FORD WSS-M1H1031-A-2007 DRAFT FABRIC DUBUFFET C VERSION 8C WOVEN JACQUARD UNLAMINATED -- TO BE USED WITH FORD WSS-M99P1111-A 《DUBUFFET VERSION 8C图案的不分层提花机织织物 与标准FORD WSS-M99P111.pdf

《FORD WSS-M1H1031-A-2007 DRAFT FABRIC DUBUFFET C VERSION 8C WOVEN JACQUARD UNLAMINATED -- TO BE USED WITH FORD WSS-M99P1111-A 《DUBUFFET VERSION 8C图案的不分层提花机织织物 与标准FORD WSS-M99P111.pdf》由会员分享，可在线阅读，更多相关《FORD WSS-M1H1031-A-2007 DRAFT FABRIC DUBUFFET C VERSION 8C WOVEN JACQUARD UNLAMINATED -- TO BE USED WITH FORD WSS-M99P1111-A 《DUBUFFET VERSION 8C图案的不分层提花机织织物 与标准FORD WSS-M99P111.pdf（2页珍藏版）》请在麦多课文档分享上搜索。

1、 ENGINEERING MATERIAL SPECIFICATIONDate Action Revisions 2007 04 19 Activated M. Montgomery Printed copies are uncontrolled Copyright 2007, Ford Global Technologies, LLC Page 1 of 2 DRAFT, FABRIC, DUBUFFET VERSION 8C, WOVEN JACQUARD WSS-M1H1031-A UNLAMINATED 1. SCOPE The material defined by this spe

2、cification is a woven jacquard polyester face fabric. 2. APPLICATION This specification was released originally for material used as an interior trim fabric for the C 214 MCA. 3. REQUIREMENTS In addition to the requirements listed herein, the fabric shall meet all requirements of WSS-M8P18-A1/A2/A3/

3、A4 as applicable. 3.1 STANDARD REQUIREMENTS FOR PRODUCTION MATERIALS Material suppliers and part producers must conform to the Companys Standard Requirements For Production Materials (WSS-M99P1111-A). 3.2 FABRIC CONSTRUCTION 3.2.1 Fabric Count, +/- 10% tolerance (ASTM D 3775) Warp 280 ends/10 cm Wef

4、t 170 picks/10 cm 3.2.2 Fabric Weight, range. (FLTM BN 106-01) 250 +/- 25 g/m23.3 COMPOSITION (ASTM D 629) Fabric 100% polyester 3.4 YARN CONSTRUCTION (ASTM D 1244) Warp 540 dtex f128 (Polyester, air texturized, round, semi-dull) Weft 540 dtex f130 (Polyester, Bright, trilobal, air texturized) ENGIN

5、EERING MATERIAL SPECIFICATIONWSS-M1H1031-A Printed copies are uncontrolled Copyright 2007, Ford Global Technologies, LLC Page 2 of 2 3.5 METHOD OF DYEING Yarn dyed or as approved by Materials Engineering 3.6 FINISHING OPERATIONS As approved by Materials Engineering 4. GENERAL INFORMATION The information given below is provided for clarification and assistance in meeting the requirements of this specification. 4.1 Purchase departments will ensure that both materials defined in this specification and shipped to any one assembly plant will be produced by one supplier only.