ITU-R M 489-2-1995 Technical Characteristics of VHF Radiotelephone Equipment Operating in the Maritime Mobile Service in Channels Spaced by 25 kHz《运行于海上移动业务以25KHz为信道间隔的VHF无线电话设备的技术.pdf

《ITU-R M 489-2-1995 Technical Characteristics of VHF Radiotelephone Equipment Operating in the Maritime Mobile Service in Channels Spaced by 25 kHz《运行于海上移动业务以25KHz为信道间隔的VHF无线电话设备的技术.pdf》由会员分享，可在线阅读，更多相关《ITU-R M 489-2-1995 Technical Characteristics of VHF Radiotelephone Equipment Operating in the Maritime Mobile Service in Channels Spaced by 25 kHz《运行于海上移动业务以25KHz为信道间隔的VHF无线电话设备的技术.pdf（2页珍藏版）》请在麦多课文档分享上搜索。

1、150 RECOMMENDATION U-R M.489-2 TECHNICAL CHARACTERISTICS OF VHF RADIOTELEPHONE EQUIPMENT OPERATING IN THE MARITIME MOBILE SERVICE IN CHANNELS SPACED BY 25 kHz (1974-1978-1995) Summary The Recommendation describes the technical characteristics of VHF radiotelephone transmitters and receivers (or tran

2、sceivers) used in the maritime mobile service when operating in 25 kHz channels of Appendix S 18 Appendix 181 of the Radio Regulations (RR). It also contains those additional characteristics of transceivers required to operate digital selective calling. The IT Radiocommunication Assembly, considerin

3、g that Resolution No. 308 of the World Administrative Radio Conference (Geneva, 1979) stipulated that: a) - b) that RR Appendix S18 Appendix 181 gives a table of transmitting frequencies which is based upon the principle of 25 Wz channel separations for the maritime mobile service; c) that in Opinio

4、n 42, the International Electrotechnical Commission (IEC) has been invited to advise the ITU Radiocommunication Sector of any methods of measurement applicable to radio equipment used in land mobile services; and that such methods of measurement may also be suitable for radio equipment used in marit

5、ime mobile services; d) that there is a need to specify the technical characteristics of VHF radiotelephone equipment operating in the maritime mobile service in channels spaced by 25 kHz, all maritime mobile VHF radiotelephone equipment shall conform to 25 kHz standards by 1 January 1983; recommend

6、s that the following characteristics should be met by VHF (metric) FM radiotelephone equipment used for the 1 maritime mobile services operating on the frequencies specified in RR Appendix S 18 Appendix 181. 1.1 General characteristics 1.1.1 1.1.2 1.1.3 used. The class of emission should be F3E/G3E.

7、 The necessary bandwidth should be 16 Wz. Only phase modulation (frequency modulation with a pre-emphasis characteristic of 6 dB/octave) should be * This Recommendation should be brought to the attention of the International Maritime Organization (IMO) and the Telecommunication Standardization Secto

8、r (ITU-T). Note by the Secretariat: The references made to the Radio Regulations (RR) in this Recommendation refer to the RR as revised by the World Radiocommunication Conference 1995. These elements of the RR will come into force on 1 June 1998. Where applicable, the equivalent references in the cu

9、rrent RR are also provided in square brackets. - - 1TU-R RECflN*fl- SERIES*PT*3 75 4855232 0528004 718 Rec. ITU-R M.489-2 151 1.1.4 The frequency deviation corresponding to 100% modulation should approach f5 kHz as nearly as practicable. In no event should the frequency deviation exceed 25 kHz. Devi

10、ation limiting circuits should be employed such that the maximum frequency deviation attainable should be independent of the input audio frequency. 1.1.5 comply with all the requirements of this Recommendation. 1.1.6 within 5 s. 1.1.7 1.1.8 a) b) Where duplex or semiduplex systems are in use, the pe

11、rformance of the radio equipment should continue to The equipment should be designed so that frequency changes between assigned channels can be carried out Emissions should be vertically polarized at the source. Stations using digital selective calling shall have the following capabilities: sensing

12、to determine the presence of a signal on 156.525 MHz (channel 70); and automatic prevention of the transmission of a call, except for distress and safety calls, when the channel is occupied by calls. 1.2 Transmitters 1.2.1 transmitters should not exceed 10 parts in lo6. 1.2.2 impedance of the transm

13、itter, should be in accordance with the provisions of RR Appendix S3 Appendix 81. 1.2.3 The carrier power for coast stations should not normally exceed 50 W. 1.2.4 The carrier power for ship station transmitters should not exceed 25 W. Means should be provided to readily reduce this power to 1 W or

14、less for use at short ranges, except for digital selective calling equipment operating on 156.525 MHz (channel 70) in which case the power reduction facility is optional (see also Recommen- dation ITU-R M.541 recommends 3.7). 1.2.5 1.2.6 required. The frequency tolerance for coast station transmitte

15、rs should not exceed 5 parts in lo4, and that for ship station Spurious emissions on discrete frequencies, when measured in a non-reactive load equal to the nominal output The upper limit of the audio-frequency band should not exceed 3 kHz. The cabinet radiated power should not exceed 25 pW. In some

16、 radio environments, lower values may be 1.3 Receivers 1.3.1 ratio at the output of the receiver. 1.3.2 1.3.3 1.3.4 1.3.5 at any discrete frequency. In some radio environments lower values may be required. 1.3.6 The effective radiated power of any cabinet radiated spurious emission on any frequency

17、up to 70 MHz should not exceed 10 nW. Above 70 MHz, the spurious emissions should not exceed 10 nW by more than 6 dB/octave in frequency up to 1 O00 MHz. In some radio environments, lower values may be required; 2 that reference should also be made to Recommendations ITU-R SM.331 and ITU-R SM.332 an

18、d to the relevant IEC publications on methods of measurement. The reference sensitivity should be equal to or less than 2.0 pV, e.m.f., for a given reference signal-to-noise The adjacent channel selectivity should be at least 70 dB. The spurious response rejection ratio should be at least 70 dB. The radio frequency intermodulation rejection ratio should be at least 65 dB. The power of any conducted spurious emission, measured at the antenna terminals, should not exceed 2.0 nW