NAVY A-A-59441-2004 VAPOR CORROSION INHIBITORS《蒸汽腐蚀抑制剂》.pdf

《NAVY A-A-59441-2004 VAPOR CORROSION INHIBITORS《蒸汽腐蚀抑制剂》.pdf》由会员分享，可在线阅读，更多相关《NAVY A-A-59441-2004 VAPOR CORROSION INHIBITORS《蒸汽腐蚀抑制剂》.pdf（5页珍藏版）》请在麦多课文档分享上搜索。

1、METRICA-A-59441 16 January 2004 COMMERCIAL ITEM DESCRIPTION VAPOR CORROSION INHIBITORS The General Services Administration has authorized the use of this commercial item description, for all federal agencies. 1. SCOPE. This commercial item description covers the requirements for vapor corrosion inhi

2、bitors (VCIs) to provide corrosion protection for metal components and electrical and electronic assemblies subjected to corrosive environments. The effectiveness of VCIs is governed by the capability to maintain an active molecular layer on the surface of concern. 2. CLASSIFICATION. The VCI materia

3、ls shall be of the following types: Type I - VCI-diffusing devices with adhesive backing. Type II - VCI-diffusing devices without adhesive backing. Type III - VCI packaged in aerosol containers. Type IV - Bulk VCI materials in suspension or liquid form. Type V - Bulk VCI materials in powdered form.

4、Type VI - VCI packaging products. Type VII - VCI impregnated wipes. 3. SALIENT CHARACTERISTICS 3.1 Specification sheets. Individual item requirements shall be as specified herein and in accordance with the applicable specification sheet. In the event of any conflict between the requirements of this

5、commercial item description and the specification sheet, the former shall govern. 3.2 Materials. The VCIs shall be formulated from non-toxic compounds, which are environmentally safe. The VCI compounds, other components and adhesive materials shall not support combustion. Aerosol propellants shall b

6、e non-flammable and non-toxic. VCI formulations and VCI products shall have passed review by the Naval Environmental Health Center (NEHC). In addition VCI compounds and VCI products shall not contain: a) amines and nitrites or nitrates in combination, b) phosphates, or c) silicones. Beneficial comme

7、nts, recommendations, additions, deletions, clarifications, etc. and any data that may improve this document should be sent to: Commander, Naval Sea Systems Command, ATTN: SEA 05Q, 1333 Isaac Hull Avenue, SE, Stop 5160, Washington Navy Yard DC 20376-5160 or emailed to commandstandardsnavsea.navy.mil

8、, with the subject line “Document Comment”. Since contact information can change, you may want to verify the currency of this address information using the ASSIST Online database at www.dodssp.daps.mil. FSC 2090 Provided by IHSNot for ResaleNo reproduction or networking permitted without license fro

9、m IHS-,-,-A-A-59441 3.2.1 Material selection. Care must be taken to ensure that the VCI materials selected are approved for the intended use. In the case of Type VI materials used for parts to be placed in storage aboard ship, the materials selected must meet current requirements for the generation,

10、 storage and disposal of waste (residue) at sea. 3.3 Operating environment. The VCI vapor diffusing devices shall retain full functionality for corrosion protection in components and equipment that operate in the temperature range 25 to +65 C. The operating environments for each type of VCI are as f

11、ollows: 3.3.1 Type I. Used in sealed mechanical, electrical and electronic enclosures. Type I VCIs may be used in all equipment: shipboard, land-based, mobile, and aviation. They may also be used in sealed packaging during storage and in transit. 3.3.2 Type II. Used in packaging for protection durin

12、g storage and in transit. Type II VCIs may be used in all equipment: shipboard, land-based, mobile, and aviation. They may also be used in sealed mechanical, electrical and electronic enclosures when no hazard is created by their movement within the enclosure. 3.3.3 Type III. Used in spot applicatio

13、ns in sealed enclosures (medium term protection) and exposed locations (short term or temporary protection). Type III VCIs may be used in all equipment: shipboard, land-based, mobile, and aviation. 3.3.4 Type IV. Used in applications to large components for open storage or transit (medium-term prote

14、ction). Type IV VCIs are normally used in industrial facilities (intermediate or depot-level). 3.3.5 Type V. Used in applications involving large sealed enclosures-tanks or voids (medium to long term protection). Type V VCIs may be used in shipboard, land-based, and mobile applications. 3.3.6 Type V

15、I. Used in applications involving packaging of materials that must be protected from corrosion. They include long term storage and storage in environments that promote corrosion. Type VI VCIs may be used in all packaging and storage applications. 3.3.7 Type VII. Used in applications involving the pe

16、rformance of maintenance upon equipment, for which short-term protection is required while it is exposed to the environment. Type VII VCIs may be used in all applications. 3.4 Performance. As used in individual spec sheets, VCI materials shall protect classes of metals as defined by the following ca

17、tegories: MM Multimetal VCI products inhibit corrosion for all metals normally found exposed in electrical and electronic equipment, as well as mechanical/electromechanical equipment and components. F Ferrous VCI products have been optimized to inhibit corrosion for all ferrous metals found exposed

18、in mechanical, electromechanical, electrical and electronic equipment, including carbon steel, stainless steel, galvanized steel and iron. NF Non-ferrous products have been optimized to inhibit corrosion for all non-ferrous metals normally found exposed in electrical and electronic equipment, as wel

19、l as mechanical, electromechanical and metals industries, including copper and its alloys, aluminum and its alloys, and solder. 3.5 Personal safety. The application of VCI materials shall not require the use of personal protective equipment (PPE). Where VCIs are added to other products to improve th

20、eir performance or application, no additional PPE shall be required then would otherwise be required for the non-VCI formulation of the product. 3.6 Protection life. VCI materials shall provide protection for the periods shown in Table I of specification sheet. 4. REGULATORY REQUIREMENTS. The offero

21、r/contractor is encouraged to use recovered materials to the maximum extent practicable, in accordance with paragraph 23.403 of the Federal Acquisition Regulation (FAR). 2 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-59441 5. PRODUCT CONFORMAN

22、CE. The products provided shall meet the salient characteristics of this Commercial Item Description, conform to the producers own drawings, specifications, standards, and quality assurance practices, and be the same product offered for sale in the commercial marketplace. The government reserves the

23、 right to require proof of such conformance. 6. PACKAGING. Preservation, packing, and marking shall be as specified in the contract or order. 6.1 Shelf life. The shelf life of kits shall be not less than 24 months when stored in a sheltered space having a controlled environment. 6.2 Labeling. The ma

24、nufacturers commercial labels for bulk packaging may be used provided that they include the following: a. Volume or surface area protected. b. Application conditions. c. Types of metals for which the product is applicable. d. Instructions for application or installation. e. Precautions to be observe

25、d during installation. An expiration date representing the latest installation date for satisfactory performance shall be placed on each kit; it shall read “Install by: date.” 7. NOTES. 7.1 Intended use. VCI products are coated, impregnated or filled with chemical compounds that actively diffuse inv

26、isible corrosion inhibiting vapors into their surrounding atmosphere. The molecules of these vapors adsorb to metal surfaces inside the enclosed volume to form an active layer of protection against corrosion that causes no change to the character of metal surfaces. The VCI layer later completely eva

27、porates from all metal surfaces when they are exposed to the atmosphere and the VCI diffusion source is removed. 7.2 Part or identification number (PIN). The following part or identification numbering procedure is for government purposes and does not constitute a requirement for the contractor. PIN

28、code: AA59441 /X - X XX CID Number Spec Sheet(see code below) VCI Type (see code below) Material Form (see code in Table I of spec sheet) Spec Sheet VCI Type Sheet Code Type Code 1 1 1 A2 2 2 B 3 3 3 C4 4 4 D 5 5 5 E6 6 6 F 7 7 7 G3Provided by IHSNot for ResaleNo reproduction or networking permitted

29、 without license from IHS-,-,-A-A-59441 Material Form (see also Table I of applicable spec sheet) Form Code Form Code Form Code 1 01 11 11 21 212 02 12 12 22 22 3 03 13 13 23 234 04 14 14 24 24 5 05 15 15 25 256 06 16 16 26 26 7 07 17 17 27 278 08 18 18 28 28 9 09 19 19 29 2910 10 20 20 30 30 The ex

30、ample PIN code for a Type IV VCI, material form 18 is: AA59441/4-D18. 7.3 Source of documents. 7.3.1 The Federal Acquisition Regulation may be obtained from the Superintendent of Documents, U.S. Government Printing Office, Washington, DC 20402 or online at http:/www.arnet.gov/far. 7.3.2 DoD specific

31、ations are available online at http:/astimage.daps.dla.mil/quicksearch/ or www.dodssp.daps.mil or from the Standardization Document Order Desk, 700 Robbins Avenue, Bldg. 4D, Philadelphia, PA 19111-5094. 7.4 National stock numbers (NSNs). See individual specification sheets for NSNs. 7.5 Ordering dat

32、a. The contract or order should specify the following: a. CID document number, revision, and CID PIN. b. Product conformance provisions. c. Quantity required. 7.6 Key words. Adhesive strip Aerosol Corrosion Diffuser Diffusing device Foam Personal protective equipment Vapor corrosion inhibitor VCI 7.

33、7 Definitions. 7.7.1 Enclosure. An enclosure is any cabinet, junction box, termination, or space surrounded by a material layer that provides physical protection to its contents. A “sealed enclosure” is one that completely prevents or restricts the inflow and outflow of air to a small fraction of th

34、e total enclosed volume. 7.7.2 Protection life. The period during which the VCI materials will remain active and prevent corrosion when they are installed or applied according to the manufacturers instructions. 4Provided by IHSNot for ResaleNo reproduction or networking permitted without license fro

35、m IHS-,-,-A-A-59441 57.7.3 Protection volume. For VCI emitters and bulk VCI materials that are applied by weight or volume, the protection volume is the maximum gross volume of the sealed enclosure or closed space for which the individual emitter or recommended application will provide corrosion pro

36、tection for the rated “protection life.” The gross volume is the total volume without a decrement for the included equipment. MILITARY INTERESTS CIVIL AGENCY COORDINATING ACTIVITY: GSA - FSS Custodians: Navy SH Preparing Activity: Air Force 99 Navy SH (Project 2090-0118-000) Review Activity: DLA CC Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-