FORD WSS-M2C171-E-2012 OIL ENGINE API CJ-4 SERVICE FILL TO BE USED WITH FORD WSS-M99P1111-A 《耐用填充发动机油API CJ-4 与福特WSS-M99P1111-A 一起使用》.pdf

《FORD WSS-M2C171-E-2012 OIL ENGINE API CJ-4 SERVICE FILL TO BE USED WITH FORD WSS-M99P1111-A 《耐用填充发动机油API CJ-4 与福特WSS-M99P1111-A 一起使用》.pdf》由会员分享，可在线阅读，更多相关《FORD WSS-M2C171-E-2012 OIL ENGINE API CJ-4 SERVICE FILL TO BE USED WITH FORD WSS-M99P1111-A 《耐用填充发动机油API CJ-4 与福特WSS-M99P1111-A 一起使用》.pdf（1页珍藏版）》请在麦多课文档分享上搜索。

1、 ENGINEERING MATERIAL SPECIFICATION Date Action Revisions Rev. 1 2012 04 03 Revised Removed service category SM from title and 3.2. C. E. Richardson, FNA 2007 03 07 Activated M. J. Riley Controlled document at www.MATS Copyright 2012, Ford Global Technologies, LLC Page 1 of 1 OIL, ENGINE, API CJ-4,

2、SERVICE FILL WSS-M2C171-E 1. SCOPE This material specification defines the minimum acceptable performance requirements and physical/chemical properties of engine oils to be used in Ford Motor Company vehicles. 2. APPLICATION This specification was released originally for diesel engine service fill o

3、ils meeting the 2008 model vehicle warranty requirements. This engine oil is used for lubrication of compression ignition engines using diesel fuel. The section titled STANDARD REQUIREMENTS FOR PRODUCTION MATERIALS applies only to engine oils supplied directly to Ford Motor Company and its affiliate

4、s. 3. REQUIREMENTS 3.1 STANDARD REQUIREMENTS FOR PRODUCTION MATERIALS Material suppliers and part producers must conform to the Companys Standard Requirements For Production Materials (WSS-M99P1111-A). 3.2 PERFORMANCE Shall meet all the requirements of and be licensed to display API service categori

5、es CJ-4. 3.3 PHYSICAL/CHEMICAL PROPERTIES 3.3.1 Physical Appearance and Odor Shall be clear and bright with no objectionable odor. 3.3.2 Contaminants Shall be free of carcinogens, toxins, metals not removed in refining or from previous use. 3.4 QUALIFICATION It is the suppliers responsibility to hav

6、e the technical evidence and documentation certifying that a given formulation (base oil/additive combination) meets all requirements described in this specification. The affected Ford Fuels and Lubricants Engineering activity reserves the right to request certification documentation from any company claiming to meet this specification. 4. GENERAL INFORMATION The information given below is provided for clarification and assistance in meeting the requirements of this specification. Contact for questions concerning Engineering Material Specifications.