IEC 61558-2-6-2009 Safety of transformers reactors power supply units and similar products for voltages up to 1100 V - Part 2-6 Particular requirements and tests for safety isolati.pdf

《IEC 61558-2-6-2009 Safety of transformers reactors power supply units and similar products for voltages up to 1100 V - Part 2-6 Particular requirements and tests for safety isolati.pdf》由会员分享，可在线阅读，更多相关《IEC 61558-2-6-2009 Safety of transformers reactors power supply units and similar products for voltages up to 1100 V - Part 2-6 Particular requirements and tests for safety isolati.pdf（32页珍藏版）》请在麦多课文档分享上搜索。

1、 IEC 61558-2-6Edition 2.0 2009-02INTERNATIONAL STANDARD NORME INTERNATIONALESafety of transformers, reactors, power supply units and similar products for supply voltages up to 1 100 V Part 2-6: Particular requirements and tests for safety isolating transformers and power supply units incorporating s

2、afety isolating transformers Scurit des transformateurs, bobines dinductance, blocs dalimentation et produits analogues pour des tensions dalimentation jusqu 1 100 V Partie 2-6: Rgles particulires et essais pour les transformateurs de scurit et les blocs dalimentation incorporant des transformateurs

3、 de scurit IEC61558-2-6:2009 GROUP SAFETY PUBLICATION PUBLICATION GROUPE DE SCURIT THIS PUBLICATION IS COPYRIGHT PROTECTED Copyright 2009 IEC, Geneva, Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, e

4、lectronic or mechanical, including photocopying and microfilm, without permission in writing from either IEC or IECs member National Committee in the country of the requester. If you have any questions about IEC copyright or have an enquiry about obtaining additional rights to this publication, plea

5、se contact the address below or your local IEC member National Committee for further information. Droits de reproduction rservs. Sauf indication contraire, aucune partie de cette publication ne peut tre reproduite ni utilise sous quelque forme que ce soit et par aucun procd, lectronique ou mcanique,

6、 y compris la photocopie et les microfilms, sans laccord crit de la CEI ou du Comit national de la CEI du pays du demandeur. Si vous avez des questions sur le copyright de la CEI ou si vous dsirez obtenir des droits supplmentaires sur cette publication, utilisez les coordonnes ci-aprs ou contactez l

7、e Comit national de la CEI de votre pays de rsidence. IEC Central Office 3, rue de Varemb CH-1211 Geneva 20 Switzerland Email: inmailiec.ch Web: www.iec.ch About the IEC The International Electrotechnical Commission (IEC) is the leading global organization that prepares and publishes International S

8、tandards for all electrical, electronic and related technologies. About IEC publications The technical content of IEC publications is kept under constant review by the IEC. Please make sure that you have the latest edition, a corrigenda or an amendment might have been published. Catalogue of IEC pub

9、lications: www.iec.ch/searchpub The IEC on-line Catalogue enables you to search by a variety of criteria (reference number, text, technical committee,). It also gives information on projects, withdrawn and replaced publications. IEC Just Published: www.iec.ch/online_news/justpub Stay up to date on a

10、ll new IEC publications. Just Published details twice a month all new publications released. Available on-line and also by email. Electropedia: www.electropedia.org The worlds leading online dictionary of electronic and electrical terms containing more than 20 000 terms and definitions in English an

11、d French, with equivalent terms in additional languages. Also known as the International Electrotechnical Vocabulary online. Customer Service Centre: www.iec.ch/webstore/custserv If you wish to give us your feedback on this publication or need further assistance, please visit the Customer Service Ce

12、ntre FAQ or contact us: Email: csciec.ch Tel.: +41 22 919 02 11 Fax: +41 22 919 03 00 A propos de la CEI La Commission Electrotechnique Internationale (CEI) est la premire organisation mondiale qui labore et publie des normes internationales pour tout ce qui a trait llectricit, llectronique et aux t

13、echnologies apparentes. A propos des publications CEI Le contenu technique des publications de la CEI est constamment revu. Veuillez vous assurer que vous possdez ldition la plus rcente, un corrigendum ou amendement peut avoir t publi. Catalogue des publications de la CEI: www.iec.ch/searchpub/cur_f

14、ut-f.htm Le Catalogue en-ligne de la CEI vous permet deffectuer des recherches en utilisant diffrents critres (numro de rfrence, texte, comit dtudes,). Il donne aussi des informations sur les projets et les publications retires ou remplaces. Just Published CEI: www.iec.ch/online_news/justpub Restez

15、inform sur les nouvelles publications de la CEI. Just Published dtaille deux fois par mois les nouvelles publications parues. Disponible en-ligne et aussi par email. Electropedia: www.electropedia.org Le premier dictionnaire en ligne au monde de termes lectroniques et lectriques. Il contient plus de

16、 20 000 termes et dfinitions en anglais et en franais, ainsi que les termes quivalents dans les langues additionnelles. Egalement appel Vocabulaire Electrotechnique International en ligne. Service Clients: www.iec.ch/webstore/custserv/custserv_entry-f.htm Si vous dsirez nous donner des commentaires

17、sur cette publication ou si vous avez des questions, visitez le FAQ du Service clients ou contactez-nous: Email: csciec.ch Tl.: +41 22 919 02 11 Fax: +41 22 919 03 00 IEC 61558-2-6Edition 2.0 2009-02INTERNATIONAL STANDARD NORME INTERNATIONALESafety of transformers, reactors, power supply units and s

18、imilar products for supply voltages up to 1 100 V Part 2-6: Particular requirements and tests for safety isolating transformers and power supply units incorporating safety isolating transformers Scurit des transformateurs, bobines dinductance, blocs dalimentation et produits analogues pour des tensi

19、ons dalimentation jusqu 1 100 V Partie 2-6: Rgles particulires et essais pour les transformateurs de scurit et les blocs dalimentation incorporant des transformateurs de scurit INTERNATIONAL ELECTROTECHNICAL COMMISSION COMMISSION ELECTROTECHNIQUE INTERNATIONALE NICS 29.180 PRICE CODECODE PRIXISBN 2-

20、8318-1028-8GROUP SAFETY PUBLICATION PUBLICATION GROUPE DE SCURIT Registered trademark of the International Electrotechnical Commission Marque dpose de la Commission Electrotechnique Internationale 2 61558-2-6 IEC:2009 CONTENTS FOREWORD.3 1 Scope.5 2 Normative references .6 3 Terms and definitions .6

21、 4 General requirements.6 5 General notes on tests .6 6 Ratings.6 7 Classification7 8 Marking and other information 7 9 Protection against electric shock 7 10 Change of input voltage setting 7 11 Output voltage and output current under load .7 12 No-load output voltage .7 13 Short-circuit voltage .8

22、 14 Heating 8 15 Short-circuit and overload protection 8 16 Mechanical strength .9 17 Protection against harmful ingress of dust, solid objects and moisture9 18 Insulation resistance, dielectric strength and leakage current .9 19 Construction.9 20 Components .11 21 Internal wiring.11 22 Supply conne

23、ction and other external flexible cable or cords 11 23 Terminals for external conductors.11 24 Provisions for protective earthing .11 25 Screws and connections.11 26 Creepage distances, clearances and distances through insulation12 27 Resistance to heat, fire and tracking.12 28 Resistance to rusting

24、12 Annexes .13 Annex C Creepage distances (cr), clearances (cl) and distances through insulation (dti) Material group II (400 CTI 600) 13 Annex D Creepage distances (cr), clearances (cl) and distances through insulation (dti) Material group I (CTI 600)13 Annex R Explanations of the application of 4.

25、2 of IEC 60664-1:2007 (see IEC 61558-1 Subclause 26.2)13 Bibliography14 Table 101 Output voltage difference 8 61558-2-6 IEC:2009 3 INTERNATIONAL ELECTROTECHNICAL COMMISSION _ SAFETY OF TRANSFORMERS, REACTORS, POWER SUPPLY UNITS AND SIMILAR PRODUCTS FOR SUPPLY VOLTAGES UP TO 1 100 V Part 2-6: Particu

26、lar requirements and tests for safety isolating transformers and power supply units incorporating safety isolating transformers FOREWORD 1) The International Electrotechnical Commission (IEC) is a worldwide organization for standardization comprising all national electrotechnical committees (IEC Nat

27、ional Committees). The object of IEC is to promote international co-operation on all questions concerning standardization in the electrical and electronic fields. To this end and in addition to other activities, IEC publishes International Standards, Technical Specifications, Technical Reports, Publ

28、icly Available Specifications (PAS) and Guides (hereafter referred to as “IEC Publication(s)”). Their preparation is entrusted to technical committees; any IEC National Committee interested in the subject dealt with may Participate in this preparatory work. International, governmental and non-govern

29、mental organizations liaising with the IEC also Participate in this preparation. IEC collaborates closely with the International Organization for Standardization (ISO) in accordance with conditions determined by agreement between the two organizations. 2) The formal decisions or agreements of IEC on

30、 technical matters express, as nearly as possible, an international consensus of opinion on the relevant subjects since each technical committee has representation from all interested IEC National Committees. 3) IEC Publications have the form of recommendations for international use and are accepted

31、 by IEC National Committees in that sense. While all reasonable efforts are made to ensure that the technical content of IEC Publications is accurate, IEC cannot be held responsible for the way in which they are used or for any misinterpretation by any end user. 4) In order to promote international

32、uniformity, IEC National Committees undertake to apply IEC Publications transparently to the maximum extent possible in their national and regional publications. Any divergence between any IEC Publication and the corresponding national or regional publication shall be clearly indicated in the latter

33、. 5) IEC provides no marking procedure to indicate its approval and cannot be rendered responsible for any equipment declared to be in conformity with an IEC Publication. 6) All users should ensure that they have the latest edition of this publication. 7) No liability shall attach to IEC or its dire

34、ctors, employees, servants or agents including individual experts and members of its technical committees and IEC National Committees for any personal injury, property damage or other damage of any nature whatsoever, whether direct or indirect, or for costs (including legal fees) and expenses arisin

35、g out of the publication, use of, or reliance upon, this IEC Publication or any other IEC Publications. 8) Attention is drawn to the Normative references cited in this publication. Use of the referenced publications is indispensable for the correct application of this publication. 9) Attention is dr

36、awn to the possibility that some of the elements of this IEC Publication may be the subject of patent rights. IEC shall not be held responsible for identifying any or all such patent rights. International standard IEC 61558-2-6 has been prepared by IEC technical committee 96: Transformers, reactors,

37、 power supply units and similar products for low voltages up to 1 100 V. This second edition cancels and replaces the first edition published in 1997. It constitutes a technical revision. The main changes consist of updating this part in accordance with Part 1 (2005), and increasing the supply volta

38、ges up to 1 100 V to be in line with the standards of TC 14. This part has the status of a group safety publication in accordance with IEC Guide 104: (1997): The preparation of safety publications and the use of basic safety publications and group safety publications. 4 61558-2-6 IEC:2009 The text o

39、f this standard is based on the following documents: FDIS Report on voting 96/317/FDIS 96/322/RVD Full information on the voting for the approval of this standard can be found in the report on voting indicated in the above table. This publication has been drafted in accordance with the ISO/IEC Direc

40、tives, Part 2. This part is intended to be used in conjunction with the latest edition of IEC 61558-1 and its amendments. It is based on the second edition (2005) of that standard. This part supplements or modifies the corresponding clauses in IEC 61558-1, so as to convert that publication into the

41、IEC standard: Particular requirements and tests for safety isolating transformers and power supply units incorporating safety isolating transformers. A list of all parts of the IEC 61558 series can be found on the IEC website under the title: Safety of transformers, reactors, power supply units and

42、similar products for supply voltages up to 1 100 V. Future standards in this series will carry the new general title as cited above. Titles of existing standards in this series will be updated at the time of the next edition. Where a particular subclause of Part 1 is not mentioned in this part, that

43、 subclause applies as far as is reasonable. Where this part states “addition“, “modification“ or “replacement“, the relevant text of Part 1 is to be adapted accordingly. In this part, the following print types are used: requirements proper: in roman type; test specifications: in italic type; explana

44、tory matter: in smaller roman type: In the text of this part, the words in bold are defined in Clause 3. Subclauses, notes, figures and tables additional to those in Part 1 are numbered starting from 101; supplementary annexes are entitled AA, BB, etc. The committee has decided that the contents of

45、this publication will remain unchanged until the maintenance result date indicated on the IEC web site under “http:/webstore.iec.ch“ in the data related to the specific publication. At this date, the publication will be reconfirmed, withdrawn, replaced by a revised edition, or amended. NOTE The atte

46、ntion of National Committees is drawn to the fact that equipment manufacturers and testing organizations may need a transitional period following publication of a new, amended or revised IEC publication in which to make products in accordance with the new requirements and to equip themselves for con

47、ducting new or revised tests. It is the recommendation of the committee that the content of this publication be adopted for implementation nationally not earlier than 12 months from the date of publication. 61558-2-6 IEC:2009 5 SAFETY OF TRANSFORMERS, REACTORS, POWER SUPPLY UNITS AND SIMILAR PRODUCT

48、S FOR SUPPLY VOLTAGES UP TO 1 100 V Part 2-6: Particular requirements and tests for safety isolating transformers and power supply units incorporating safety isolating transformers 1 Scope Replacement: This part of IEC 61558 deals with the safety of safety isolating transformers for general applicat

49、ions and power supply units incorporating safety isolating transformers for general applications. Transformers incorporating electronic circuits are also covered by this standard. NOTE 1 Safety includes electrical, thermal and mechanical aspects. Unless otherwise specified, from here onward, the term transformer covers safety isolating transformers for general applications and power supply units incor