FORD FLTM EU BN 027-01-2001 ADHESIVE WEIGHT TEST FOR VINYL ROOFS《乙烯基车顶的附着重量试验》.pdf

《FORD FLTM EU BN 027-01-2001 ADHESIVE WEIGHT TEST FOR VINYL ROOFS《乙烯基车顶的附着重量试验》.pdf》由会员分享，可在线阅读，更多相关《FORD FLTM EU BN 027-01-2001 ADHESIVE WEIGHT TEST FOR VINYL ROOFS《乙烯基车顶的附着重量试验》.pdf（2页珍藏版）》请在麦多课文档分享上搜索。

1、FORD LABORATORY TEST METHOD EU BN 027-01 2001 0823 ADHESIVE WEIGHT TEST FOR VINYL ROOFS Revised Editorial - no technical change A. Cockman Application This method is used to determine the weight in g/m2 of adhesive sprayed on vinyl roofs. Apparatus Required La bo ratory Balance Accuracy +/- 0.1 mg A

2、luminum Foil Household type Double Backed Adhesive Tape Laboratory Convection Oven Capable of maintaining a temperature of 80 +/- 2 OC. Conditioning and Test Conditions All test values indicated herein are based on material conditioned in a controlled atmosphere of 23 +/- 2 OC and 50 +/- 5 % relativ

3、e tumidity for not less than 24 h prior to testing and tested under the same conditions unless otherwise specified. Procedure 1. Cut three 1 O0 x 1 O0 mm sections from a roll of foil (area = 1 O0 cm). 2. Weigh the foil sections (W,) 3. Place foil adjacent to or directly on the substrate to be spraye

4、d (according to the material specification or as otherwise specified) in a random arrangement to obtain values representative of the entire surface being sprayed. Note: Foil may be secured to test surface with double backed adhesive tape. I Date I Action I Revisions I Copynght02001, Ford Global Tech

5、nologies, Inc FORD LABORATORY TEST METHOD EU BN 027-01 4. Following application of adhesive, remove foil and place them in a convection oven at 80 OC for four hours. Note: Remove the tape from the foil. 5. After removal from oven, weigh foil and calculate weight in g/m2. (W2). Report the average of

6、three weights. 6. Calculate as follows: (W2- W,) x 100 = w, Where: W2 = Weight of foil and adhesive (g/lOO cm). W1 = Weight of foil (g/lOO cm). W,= Weight of adhesive in g/m2 Chemicals, materials, parts, and equipment referenced in this document must be used and handled properly. Each party is responsible for determining proper use and handling in its facilities. Page 2 of 2 Copyright 02001, Ford Global Technologies, Inc