FORD WSS-M2C205-A-2009 OIL ENGINE ILSAC GF - 3 SERVICE FILL TO BE USED WITH FORD WSS-M99P1111-A 《使用中注入型ILSAC GF-3发动机油 与标准FORD WSS-M99P1111-A一起使用 》.pdf

《FORD WSS-M2C205-A-2009 OIL ENGINE ILSAC GF - 3 SERVICE FILL TO BE USED WITH FORD WSS-M99P1111-A 《使用中注入型ILSAC GF-3发动机油 与标准FORD WSS-M99P1111-A一起使用 》.pdf》由会员分享，可在线阅读，更多相关《FORD WSS-M2C205-A-2009 OIL ENGINE ILSAC GF - 3 SERVICE FILL TO BE USED WITH FORD WSS-M99P1111-A 《使用中注入型ILSAC GF-3发动机油 与标准FORD WSS-M99P1111-A一起使用 》.pdf（1页珍藏版）》请在麦多课文档分享上搜索。

1、 ENGINEERING MATERIAL SPECIFICATIONDate Action Revisions 2009 11 11 N-STATUS No known use. No replacement named D. DiGregorio, NA 2004 05 21 Revised Para 3.0 inserted; para 3.1, 3.5 & 4 deleted 2001 03 13 Activated M. J. Riley Printed copies are uncontrolled Copyright 2009, Ford Global Technologies,

2、 LLC Page 1 of 1 OIL, ENGINE, ILSAC GF - 3, SERVICE FILL WSS-M2C205-A NOT TO BE USED FOR NEW DESIGN 1. SCOPE This material specification defines the minimum acceptable performance requirements and physical/chemical properties of engine oils to be used in Ford Motor Company vehicles. 2. APPLICATION T

3、his material is used for lubrication of gasoline engines. This specification was released originally for service fill engine oils meeting the 2002 model vehicle requirements for viscosity grades other than SAE 5W-20. Sections of WSS-M99P1111-A titled QUALITY SYSTEM REQUIREMENTS, SUPPLIERS RESPONSIBI

4、LITY, and APPROVAL OF MATERIALS apply only to engine oils supplied directly to Ford Motor Company and its affiliates. 3. REQUIREMENTS Material specification requirements are to be used for initial qualification of materials. 3.0 STANDARD REQUIREMENTS FOR PRODUCTION MATERIALS Material suppliers and p

5、art producers must conform to the Companys Standard Requirements For Production Materials (WSS-M99P1111-A). 3.2 PERFORMANCE Shall meet all the requirements of “The ILSAC GF-3 Minimum Performance Standard For Passenger Car Engine Oils“ and shall be licensed to display the API Certification Mark. 3.3

6、PHYSICAL/CHEMICAL PROPERTIES 3.3.1 Copper Corrosion, max 1b (Dark Orange) (ASTM D 130 or ISO 2160, 3 h at 100 C) 3.3.2 Physical Appearance and Odor Shall be clear and bright with no objectionable odor. 3.3.3 Contaminants Shall be free of carcinogens, toxins, metals from refining or previous use. 3.4

7、 QUALIFICATION It is the suppliers responsibility to have the technical evidence and documentation certifying that a given formulation (base oil/ additive combination) meets all requirements described in this specification. The affected Ford Fuels and Lubricants Engineering activity reserves the right to request certification documentation from any company claiming to meet this specification.