NAVY MIL-S-81780 C-1977 SPECIAL HANDLING EQUIPMENT《设备特殊处理》.pdf

《NAVY MIL-S-81780 C-1977 SPECIAL HANDLING EQUIPMENT《设备特殊处理》.pdf》由会员分享，可在线阅读，更多相关《NAVY MIL-S-81780 C-1977 SPECIAL HANDLING EQUIPMENT《设备特殊处理》.pdf（9页珍藏版）》请在麦多课文档分享上搜索。

1、MIL -S -8 1780C (AS) 11 July 1977 Superseding 6 Decembar 1974 MIL-S-81780B (AS) MILITARY SPECIFICATION SPECIAL HANDLING EQUIPMENT This specification has been approved by the Naval Air Systems Command, Department of the Navy. 1. SCOPE 1.1 Scope. This specification covers the performance, design, and

2、test requirements for ths Special Handling Equipment (SHE). 1.2 Classification. The SHE shall consist of the following items (see 6.4). a. Adapter, Handling, Antenna MX-9046( )/AWM-23(V) b. Adapter, Handling, Tactical Information Display MX-9047( )/ Am-23 (V) c. Bar, Lifting, Antenna MX-9048( )/AWM-

3、23(V) d. Adapter, Hoisting, Antenna ADU-371( )/E e. Adapter, Handling, Antenna MX-9691( )/AWM-23(V) 1.3 Associated equipment. The antenna handling adapter s.dl operate with Test Set , Antenna, Boresight TS-3568 ( ) /AwM-23(V) (See .6.4) . 2. APPLICABLE DOCUMENTS 2.1 General. The following documents,

4、 of the issue specified in AS-4053, Applicable Document List for AWCS Test Set AN/AiVM-Z3(V) , form a part of this specification to the extent specified herein. shall be the applicable general specification for the SHE described herein (see 6.6). MZLnTn81734CAS) Beneficial comments (recommendations,

5、 additions, deletions) and any,perti- nent data which may be of use in improving this document should.be addressed to: Engineerhg Specifications and Standards Department (Code 93) Naval Air Engineering Center, Lakehurst, N.J. 08733, by using self-addressed Standardization Document Improvement Propos

6、al (DD Form 1426) appearing at the end of this document or by letter. I -1- FSC-4935 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-Sn81780C (AS) SPECIFXCATTONS Military MIL-Tn81734CAS) - DRAWINGS Hughes Aircraft Company Test Set, Airborne Weapo

7、n Control System, N/AiI-23(V) 493602-1XX .,-pter, Handling Antenna 493614-1XX Adapter, Handling, TID 493619-1XX Bar, Lifting, Antenna 493625-1XX Adapter, Hoisting, Antenna 2.2 Availability of documents. Applicable(see 6.6) 2.3 Precedence of documents. When the requirements of the contract, this spec

8、ification, or applicable subsidiary documents are in conflict, the following precedence shall apply: a. document. Contract - The contract shall have precedence over any other b. This specification - This specification shall have precedence over all applicable subsidiary documents (see 6.6). c. Refer

9、enced documents - Any document referenced in this specification shall have precedence over all applicable documents referenced therein, 3. REQUIREMENTS 3.1 Materials, parts, and processes. Applicable (see 6.6). 3.1.1 Selection of materials, parts, and processes. Applicable. 3.1.1.1 Approval of nonst

10、andard materials, parts, and processes, Applicable. .3.1,2 Flammable materials. Applicable. 3.1.3 Cables and connectors. Not applicable. . 3.1.4 Wire. Not applicable. 3.1.5 Rotary switches. Not applicable 3.1.6 Finishes. Applicable. -2- Provided by IHSNot for ResaleNo reproduction or networking perm

11、itted without license from IHS-,-,-MIL-S-817OC LI7 m 7777906 0256664 m MIL-S-8178OC (AS) 3.1.7 Marking and identification. Applicable. 3.1.8 Soldering. Not applicable. 3.1.9 Welding. Applicable. 3.1.10 Printed wiring. Not applicable. 3.1.11 Engineering changes to printed circuit boards. Not applicab

12、le. 3.1.12 Replaceability of electronic standard parts and materials. Not applicable. 3.2 Design and construction. Applicable. 3.2.1 Design features. Applicable. 3.2.1.1 Method of operation. Applicable. 3.2.1.2 Commercial test equipment, Not applicable. 3.2.1.2.1 Other commercial components, Not app

13、licable. 3.2.1.3 Circuit grounds. Not applicable. 3.2.1.4 Interchangeability. Applicable. 3.2.1.5 Identification of product. Applicable. 3.2.1.6 Human factors. Applicable. 3.2.1.7 Test set generated acoustic noise. Not applicable. 3.2.1.8 Forced-liquid cooling. Not applicable. 3.2.1.9 Space and weig

14、ht limitations. The maximum size and weight of the SHE shall be as listed in Table I. 3.2.1.10 Connectors. Not applicable. 3.2.1.11 Secondary electrical power. Not applicable. 3.2.1.12 Interface. The antenna handling adapter shall interface with the AN/AWG-9 radar antenna. adapter shall interface wi

15、th the AN/AWG-9 tactical information display. antenna lifting bar shall interface with the AN/AiVG-9 radar antenna. antenna hoisting adapter shall provide an interface between the hoist mechanism and the AN/AWG-9 radar antenna. The tactical information display handling The The -3- Provided by IHSNot

16、 for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-S-8178OC (AS) 3.2.2 Utilities. Not applicable. 3.2.3 Service conditions. 3.2.3.1 Electrical. Not applicable. 3.2.3.2 Environmental. Avvlicable. * TABLE I SPECIAL HANDLING EQUIPPENT . FOR WEAPON REPLACEABLE ASSEMBLIES

17、 Item Nomenclature (see 6.4) Adapter, Handling Antenna MX-9046( )/ AWM-23 (V) Adapter, Handling Tactical Information Display MX-9047( ) / AWM-23 (Y) Bar, Lifting, Antenna MX-9048( )/ AWM- 2 3 (V) Adapter, Hoisting, Antenna ADU-371( )/E Adapter, Handling, Antenna MX-9691( )/ AWM-23(V) WFW Application

18、 (see 6.4) Antenna AS-2764( )/ AWG-9 Display, Tactical IP-1110( )/AWG-9 Antenna AS-2764C / AWG-9 Antenna AS-2764C )/ AWG-9 Antenna AS-2764( )/ AWG-9 4- Size (inches max) 44 by 40 by 32 31 by 17 by 21 48 hy 39 by 25 13 by 10 bY 8 by 33 44 by 40 wzy (lbs max) 48 20 19 15 48 Provided by IHSNot for Resa

19、leNo reproduction or networking permitted without license from IHS-,-,-MIL-S-81780C (AS) 3.2.3.2.1 Organizational level. Applicable. 3.2.3.2.2 Intermediate level. Applicable. 3.2.4 Maintainability. Applicable. 3.2.4.1 Mean time to repair. Applicable. 3.2.4.2 Test points. Not applicable. 3.2.4.3 Shop

20、 replaceable assemblies. Not applicable. 3.2.4.4 Self test capabilities. Not applicable. 3.2.5 Reliability. Not applicable. 3.2.6 Electromagnetic Interference (EMI) . Not applicable. 3.2.7 Utilities protection. Not applicable. 3.2.8 Calibration cycle. Not applicable. 3.3 Performance 3.3.1 General. T

21、he SHE shall facilitate the safe removal, installation, and transportation of the weapon replaceable assemblies (WRAs) listed in Table I at the organizational and intermediate maintenance levels. 3.3.2 Organization level functional requirements. Applicable. 3.3.3 Intermediate level functional requir

22、ements. Applicable. 3.3.4 Warm-up time. Not applicable. 3.4 Detailed functional requirements. Applicable. 3.5 Workmanship. Applicable. 3.6 SHE elements. Unless otherwise specified, the SHE shall be as specified in the following. 3.6.1 Handling Adapters. Handling adapters shall be welded assemblies t

23、hat facilitate handling of, and provide physical protection for, the WFWs with which they are to be used. ment to a suitable dolly by means of straps (not supplied with the adapters). 0 They shall be constructed to permit attach- -5- Provided by IHSNot for ResaleNo reproduction or networking permitt

24、ed without license from IHS-,-,-MIL-S-BL7OC 47 97799Ob 025bbb7 3 W MIL-S-8178OC (AS) 3.6.1.1 Adapter, Handling, Antenna MX-9046( )/AWM-23(V) and MX-9691( )/ AWM-23(V). that two adapters may be attached to one another to provide a protective frame enclosing an antenna secured to one of the adapters.

25、provide a mounting surface with tapped holes located to match the mounting holes in the base of Antenna AS-2764( )/AWG-9. Hexagon headed cap screws (captive to the adapter) shall be provided to fasten the antenna to the adapter. Provi- sion shall be made for mounting the adapter in Stand, Mounting,

26、Antenna M-4445 ( )/AWM-23(V). The adapter shall provide maintenance access to the sides, top, bottom, and rear of the radar ansenna. The antenna handling adapter shall be so designed and constructed Each adapter shall 3.6.1.2 Adapter, Handling, Tactical Information Display MX-9047( )/AWM- 23(V). TID

27、. The TID handling adapter shall provide protective mounting for the Bolts and pins used for attachment shall be captive to the adapter. 3.6.1.3 Bar, Lifting, Antenna MX-9048( )/AWM-23(V). The lifting bar shall engage the antenna hoisting lugs to facilitate removal and installation of the radar ante

28、nna. The lifting bar shall provide for application of a lifting force acting along a vertical line through the center of gravity of the radar antenna. 3.6.1.4 Adapter, Hoisting, Antenna ADU-371( )/E. The antenna hoisting adapter shall provide captive attachment pins or screws for attachment of the a

29、dapter to the radar antenna. with jaw spacing of one-half inch minimum and a captive (to the adapter) clevis pin with a maximum diameter of 3/8 inch for attachment to a hoist ring. over the radar antenna center of gravity. The adapter shall have an open jaw clevis The open jaw clevis shall be locate

30、d to provide a lift point directly 4. QUALITY ASSURANCE PROVISIONS 4.1 Responsibility for inspection. Applicable. 4.2 General. Applicable. 4.2.1 Classification. Applicable. 4.2.2 Individual items. Applicable. 4.2.3 In-process inspection. Applicable, 4.2.4 In-process data. Applicable. 4.2.5 Acceptanc

31、e test plan. Applicable. Table II shall apply. 4.2.6 Test results. Applicable. -6- O Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-TABLE II ACCEPTANCE TEST PLAN FOR HANDLING EQUIPMENT AN/AWM-23 (V) 1.0 TEST OBJECTIVE. To demonstrate that the materi

32、al, workmanship and mechanical interchangeability requirements of 3.1, 3.5, and 3.2.1.4, respectively, have been met. 2 .O TEST CONDITIONS (None applicable) . 3.0 TESTS. Inspect each item listed below for conformance to the applicable assembly or outline and mounting drawing. EQUIPMENT ITEMS Name Pa

33、rt No. 1. Adapter, Handling, Antenna 493602-1XX 2. Adapter, Handling, TID 493614-1XX 3. Adapter, Hoisting, Antenna . 493625-1XX 4. Bar, Lifting, Antenna 493619-1XX -7- Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-S-BL7OC 49 9799906 0256669 7 M

34、IL -S -8 1780C (AS) 4.2.7 Acceptance. Applicable. 4.2.8 Utilities. Not applicable. 4.2.9 Configuration. Applicable. 4.3 Tests. 4.3.1 Electrical and electronic items - operational run-in test. Not applicable. 4.3.2 Mechanical items. Applicable. 4.4 Environmental test conditions. Applicable. 4.5 Test

35、location. Applicable. 4.6 Acceptance schedule. Applicable. 4.7 Test procedures. Applicable. 4.8 Rejection and retest. Applicable. 5. PREPARATION FOR DELIVERY 5.1 General. Applicable. 6. NOTES 6.1 Intended use. The SHE is intended to be used at organizational or intermediate levels to facilitate hand

36、ling of certain WRAs used in Weapon Control System (WCS)AN/AWG-9. 6.2 Ordering data. Applicable. 6.3 Definitions. Applicable. 6.4 Nomenslature cross reference. The following is a cross reference The contractor part number suffix is controlled by the configu- between the official Navy nomenclature and the major contractor part numbers. ration list in the contract. -8- Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-