between any IEC Publication and the corresponding national or regional publication shall be clearly indicated in the latter. 5) IEC itself does not provide any attestation of conformity. Independent certification bodies provide conformity assessment servic

25、es and, in some areas, access to IEC marks of conformity. IEC is not responsible for any services carried out by independent certification bodies. 6) All users should ensure that they have the latest edition of this publication. 7) No liability shall attach to IEC or its directors, employees, servan

26、ts or agents including individual experts and members of its technical committees and IEC National Committees for any personal injury, property damage or other damage of any nature whatsoever, whether direct or indirect, or for costs (including legal fees) and expenses arising out of the publication

27、, use of, or reliance upon, this IEC Publication or any other IEC Publications. 8) Attention is drawn to the Normative references cited in this publication. Use of the referenced publications is indispensable for the correct application of this publication. 9) Attention is drawn to the possibility t

28、hat some of the elements of this IEC Publication may be the subject of patent rights. IEC shall not be held responsible for identifying any or all such patent rights. International Standard IEC 62642-3 has been prepared by IEC technical committee 79: Alarm and electronic security systems. This stand

29、ard is based on EN 50131-3 (2006). The text of this standard is based on the following documents: FDIS Report on voting 79/310/FDIS 79/321/RVD Full information on the voting for the approval of this standard can be found in the report on voting indicated in the above table. This publication has been drafted in accordance with the ISO/IEC Directives, Part 2.