NAVY MIL-STD-1320-221-1985 TRUCKLOADING MOTOR 5 0 INCH ROCKET MK 22 MOD 4 (LOADED ASSEMBLY) IN CONTAINER MK 697 MOD 0《 5 0 INCH火箭发动机 MK 22 MOD 4在MK 697 MOD 0的装车》.pdf

《NAVY MIL-STD-1320-221-1985 TRUCKLOADING MOTOR 5 0 INCH ROCKET MK 22 MOD 4 (LOADED ASSEMBLY) IN CONTAINER MK 697 MOD 0《 5 0 INCH火箭发动机 MK 22 MOD 4在MK 697 MOD 0的装车》.pdf》由会员分享，可在线阅读，更多相关《NAVY MIL-STD-1320-221-1985 TRUCKLOADING MOTOR 5 0 INCH ROCKET MK 22 MOD 4 (LOADED ASSEMBLY) IN CONTAINER MK 697 MOD 0《 5 0 INCH火箭发动机 MK 22 MOD 4在MK 697 MOD 0的装车》.pdf（5页珍藏版）》请在麦多课文档分享上搜索。

1、MIL-STD-1320 -221 81 = 7777711 0057588 8 M IL-STO-1 3 20-221 (NAVY) MILITARY STANDARD 9 APRIL 1985 TRUCKLOADING MOTOR, 5.0 INCH ROCKET MK 22 MOD 4 (LOADED ASSEMBLY) IN CONTAINER MK 697 MOD. O CONTAINER DATA DIMENSIONS 92 I X 14W X 21 1/4H CUBE 15.8 CU. FT. GROSS WT . 270 LBS COhTAINER DHG . 5167 i51

2、 DOT HAZARD CLASSIFICATION . EXPL. B CG HAZARD CLASSIFICATION INDEX - - ITEM PSE GENERAG NOTES 2 FTL 2&3 NOTES : LTL 4 1. UNLESS OTHERWISE SPECIFIED DIMENSIONS ARE IN INCHES. UNITIZING 5 2. FOR CROSS REFBRENCE TO ASSOCIATED PALLETIZING, CONTAINERLOADING, AND CARLOADING MILITARY STANDARDS, RBFER TO I

3、NDEX TO STANDARDS, MIL-HDBK-236 INAWJ AUTHORIZED AND RELEASED FOR HIGHWAY SHIPMENT ONLY DISTRIBUTIOH STATEMENT A Approvrd lof public fmiw8Oi dhtribhim it Mihitd. dff fn 1y I- Y)F)b5 DATE ORIGINATOR NAVAL WEAPONS HANDLING CENTER WPNSTA EARLE, NEW JERSEY 1- Provided by IHSNot for ResaleNo reproduction

4、 or networking permitted without license from IHS-,-,-MIL-STD-1320-221 (NAVY) GENERAL NOTES 1. THIS DOCUMENT GIVES DETAILED INSTRUCTIONS FOR TRUCKLOADING THE 5.0 INCH ROCKET MOTOR MK 22 MOD 4 IN CONTAINBR HK 697 MOD O. PHE PROCEDURES AND PRACTICES DESCRIBBD HEREIN ARE INTENDED FOR 40, 42, 44 AND 45

5、FT. TRAILERS (VAN). VANS WITH BOTH NAILABLE AND NONNAILABLE FLOOR. MUST BE SHIPPED IN A VAN WITH NAILABLE FLOORS. 2. A FULL TRUCKLOAD IFTLJ MAY B6 SHIPPBD IN A LESS THAN TRUCKLOAD 1LTL) 5. THE MAXIMUM GROSS WEIGHT OF THE TRACTOR-TRAILER AND THE ALLOWABLE AXLE WEIGHTS ARE THE RESPONSIBILITY OF THE CA

6、RRIER. THE CARRIER WILL ADVISE THE SHIPPER OF THESE LIMITATIONS AND THE SHIPPER SHALL LOAD THE TRAILER IN SUCH A MAHNER THAT THE TRACTOR-TRAILER WILL NOT EXCBED THESE LIMXTATIIONS. AFTBR BLOCKING AND BRACING HAS BEBN INSPECTED, ATTACH SHIPPING DOCUMENTS TO INSIDE OF TRAILER IN AN ACCBSSIBLE AREA. CL

7、OSB AND SEAL TRAILER DOORS AND 4. ATTACH EXPLOSIVES B PI+ARD TO BOTH SIDES, FRONT AND BACK OF TRAILER. FOR GENERAL TRUCKLOADING PROCEDURES REFER TO THE GENERAL TRUCKLOADING DOWWBNTi MIL-STD-1320 (NAVY). 5. 1-1 VANS USED FOR THIS SHIPHENT MUST HAVE A MINIHUM INSIDE SIDTH OF Y3 INCHBS NOTE: NAIL FRAME

8、 TO GATB UPRIGHT (PIECE 4 OP DETAIL BI W 8-Iod NAIL PBR FRAME FTL 40 FT TRAILER (VAN). PAGB 2 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-STD-1320 -221 1 m 7777711 0057570 b m _ - 9 TIE PIECE 2 X 4 x Tw-l 2 11 2 JOINT 16d 8 STRUT 2 X 4 X TO S

9、UIT 12 SEE 10 - - MIL-STO-1320-221 (NAVY) 4 3 2 FTL 40,42,44 &45 FT TRAILERS (VAN) i. A FTL CONSISTS OF 4U FT. TRAILER - 96 ROCKET MOTORS 42 FT. TRAILER - Y9 ROCKET MOTORS 44 6 45 FT TRAILER - 102 ROCKET MOTORS L. LENGTH OF STRUT, PIECE 8 OF DETAIL C. SHALL BE SUCH AS TO CAUSE THE GATE VERTICAL 2X6X

10、6Q 4 8 3 JOINT 10d VERTICAL 2X4X64 4 SFElig5 - FWD CROSSMEEIBER 2 X 6 X TO SUIT 3 6 3 JOINT 10d I FRAMES, DETAIL C, TO BEAR AGAINST THE REAR CATE, DETAIL B, AND THE TRAILER DOORS WHEN THE DOORS ARE CLOSED. 1 io! DETAIL Q FRONT BULKHEAD (1 REQUIREDJ AFT CROSSMEMBER 2 X 6 X TWO-1 3 6 3 JOINT I 1Od NUM

11、BER 1 SIZE EQI) IAIL TO HAILS DESCRIPTION DIMEIISI 0% GATE FRAHE (4 REQUIRED) A DETAIL REAR GATE (I REQUIREDJ 7 I UPRIGHT 12 X 6 X 61 11 12 JOINT I 16d 6 I LOXGITUDINAL 12 X 6 X TO SUIT I al 10 12 JOINT I 166 LIST OF MATERIALS 8 NAILING MTA PAG6 3 Provided by IHSNot for ResaleNo reproduction or netw

12、orking permitted without license from IHS-,-,-MIL-STD-1320 -221 1 7777711 0057531 W 11 SEAL 3/4 2 EA - 10 STEEL STRAPPING 314 X 035 X 9 FT 2 EA - 9 UNITIZING BATTEN 2X4X26 2 EA - MIL-STD-1320-221 (NAVY) - - LTL All LENGTH TRAILERS (VAN) 1. HEN REQUIRED TO SHIP LTL, FIRST TAKE UNIT LOADS PROM REM ATT

13、EMPTING TO MiNTAIN 3 HIGH STACKS. CONTAINERS. STACK As SHOWN ABOVE. IF REQUIRED. BECAUSE OF UNIT LOAD CONFIGURATION, ODD NUMBERS OF CONTAINERS CANNOT BE SHIPPED UNLESS ONE UNIT LOAD IS BROKEN DOWN AND THE EXTRA SINGLE CONTAINER IS BLOCKED MD BRACED SEPARATELY AT THE REAR OF THE TRAILER. (U0 NOT USE

14、3 HIGH STACKS FOR FEWER THAN 78 IF THIS CANNOT BE DONE, THEN ARRANGE UNIT LOADS IN A 2 HIGH SIMILARLY, 1 HIGH STACKS CAN REPLACE 2 HIGH STACKS 2. DETAIL XNBB BRACE FOR 2 HIOH STACK KNEE BRACE FOR 1 HIGH STACK PAGB 4 1 BRACE, DIAGONAL BRACE, BACKUP BRACE, UPRIGHT BRACE, CLEAT BRACE, DIAGOIAL BRACE, B

15、ACKUP BRACE, UPRIGHT 2 X 6 X TO SUIT I 8 I 5 + 8 t4/JOINT 2 x 10 x 22 4 8 3 2 X 6 X 20 1/2 4 6 6 I I I 4 TRAILER FLOOR 6 2 X 6 X 30 1/2 16d 16d 10d 16d 16d - - - - 16d Iod - NUMBER I SIZE NO, EyD MIL &:H TO NA1 LS DIZIENSIONS DESCRIPTION LIST I)F MTERIALS 8 NAILING DATA I Provided by IHSNot for Resa

16、leNo reproduction or networking permitted without license from IHS-,-,-MIL-STD-1320 -221 B1 7977931 0059592 T MIL-STO-1320-221 (NAVY) UNITIZING PROCEDURE 1. TAIS UNIT LOAD IS DETAILED IN MIL-STD-1322-71 AND IS TO BE USED IN ALL TRANSPORTATION AND HANDLING OPERATIONS. A. PLACE UNITIZIHG BATTENS, ITEM 9, IISIDE THE OUTBOARD SKIDS AS SHOWN, SECURE WITH 3/4 STRAPPING, ITEM 10, AND DOUBLE NOTCH SEAL, ITEM 11. REVIEW ACTIVITY NAVY-OS PRBPARING ACTIVITY NAW-OS PROJECT NO. 8140-N645 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-