TIA TSB-159-2006 Private Land Mobile Radio Two-Way Mobile Equipment Radio Frequency (RF) Electromagnetic Exposure (EME) Test Report Guidelines《专业陆地移动无线电双向移动设备RF暴露测试报告指南》.pdf

《TIA TSB-159-2006 Private Land Mobile Radio Two-Way Mobile Equipment Radio Frequency (RF) Electromagnetic Exposure (EME) Test Report Guidelines《专业陆地移动无线电双向移动设备RF暴露测试报告指南》.pdf》由会员分享，可在线阅读，更多相关《TIA TSB-159-2006 Private Land Mobile Radio Two-Way Mobile Equipment Radio Frequency (RF) Electromagnetic Exposure (EME) Test Report Guidelines《专业陆地移动无线电双向移动设备RF暴露测试报告指南》.pdf（21页珍藏版）》请在麦多课文档分享上搜索。

1、 TSB-159 APRIL 20R/11-2011Private Land Mobile Radio Two-Way Mobile Equipment Radio Frequency (RF) Electromagnetic Exposure (EME) Test Report Guidelines NOTICE TIA Engineering Standards and Publications are designed to serve the public interest through eliminating misunderstandings between manufactur

2、ers and purchasers, facilitating interchangeability and improvement of products, and assisting the purchaser in selecting and obtaining with minimum delay the proper product for their particular need. The existence of such Standards and Publications shall not in any respect preclude any member or no

3、n-member of TIA from manufacturing or selling products not conforming to such Standards and Publications. Neither shall the existence of such Standards and Publications preclude their voluntary use by Non-TIA members, either domestically or internationally. Standards and Publications are adopted by

4、TIA in accordance with the American National Standards Institute (ANSI) patent policy. By such action, TIA does not assume any liability to any patent owner, nor does it assume any obligation whatever to parties adopting the Standard or Publication. This Standard does not purport to address all safe

5、ty problems associated with its use or all applicable regulatory requirements. It is the responsibility of the user of this Standard to establish appropriate safety and health practices and to determine the applicability of regulatory limitations before its use. (From Standards Proposal No. 3-0200 f

6、ormulated under the cognizance of the TIA, Subcommittee TR-8.17on RF Exposure). Published by TELECOMMUNICATIONS INDUSTRY ASSOCIATION Standards and Technology Department 2500 Wilson Boulevard Arlington, VA 22201 U.S.A. PRICE: Please refer to current Catalog of TIA TELECOMMUNICATIONS INDUSTRY ASSOCIAT

7、ION STANDARDS AND ENGINEERING PUBLICATIONS or call IHS, USA and Canada (1-877-413-5187) International (303-397-2896) or search online at http:/www.tiaonline.org/standards/catalog/ All rights reserved Printed in U.S.A. NOTICE OF COPYRIGHT This document is copyrighted by the TIA. Reproduction of these

8、 documents either in hard copy or soft copy (including posting on the web) is prohibited without copyright permission. For copyright permission to reproduce portions of this document, please contact the TIA Standards Department or go to the TIA website (www.tiaonline.org) for details on how to reque

9、st permission. Details are located at: http:/www.tiaonline.org/standards/catalog/info.cfm#copyright or Telecommunications Industry Association Technology (b) there is no assurance that the Document will be approved by any Committee of TIA or any other body in its present or any other form; (c) the D

10、ocument may be amended, modified or changed in the standards development or any editing process. The use or practice of contents of this Document may involve the use of intellectual property rights (“IPR”), including pending or issued patents, or copyrights, owned by one or more parties. TIA makes n

11、o search or investigation for IPR. When IPR consisting of patents and published pending patent applications are claimed and called to TIAs attention, a statement from the holder thereof is requested, all in accordance with the Manual. TIA takes no position with reference to, and disclaims any obliga

12、tion to investigate or inquire into, the scope or validity of any claims of IPR. TIA will neither be a party to discussions of any licensing terms or conditions, which are instead left to the parties involved, nor will TIA opine or judge whether proposed licensing terms or conditions are reasonable

13、or non-discriminatory. TIA does not warrant or represent that procedures or practices suggested or provided in the Manual have been complied with as respects the Document or its contents. If the Document contains one or more Normative References to a document published by another organization (“othe

14、r SSO”) engaged in the formulation, development or publication of standards (whether designated as a standard, specification, recommendation or otherwise), whether such reference consists of mandatory, alternate or optional elements (as defined in the TIA Engineering Manual, 4thedition) then (i) TIA

15、 disclaims any duty or obligation to search or investigate the records of any other SSO for IPR or letters of assurance relating to any such Normative Reference; (ii) TIAs policy of encouragement of voluntary disclosure (see Engineering Manual Section 6.5.1) of Essential Patent(s) and published pend

16、ing patent applications shall apply; and (iii) Information as to claims of IPR in the records or publications of the other SSO shall not constitute identification to TIA of a claim of Essential Patent(s) or published pending patent applications. TIA does not enforce or monitor compliance with the co

17、ntents of the Document. TIA does not certify, inspect, test or otherwise investigate products, designs or services or any claims of compliance with the contents of the Document. ALL WARRANTIES, EXPRESS OR IMPLIED, ARE DISCLAIMED, INCLUDING WITHOUT LIMITATION, ANY AND ALL WARRANTIES CONCERNING THE AC

18、CURACY OF THE CONTENTS, ITS FITNESS OR APPROPRIATENESS FOR A PARTICULAR PURPOSE OR USE, ITS MERCHANTABILITY AND ITS NONINFRINGEMENT OF ANY THIRD PARTYS INTELLECTUAL PROPERTY RIGHTS. TIA EXPRESSLY DISCLAIMS ANY AND ALL RESPONSIBILITIES FOR THE ACCURACY OF THE CONTENTS AND MAKES NO REPRESENTATIONS OR

19、WARRANTIES REGARDING THE CONTENTS COMPLIANCE WITH ANY APPLICABLE STATUTE, RULE OR REGULATION, OR THE SAFETY OR HEALTH EFFECTS OF THE CONTENTS OR ANY PRODUCT OR SERVICE REFERRED TO IN THE DOCUMENT OR PRODUCED OR RENDERED TO COMPLY WITH THE CONTENTS. TIA SHALL NOT BE LIABLE FOR ANY AND ALL DAMAGES, DI

20、RECT OR INDIRECT, ARISING FROM OR RELATING TO ANY USE OF THE CONTENTS CONTAINED HEREIN, INCLUDING WITHOUT LIMITATION ANY AND ALL INDIRECT, SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES (INCLUDING DAMAGES FOR LOSS OF BUSINESS, LOSS OF PROFITS, LITIGATION, OR THE LIKE), WHETHER BASED UPON BREACH OF CON

21、TRACT, BREACH OF WARRANTY, TORT (INCLUDING NEGLIGENCE), PRODUCT LIABILITY OR OTHERWISE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. THE FOREGOING NEGATION OF DAMAGES IS A FUNDAMENTAL ELEMENT OF THE USE OF THE CONTENTS HEREOF, AND THESE CONTENTS WOULD NOT BE PUBLISHED BY TIA WITHOUT SUCH LIMI

22、TATIONS. iiFORWARD This forward is not part of this Telecommunications Systems Bulletin (TSB). This TSB is the product of work undertaken by the EME working group of the TIA TR8.17 RF Exposure Engineering Subcommittee. TR8.17 is a subcommittee of TIA TR8 Private Land Mobile Engineering Committee and

23、 addresses RF exposure matters of Private Radio products. The members of TR8.17 and the members of the EME Working Group appreciate the need to provide clear and consistent information documenting device compliance with the appropriate regulatory RF Exposure requirements. During the review of RF Exp

24、osure Test Reports previously submitted to relevant regulatory bodies the members of the Working Group encountered wide variety in the formats of the reports submitted. While the Working Group believes the devices covered in these test reports previously submitted demonstrate compliance with all nec

25、essary regulatory requirements, the Working Group found the diversity of the test report format made the review of the report contents time-consuming, confusing and inefficient. The Working Group realized a more uniform reporting format would likely improve the efficiency of the review process by re

26、ducing if not eliminating the confusion encountered during the review of previously submitted RF Exposure Test Reports. The Working Group believes the amount of time necessary to adequately review the test reports will decrease significantly if reviewers know exactly where the information being soug

27、ht is located in the test report. The sole purpose of this Bulletin is to suggest a consistent RF Exposure test report format for mobile two way land mobile radio products. This Bulletin does not alter, in any way, the relevant regulatory requirements for RF Exposure. The information in this Bulleti

28、n is intended to be solely informative. iiiPrivate Land Mobile Radio Two-Way Mobile Equipment Radio Frequency (RF) Electromagnetic Exposure (EME)Test Report Guidelines TABLE OF CONTENTS Forward ii Table of Contents iii 1. INTRODUCTION .1 1.1. Scope.1 1.2. Relevant Documents2 1.3. Definitions 2 2. SU

29、GGESTED TEST REPORT CONTENTS3 2.1. Cover Page4 2.2. Test Report Table of Contents.4 2.3. Introduction and Overview .5 2.4. References, Standards and Guidelines .5 2.4.1 MPE Limits.5 2.5. Description of Device Under Test (DUT) .6 2.6. Description of Test System6 2.6.1. Description of Ground Plane or

30、Test Vehicle and Antenna locations 6 2.6.2. Description of Test Site.7 2.6.3. Description of Measurement Equipment.7 2.7. Additional Test Equipment.7 2.8 DUT Test Strategy and methodology.7 2.8.1 DUT Configuration 7 2.8.2. Test Plan.7 2.8.3. Environmental Test Conditions8 2.9. Test Results Summary.8

31、 2.10. Conclusion .8 2.11. Appendices 9 ANNEX A.1 Suggested Cover Page Format Template A ANNEX A.2 Suggested Test Report Format Template B 1Private Land Mobile Radio Two-Way Mobile Equipment Radio Frequency (RF) Electromagnetic Exposure (EME) Test Report Guidelines 1. INTRODUCTION Exposure to radio

32、frequency (RF) energy has been identified as an environmental factor to be considered before a radio transmitter will be certified by various regulatory agencies. Federal Communications Commission (FCC) Office of Engineering and Technlogy (OET) Bulletin 65 (Evaluating Compliance with FCC Guidelines

33、for Human Exposure to Radiofrequency Electromagnetic Fields, edition 97-01, August 1997) outlines various EME evaluation methods as they apply to mobile, portable and base station Land Mobile Radio Products and provides assistance in determining whether a proposed or existing transmitting facility,

34、operation or device complies with established FCC RF Exposure requirements. 47 CFR Code of Federal Regulations (CFR) 2.1091, 2.1093, 1.1307(b) and 1.1310 require RF exposure compliance for fixed, mobile and portable transmitting devices. 47 CFR 1.1310 lists the field strength and power density limit

35、s that are applicable to mobile and fixed transmitters. 47 CFR 2.1093 (d) lists the specific absorption rate (SAR) limits for portable transmitters that are applicable for general population and for occupational exposure conditions. OET Bulletin 65 (97-01), Supplement C (01-01) to OET Bulletin 65, A

36、merican National Standards Institute/Institute of Electrical and Electronics Engineers, Inc. (ANSI/IEEE) C95.3, National Council on Radiation Protection and Measurements (NCRP) Report 119, and Industry Canada (IC) Radio Standards Specification(RSS) -102 also provide guidance on RF exposure evaluatio

37、n for meeting field strength, power density and SAR requirements. Numerous rules sections and other documents discuss RF exposure requirements and methods to be used for verification of compliance with such requirements, but there exists no information outlining any recommended formats for reports s

38、ubmitted to document compliance with relevant RF Exposure requirements. 1.1. Scope To recommend uniform format guidelines that can be used in the preparation of test reports submitted to the FCC and other relevant regulatory agencies, where such mobile two-way radio equipment test reports are intend

39、ed to document compliance with relevant regulatory RF Exposure requirements. 21.2. Relevant Documents This Telecommunications Systems Bulletin (TSB) ought to be interpreted in conjunction with definitions and procedures described in the following documents: IEEE C95.1-1999 IEEE C95.3-2002 47 CFR 1.1

40、307, 1.1310, 2.1091 and 2.1093 FCC OET Bulletin 65, edition 97-01 Supplement C to OET Bulletin 65, edition 01-01 (June 2001 release) NCRP Report No. 86, 1986 IC RSS-102, Issue 1, 1999. 1.3. Definitions 1.3.1. Portable 2-way device1For purposes of FCC RF exposure requirements, a portable device is de

41、fined as a transmitting device designed to be used with its radiating structures located within 20 centimeters of a persons body. Portable devices are evaluated for RF exposure compliance with respect to specific absorption rate (SAR) limits. 1.3.2. Mobile 2-way device2For purposes of FCC RF exposur

42、e requirements, a mobile device is defined as a transmitting device designed to be used in other than fixed locations3and to be generally used in such a way that a separation distance of at least 20 centimeters is normally maintained between the transmitters radiating structures and the body of the

43、user and nearby persons. A 2-way radio operating with a vehicular-mounted antenna is an example of a mobile transmitter device. Mobile devices are normally evaluated for RF exposure compliance with respect to field strength or power density limits. When appropriate, mobile devices may also be evalua

44、ted with respect to SAR limits to demonstrate compliance. 1.3.3. FCC RF Exposure Limits The RF exposure limits adopted by the FCC are generally based on recommendations from the National Council on Radiation Protection and Measurements (NCRP) Report No. 86 and the American National Standards Institu

45、te (ANSI/IEEE) C95.1-1992.4In the frequency range from 100 MHz to 1500 MHz, exposure limits for field strength and power density are also generally based on guidelines recommended by the American 1See 47 CFR 2.1093 2See 47 CFR 2.1091 3In this context, the term “fixed location“ means that the device,

46、 including its antenna, is physically secured at a permanent location and is not able to be easily moved to another location. 4NCRP Report No. 86, “Biological Effects and Exposure Criteria for Radiofrequency Electromagnetic Fields“, sections 17.4.1, 17.4.1.1, 17.4.2 and 17.4.3; copyright NCRP, 1986,

47、 Bethesda, Maryland 20814. ANSI/IEEE C95.1-1992, “IEEE Standard for Safety Levels with Respect to Human Exposure to Radio Frequency Electromagnetic Fields, 3 kHz to 300 GHz”, Section 4.1; copyright 1992 by the Institute of Electrical and Electronics Engineers, Inc., New York, New York 10017. 3FCC RF

48、 exposure compliance for mobile devices is determined according to the frequency dependent field strength and power density limits described in 47 CFR 1.1310. The SAR limits for portable devices are described in 47 CFR 2.1093. 1.3.4 Maximum Permissible Exposure (MPE)5The rms and peak electric and ma

49、gnetic field strengths, their squares, or the plane-wave equivalent power densities associated with these fields and the induced and contact currents to which a person may be exposed without harmful effect and with an acceptable safety factor. 1.3.5. RF Exposure Categories 1.3.5.1. Controlled environment The occupational/controlled exposure limits are applicable to situations in which persons are exposed as a consequence of their employment, and such persons have been made aware of the pot