NAVY MIL-T-29360 (3)-1979 TEST EQUIPMENT DATA COMMUNICATIONS TERMINAL AN TYC-5A(V)《AN TYC-5A(V)型数字通信终端测试装置》.pdf

《NAVY MIL-T-29360 (3)-1979 TEST EQUIPMENT DATA COMMUNICATIONS TERMINAL AN TYC-5A(V)《AN TYC-5A(V)型数字通信终端测试装置》.pdf》由会员分享，可在线阅读，更多相关《NAVY MIL-T-29360 (3)-1979 TEST EQUIPMENT DATA COMMUNICATIONS TERMINAL AN TYC-5A(V)《AN TYC-5A(V)型数字通信终端测试装置》.pdf（2页珍藏版）》请在麦多课文档分享上搜索。

1、- - Y-/ / - MIL-T-27360 (3) 66 7797706 Olt36577 4 H F- r 9- 60 - 7g MIL-T-29360 (M(2) AMENDMENT 3 29 November 1979 AMENDMENT 2 26 September 1979 SUPERSEDING - MILITARY SPECIFICATION TEST EQUIPMENT, DATA COMMUNICATIONS TElWINAL AN/TYC-5A(V) This amendment forms a part of Military Specification MIL-T-

2、29360(MC), dated 7 September 1976. PAGE 10 93.3.5.5 (a) (8) (B) : Delete “Pull counter switch“ and sub- s t i tute “Poll count switch .- *3.3.5,5 (a) (8) (J) : Delete “continuous“ and substitute II message.“ - PAGE 11 7k3.3.5.5 (b) (4) : At end of paragraph, add “The ROM shall contain two message fo

3、rmats, one formatted to simulate DSSCS (Y) traffic and the other to simulate GENSER (R) traffic.“ *3.3.5.5 (b) (5) : Delete “84“ and substitute “82“. PAGE 13 *3.3.5.5 (b)(8)(C): Delete in entirety. PAGE 14 *3.3.5.5 (b)(8)(S): Delete in entirety. 3.3.5.5 (b)(8)(T): Delete in entirety. 3.3.5.5 :After

4、(b) (8) (W) , add new paragraph “Message format R-Y switch-Selects DSSCS (Y) or GENSER (R) message format. 11 3.3.5.9 : Delete “50 watts“ and substitute “75 watts“. 3.3.6, line 5: Delete “type III, class 9“ and substitute “type II, class 5“. / FSG 6625 THIS DOCUMENT CONTAINS 0s PAGES , - Provided by

5、 IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-T-29360 (3) 66 9999906 0336600 7 S MIL-T-2936O(MC) AMENDMENT 3 PAGE 17 3.3.6.7 (f): Delete in entirety and substitute the following: (f) Provide a ROM programmed with characters from the ASCII code set, to be

6、transmitted to the AIU. The ROM shall contain two message formats, one formatted to simulate DSSCS (Y) traffic and another to simulate GENSER (R) traffic.“ PAGE 19 *3,3.6.7 : After (m) (32), add new .paragraph “Message for- mat R-Y switch - Selects DSSCS (Y) or GENSER (R) message format.“ PAGE 20 3.

7、3.6.11: Delete “45 W“ and substitute “75 W.“ PAGE 21 ,.3.3.8 (d): Delete “25“ and substitute “2.5.“ PAGE 23 3.7 (d): Delete in entirety and substitute the following: “(d) PCC. The case shall not exceed 3.5 inches in height, 4rinches. in width and 7.5 inches in length.“ *3.8(c): Delete “5“ and substi

8、tute “1“. *3.8(d): Delete 1“ and substitute “5“. 4.2.1: At end of paragraph, add “Group A only“. The margins of this amendment are marked with an asterisk to indicate where changes (additions, modifications, corrections, deletions) from the previous amendment were made. This was done as a convenienc

9、e only and tle Government assumes no liability whatsoever for any inaccuracies in these notations. Bidders and contractors are cautioned to evaluate content requirements of this document based on the entire content irrespective of the marginal notations and relationship to the last previous amendment. Preparing activity : Navy - MC Project No. 6625-N772 * Page 2 of 2 Pages Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-