FORD FLTM BV 106-01-2000 LEAK TEST FOR ENGINE AND CHASSIS SEALERS (Replaces FLTM BV 006-01)《发动机和底盘密封剂渗漏试验 替代FLTM BV 006-01［替代 FORD FLTM BV 006-01］》.pdf

《FORD FLTM BV 106-01-2000 LEAK TEST FOR ENGINE AND CHASSIS SEALERS (Replaces FLTM BV 006-01)《发动机和底盘密封剂渗漏试验 替代FLTM BV 006-01［替代 FORD FLTM BV 006-01］》.pdf》由会员分享，可在线阅读，更多相关《FORD FLTM BV 106-01-2000 LEAK TEST FOR ENGINE AND CHASSIS SEALERS (Replaces FLTM BV 006-01)《发动机和底盘密封剂渗漏试验 替代FLTM BV 006-01［替代 FORD FLTM BV 006-01］》.pdf（3页珍藏版）》请在麦多课文档分享上搜索。

1、 FORD LABORATORY TEST METHOD BV 106-01 Date Action Revisions 2000 12 08 Revised Editorial no technical change A. Cockman 1990 09 25 Printed copies are uncontrolled Page 1 of 3 Copyright 2000, Ford Global Technologies, Inc. LEAK TEST FOR ENGINE AND CHASSIS SEALERS Application This procedure is used t

2、o test the sealing properties of engine and chassis sealers in the presence of lubricating oil and coolant solution. Apparatus Required Test Fixture Refer to Figure 1. Oven Mechanical convection; must be capable of maintaining 100 - 150 C. Materials Required Engine Oil Use currently approved “factor

3、y fill“ oil. Ethylene Glycol Coolant Use currently-approved “factory fill“ coolant (ethylene glycol coolant diluted 50:50 with tap water). Transmission Fluid Use currently approved “factory fill“ fluid. Conditioning and Test Conditions All test values indicated herein are based on material condition

4、ed in a controlled atmosphere of 23 +/- 2 C and 50 +/- 5 % relative humidity for not less than 24 h prior to testing and tested under the same conditions unless otherwise specified. Procedure 1. Apply sealer to all threads of test fixture. Tighten plugs to appropriate torque (refer to Figure 1) and

5、install one end cap. FORD LABORATORY TEST METHOD BV 106-01 Page 2 of 3 Copyright 2000, Ford Global Technologies, Inc. 2. Fill the assembly with engine oil, transmission fluid or ethylene glycol solution as specified and install remaining end cap. 3. Place the assembly into an oven at 102 +/- 2 C for

6、 72 h unless otherwise specified. Orient the assembly with the plugs pointing downward (above a trough or other means of collecting any fluid that may leak). 4. Report any evidence of leakage during this period. Chemicals, materials, parts, and equipment referenced in this document must be used and handled properly. Each party is responsible for determining proper use and handling in its facilities. FORD LABORATORY TEST METHOD BV 106-01 Page 3 of 3 Copyright 2000, Ford Global Technologies, Inc. LEAK TEST FOR ENGINE AND CHASSIS SEALERS Figure 1